قراءة مجانية · حساب مجاني للمساهمةخليفة Anticars (2000)

Ford Contour

1994–2000 · 1 الأجيال · 13 أعطال موثّقة · 2 أسواق
الأجيال
كل الأجيالContour1994–20001335222
سنة الطراز
السوقالكلNA
استدعاءحرجالمقصورةNA

Seats And Restraints

The passenger side supplemental restraint system (air bag) may have a cracked inflator body. If the vehicle is involved in a deployment level crash, the passenger side air bag may not inflate properly which could result in reduced occupant protection. In addition, the igniter plug could separate from the inflator, which could result in the release of hot gases and could ignite flammable material or potentially cause personal injury. Correction: Vehicles will be inspected and a new passenger side air bag module will be installed if necessary.

وزارة النقل الكندية21 فبراير 19951995032سنوات الطراز 1995معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمقصورةNA

أحزمة الأمان

مركبات الركاب التي تم تجهيزها بتجميعات مشتربات أحزمة المقعد من شركة TRW, والشاحنات الخÙÙŠÙØ©ØŒ ومركبات Ø§Ù„Ø¯ÙØ¹ الرباعي الرياضية، والحاÙلات الصغيرة. لم يتم المعالجة الحرارية المناسبة لقاعدة مشترب أحزمة المقعد هذه، ولذلك ÙØ¥Ù†Ù‡Ø§ لا تجتاز متطلبات تحمل الأحمال الواردة ÙÙŠ المعيار الÙيدرالي لسلامة المركبات رقم 209, "تجميعات أحزمة المقعد".

NHTSA · الولايات المتحدة18 أغسطس 200000V228001سنوات الطراز 2000ترجمة آلية · اللغة الأصلية: الإنجليزيةعرض التفاصيل →
استدعاءمتوسطالمقصورةNA

Air bags:Frontal:Sensor/control module-inactive

Vehicle description: Passenger vehicles. The air bag sensor wiring pigtail insulation can become brittle and crack over time due to accumulation of water in the pigtail protective convolute in combination with high underhood temperatures related to the routing of the wiring pigtail near the radiator. This can result in environmental stress cracking of the insulation.

NHTSA · الولايات المتحدة8 سبتمبر 199999V243000سنوات الطراز 1998معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمقصورةNA

Seats And Restraints

These vehicles may not comply with the requirements of c.M.V.S.S 210 - seat belt assembly anchorages. The hardware that attaches the outboard ends of the front safety belts to the front seat frames may be cracked or fractured. If so. The load that the safety belt could sustain would be below that specified by the standard. Correction: Reinforcement plates will be installed to the attachment hardware of both outboard front safety belts. If the attachment hardware is fractured, a new safety belt will be installed.

وزارة النقل الكندية9 يناير 19961996003سنوات الطراز 1995معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالمقصورةNA

Seat belts:Front:Anchorage

Cracks have been found in the front safety belt outboard anchor tabs due to a combination of hydrogen embrittlement of the tab and stress introduced during attachment of the anchor tab to the seat frame. This does not conform with the requirements of fmvss no. 210, "seat belt assembly anchorages."

NHTSA · الولايات المتحدة4 ديسمبر 199595V228000سنوات الطراز 1995معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →

المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).