قراءة مجانية · حساب مجاني للمساهمةخليفة Anticars (2000)

BuickBuick Roadmaster

1991–1996 · 1 الأجيال · 11 أعطال موثّقة · 1 أسواق
الأجيال
كل الأجيالVIII1991–199611209
سنة الطراز
السوقالكلNA
استدعاءحرجالتعليقNA

Suspension

The wheel lug nuts on these vehicles may not have been tightened to specification during assembly. This may result in fracture of the wheel studs, which could cause the wheel to separate from the vehicle. If this were to occur while the vehicle was in motion, a crash could occur without prior warning. Correction: Wheel lug nuts will be tightened to specification.

وزارة النقل الكندية13 ديسمبر 19961996205سنوات الطراز 1996معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالتعليقNA

Wheels:Lugs/nuts/bolts/studs

The wheel lug nuts were not tightened to the proper specification during assembly.

NHTSA · الولايات المتحدة10 ديسمبر 199696V245000سنوات الطراز 1995–1996معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالمحركNA

Fuel System

The fuel tank attachment strap fasteners are below the specified torque. These loose fasteners could, in time, become completely detached. This could allow the fuel tank to sag down to the point of striking something in the road or the road surface resulting in a possible fuel leak and an under-vehicle fire. Correction: Fuel tank strap fasteners will be torqued to the proper specifications.

وزارة النقل الكندية3 نوفمبر 19941994170سنوات الطراز 1994معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالمحركNA

Fuel system, gasoline:Storage:Tank assembly:Mounting

The fuel tank attachment strap fasteners were not properly tightened. The fasteners can completely detach, eventually allowing the fuel tank to sag and the bottom of the tank to strike the roadway.

NHTSA · الولايات المتحدة25 أكتوبر 199494V210000سنوات الطراز 1994معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالتعليقNA

Wheels:Lugs/nuts/bolts/studs

Paint on the wheel mounting surfaces can act as a shim between the wheel and the rotor/drum. As the vehicle is driven, the wheel imbeds into the paint, loosening the lug nut and causing a loss of clamp load.

NHTSA · الولايات المتحدة16 أبريل 199494V076000سنوات الطراز 1994معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالمحركNA

Engine

On certain vehicles, the engine oil cooler inlet hose may contact the steering gear and wear through. This could allow engine oil to leak onto hot engine components and cause an engine compartment fire. Correction: Oil cooler hose will be repositioned and inspected. If wear is evident, the hose will be replaced.

وزارة النقل الكندية25 مارس 19941994064سنوات الطراز 1994معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالمحركNA

Engine and engine cooling:Cooling system:Hoses/lines/piping/fittings

The engine oil cooler inlet hose may have been installed too close to the steering gear causing chafing. The chafing can eventually wear through the hose's protective sleeve resulting in engine oil leaking onto the engine.

NHTSA · الولايات المتحدة21 مارس 199494V049000سنوات الطراز 1994معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالفراملNA

Brakes

The abs modulator may corrode and leak fluid from the front brake circuit. Brake fluid leakage could reduce brake effectiveness and increase stopping distances. This could result in a crash without prior warning. Correction: Dealers will remove existing corrosion from the abs modulator and install a kit to prevent future corrosion.

وزارة النقل الكندية11 ديسمبر 19971997219سنوات الطراز 1992معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالتعليقNA

Suspension

Note: Includes caprice police sedans, taxi cabs and special service wagons; fleetwood hearse and limousine. The lower control arm ball joint attachment may be loose. This condition can cause the lower control arm ball joint to loosen, fatigue and separate from the front suspension knuckle. If separation were to occur with the vehicle in motion, loss of vehicle control could occur, which could result in a vehicle crash. Correction: Front lower control arm ball joint attachment nuts will be inspected for proper torque. If the ball joint has loosened from the knuckle, both the ball joint and knuckle will be replaced.

وزارة النقل الكندية12 فبراير 19961996025سنوات الطراز 1995–1996معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالتعليقNA

Suspension:Front:Control arm:Lower ball joint

Defective lower control arm ball joint attachment nuts were not properly torqued and can loosen.

