النظام الكهربائي:الإشعال
تقد يتعرض مفتاح الإشعال لدائرة قصر داخلية.
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Ford EXP (كل الأجيال)
تقد يتعرض مفتاح الإشعال لدائرة قصر داخلية.
قد يحدث ماس كهربائي في مفتاح الإشعال يؤدي إلى ارتفاع درجة الحرارة وتصاعد الدخان، وربما نشوب حريق في عمود التوجيه بالمركبة. وقد تحدث هذه الحالة أثناء استخدام المركبة أو عندما تكون متوقفة دون مراقبة. التصحيح: سيتم استبدال مفتاح الإشعال بمفتاح ذي تصميم مُعدَّل.
في طرازات 1984، قد تظهر شقوق خارجية في رؤوس أسطوانات المحرك، مما قد يؤدي إلى تسرب الزيت على مشعب العادم. وفي طرازات 1985، قد تتمزق واقية غطاء صمامات المحرك (جوان غطاء الصمامات)، مما قد يسمح بتسرب الزيت على مشعب العادم. وكلتا الحالتين تخلقان احتمال اشتعال الزيت وتسبب حريقًا تحت غطاء المحرك. التصحيح: في طرازات 1984، سيتم فحص رؤوس الأسطوانات واستبدالها في حال وجود شقوق خارجية فيها. وفي طرازات 1985، سيتم فحص جوانات غطاء الصمامات واستبدالها ما لم تكن من تصميم أحدث.
لاحظ أن الشقوق الخارجية فوق الأسطوانة رقم 3 (موديلات 1984) أو تمزق حشيات غطاء ذراع الصمام (موديلات 1985) قد تسمح بتسرب الزيت إلى مشعب العادم.
للمركبات قد يكون هناك خلوص غير كافٍ بين أنابيب الفرامل الأمامية اليمنى وحامل مثبت على المحرك. وفي ظروف معينة، قد يلامس الحامل أنبوب الفرامل المعدني ويؤدي إلى احتكاك الأنبوب، مما قد يتسبب في تسرب سائل الفرامل وفقدان جزئي للفرامل. وسيؤدي ذلك إلى زيادة مسافات التوقف.
The front sleeve bushings of the cooling fan motors are susceptible to excessive corrosion in areas of high road salt use. This may increase the rotational friction of the fan motor or result in seizure of the armature shaft to the bushing. Either condition may draw current in excess of that of a normally operating motor but less than required to operate the fuse link. This could overheat the motor wiring circuitry and possibly result in an underhood or instrument panel fire. Vehicles affected: Cars not equipped with factory air conditioning. Quebec and atlantic provinces only.
هذه المركبات قد لا تتوافق مع المعيار C.M.V.S.S. 1103 - انبعاثات العادم. قد يعمل حاقن الوقود المركزي (CFI) بخليط غني خلال ظروف تشغيل معينة. التصحيح: سيتم تركيب حاقنات وقود CFI محسّنة وستُعدَّل سرعة الخمول.
These vehicles do not comply with cmvss 1103 - exhaust emissions. Vehicles affected: 1.6 l engine and atx transmissions
The bolts that attach the d-shaped ring for the shoulder belt are inadequately supported by the material in which they are mounted. The attachment does not comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages".
The upper torso restraint d-ring which attaches the shoulder belt to the b pillar, under certain test conditions, separated from its anchorage, and may not comply with cmvss 210 - belt anchorage.
These vehicles may not comply with cmvss 1103 - exhaust emissions.
Two door models. Fatigue cracks may occur in the door lock pillars at the front door latch striker reinforcement attachment locations. The fatigue cracks may propogate to the extent that the structural integrity of the door latch striker attachment may be significantly reduced creating the possibility that the door may not be securely retained. This condition is observable by visibly noticeable cracks on the door lock pillar adjacent to the striker assemblies.
Door lock pillars could develop fatigue cracks from normal usage of door, at the point where door latch striker reinforcements are attached.
On the involved vehicles, a thermal limiter in the blower motor resistor circuit of the air conditioner/heater assembly may not function as intended. If the blower motor becomes jammed when the system is operating in the medium-low blower speed, the resistor coils can overheat causing melting and possible ignition.
Vehicles with optional air conditioning. The air conditioner blower motor thermal limiter may not operate as intended when there is a motor blockage or malfunction. Thus, if the blower motor becomes jammed when the system is operating in the medium-low blower speed mode, the resistor coils may overheat causing melting and possible ignition of the polyproplene evaporator housing with associated vehicle damage.
Vehicles equipped with power brakes. Power brake boosters may have bewen improperly assembled by supplier. Mis-indexing of rear shell of some boosters relative to the front shell may have resulted in inadequate crimping of the two shells. If booster were to separate during vehicle operation, complete loss of service brakes would result.
Some vehicles equipped with power brake boosters have front and rear shells that may have been improperly joined. Improperly joined booster shells may separate either partially or completely during brake application.
Vehicle may not meet the fuel spillage requirements of cmvss 301 - fuel system integrity.
Certain vehicles may not meet applicable minimum fuel spillage requirements of federal motor vehicle safety standard no. 301, "fuel system integrity". During a 30 mph rear impact test, fuel spillage limits were exceeded by vehicle.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).