その他(その他)
音響機器のオーディオ本体の配線基盤において、当該基盤の製造工程が不適切なため、コ ンデンサが損傷しているものがあり、そのままの状態で使用を続けると、当該コンデンサ の端子間が短絡して、スピーカに過大な電流が流れ、最悪の場合、火災にいたるおそれが ある。
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Ford Probe (كل الأجيال)
音響機器のオーディオ本体の配線基盤において、当該基盤の製造工程が不適切なため、コ ンデンサが損傷しているものがあり、そのままの状態で使用を続けると、当該コンデンサ の端子間が短絡して、スピーカに過大な電流が流れ、最悪の場合、火災にいたるおそれが ある。
The passenger side supplemental restraint system (air bag) may have a cracked inflator body. If the vehicle is involved in a deployment level crash, the passenger side air bag may not inflate properly which could result in reduced occupant protection. In addition, the igniter plug could separate from the inflator, which could result in the release of hot gases and could ignite flammable material or potentially cause personal injury. Correction: Vehicles will be inspected and a new passenger side air bag module will be installed if necessary.
Brackets mounting automatic shoulder belt retractor assembly may have an understrength spot weld.
燃料注入口のアウターパイプに嵌合しているインナーパイプの溶接位置に不適切なものが あるため、インナーパイプが燃料フィラーキャプのシールと干渉するものがあり、そのま まの状態で使用を続けると、フィラーキャップとアウターパイプの気密性が損なわれ、最 悪の場合、当該部位から燃料蒸発ガスが大気に排出するおそれがある。
Certain vehicles may not comply with the requirements of CMVSS 1105 - Evaporative Emissions. Fuel vapour may leak from between the fuel cap and the fuel filler pipe. Correction: Filler cap will be replaced with one that incorporates an o-ring that will positively seal the suspect fuel filler pipes.
On certain vehicles, an external spring in the timing belt auto tensioner may break. The broken spring may get caught in the timing belt, resulting in possible engine stalling. Correction: Vehicles will be inspected and affected tensioners will be replaced.
Vehicle description: Passenger vehicles. An external spring in the timing belt tensioner can break and get caught in the timing belt.
The rail of the motorized seat belt track assembly may wear sufficiently under certain conditions to cause the cable which pushes and pulls the moveable buckle assembly to jam in the track, causing the seat belt track assembly to be inoperative. Correction: Driver side motorized shoulder belt tracks will be replaced with increased durability tracks. Passenger side belt tracks will be inspected and/or replaced as necessary.
Note: Driver's side (left) passive seat belt assembly. The rail of the automatic shoulder belt can wear sufficiently such that the cable which retracts the buckle assembly will become jammed in the rail rendering the shoulder belt inoperative.
Note: Passenger side (right) seat belt assembly. The rail of the automatic shoulder belt can wear sufficiently such that the cable which retracts the buckle assembly will become jammed in the rail rendering the shoulder belt inoperative.
The fuel pump wiring assembly may corrode due to road salt, possibly resulting in an electrical bridge developing between the fuel pump electrical circuit and the fuel gauge sender terminals. This could cause the fuel sender ground circuit to overheat the wiring and melt its insulation causing smoke and possible damage to other wiring. Correction: A fused jumper harness will be installed in the fuel pump/sender electrical circuit.
تشير اختبارات الامتثال إلى أن هذه المركبات قد تطلق انبعاثات أول أكسيد الكربون (CO) تتجاوز متطلبات انبعاثات العادم بموجب قانون C.M.V.S.S. 1103. تصحيح: سيتم استبدال المحول التحفيزي في المركبات المتأثرة.
ملاحظة: تم استبداله ب 95038. قد لا تلتزم هذه المركبات بانبعاثات العادم C.M.V.S.S 1103. قد تطلق المحفزات انبعاثات تتجاوز المعيار. تصحيح: سيتم استبدال محفزات نظام العادم في المركبات المتأثرة.
These vehicles do not comply with c.M.V.S.S. 210.1 tether anchorages for child restraints. The english tether bolt and metric anchor nut combination is not compatible with the standard. Also, information concerning the installation of the bolt contained in the owner guide is incorrect. Correction: New child restraint anchor bolt kits will be mailed to owners along with two revised stick-on owner guide pages. Also, dealers will replace incorrect panel weld nut if required.
If the passenger-side air bag deploys in an accident and there is no passenger in that seating position, the air bag can detach from, and deform, the mounting bracket.
The lower pivot pin that joins the liftgate gas strut to the body may separate from the lower strut mounting bracket due to an undersized rivet head. If the pin separates, the liftgate could fall and possibly cause injury to persons under the falling liftgate. Correction: Vehicles will be inspected and, if one or both of the rivet heads are undersized, that liftgate will be replaced.
Vehicle description: Passenger vehicles. The lower pivot pin that joins the liftgate gas strut to the body can separate from the lower strut mounting bracket due to an undersized rivet head.
Note: Vehicles with 3.0 litre engine. These vehicles may not comply with c.M.V.S.S. 1103 - exhaust emissions. Throttle position sensor may wear prematurely causing interruption of the sensor signal. Correction: Throttle position sensor will be inspected and replaced if necessary.
Vehicles with 3.0l engines and automatic transmissions only. These vehicles do not comply with c.M.V.S.S 1103 - exhaust emissions. Carbon monoxide levels exceed standard. Correction: Dealers will replace the electronic engine control (eec) processor and attach two decals.
The brackets to which the automatic shoulder belt retractor assembly is mounted under the centre console may have understrength spot welds that might reduce the effectiveness of the shoulder belt in the event of a vehicle collision. Correction: Dealers will install two bolts to secure the brackets on affected vehicles.
These vehicles do not comply with c.M.V.S.S. 108 - lighting. Daytime running lights shut off whenever signal lights are activated. Correction: A revised design drl module will be installed on affected vehicles.
Vehicles with 3 litre engines may have throttle levers that were bent during vehicle assembly. If this condition exists, there is a potential that the throttle may stick and not return fully to the idle position. This could cause possible loss of vehicle control. Correction: Vehicles will be inspected and if necessary, the intake manifold assembly will be replaced.
Throttle levers may have been bent during assembly.
車体の中央下部にある副消音器後部の排気管接合部に溶接不良のものがあるため、そのま まの状態で使用を続けると、当該溶接部位に亀裂が発生し、そこから排気ガスが漏れると ともに、騒音が増大するおそれがある。
The supplementary air bag inflatable restraint caution label located on the driver side sun visor does not contain the statement, "do not install rearward facing child seats in any front passenger seat position." this does not comply with the requirements of fmvss no. 208, "occupant crash protection."
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).