NHTSA · الولايات المتحدة30 يناير 199696V019000سنوات الطراز 1994–1995معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالهيكلNA

Structure

These vehicles do not comply with c.M.V.S.S. 102 - transmission shift control sequence. A misadjusted transmission shift control linkage may allow the transmission to be shifted out of the "p"(park) position with the ignition key removed. In the event of this condition occurring, the vehicle may roll from its parked position and cause potential damage and/or injury. Correction: Shift control linkage system will be adjusted.

وزارة النقل الكندية29 نوفمبر 19951995211سنوات الطراز 1995معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطناقل الحركةNA

Power train:Automatic transmission

These vehicles were produced with an improperly adjusted transmission shift control linkage. This does not meet with the requirements of fmvss no. 114, "theft protection."

NHTSA · الولايات المتحدة16 نوفمبر 199595V221000سنوات الطراز 1995معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمحركNA

Engine

Certain vehicles do not comply with CMVSS 124 - Accelerator Control Systems. At low temperatures there may be excessive movement friction in the accelerator pedal assembly. In the event of a failure of a throttle return spring the engine speed may not decrease to the level anticipated by the driver when the foot is lifted from the accelerator pedal. Loss of accelerator control could result in a vehicle crash without prior warning. Correction: Accelerator pedal assembly will be replaced.

وزارة النقل الكندية24 أبريل 19951995074سنوات الطراز 1994–1995معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمحركNA

Vehicle speed control:Springs

These vehicles fail to conform to fmvss no. 124, "accelerator control systems." at low temperatures, excessive friction can occur in the accelerator pedal assembly.

NHTSA · الولايات المتحدة24 أبريل 199595V082000سنوات الطراز 1994–1995معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمقصورةNA

أحزمة الأمان

الغطاء البلاستيكي لحلقة توجيه حزام الكتف قد يتشقق ويكشف اللوحة الفرعية الفولاذية.

NHTSA · الولايات المتحدة1 يوليو 199292V094000سنوات الطراز 1991–1992ترجمة آلية · اللغة الأصلية: الإنجليزيةعرض التفاصيل →
استدعاءمتوسطالمقصورةNA

Seats And Restraints

Note: 1991 caprice sedans and wagons and roadmaster wagons and 1992 roadmaster sedans. The shoulder belt guide loop plastic covering may crack and expose the steel sub-plate. In the event of a severe vehicle crash, the exposed steel sub-plate may cut the safety belt webbing and result in an increased possibility and/or severity of injury to the affected seat occupant. Correction: New shoulder belt guide loops will be installed on involved vehicles.

وزارة النقل الكندية29 يونيو 19921992076سنوات الطراز 1991–1992معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالهيكلNA

Structure

The secondary hood latches on these vehicles can corrode causing a very high latch release effort and possibly preventing the hood from latching properly when it is closed. If the secondary hood latch is not properly engaged the hood could open unexpectedly. If this were to occur while the vehicle was in motion, the driver's forward vision would be impaired possibly resulting in a vehicle crash. Correction: A new scondary hood latch assembly with improved corrosion resistance will be installed on affected vehicles.

وزارة النقل الكندية31 أكتوبر 19911991147سنوات الطراز 1991–1992معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالهيكلNA

Latches/locks/linkages:Hood:Latch

Secondary hood latch assemblies can corrode, causing a high latch release effort and possibly preventing the hood from latching properly when it is closed.

NHTSA · الولايات المتحدة29 أكتوبر 199191V186000سنوات الطراز 1991–1992معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءطفيفالمقصورةNA

Air bags

These vehicles were shipped with both the supplemental inflatable restraint caution label and a roof rack caution label installed on the same side of the sun visor. This does not meet the requirements of fmvss no.208, "occupant crash protection."

NHTSA · الولايات المتحدة3 نوفمبر 199595V215000سنوات الطراز 1995–1996معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →

المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0).