يفشل هذا الخبر في الامتثال لمتطلبات اختبار الاصطدام الجانبي بحاجز متحرك وفق المعيار FMVSS 301 "سلامة نظام الوقود"، إذ تجاوز تسرب الوقود من خزان البنزين الحد الأقصى المسموح به للانسكاب.
NHTSA · الولايات المتحدة23 نوفمبر 199393V192000سنوات الطراز 1990–1994ترجمة آلية · اللغة الأصلية: الإنجليزيةعرض التفاصيل →
Note: All 1988-89 excel vehicles sold in canada. The reed valve subassembly contained within the air control valve could fail due to corrosion allowing the hot exhaust gases to flow backward into the plastic secondary air filter case when the vehicle is being driven. These hot gases may melt the secondary air filter case and could result in an engine compartment fire. Correction: Reed valve subassembly will be replaced.
وزارة النقل الكندية30 ديسمبر 19911991176سنوات الطراز 1988–1989معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
The fuel return tube clip may have been incorrectly installed allowing the fuel return hose to contact either the distributor high tension cable or the e.G.R. Valve. This could, over time, result in wear and eventual leakage at the fuel hose. The fuel leakage could result in an underhood fire. V.I.N. Range s.O.P. To kmhla31j1gu040086
وزارة النقل الكندية18 أبريل 19861986044سنوات الطراز 1986معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
في بعض المركبات، لا تتوافق الطبقة الواقية الداخلية التي يضعها الشركة المصنعة على مستشعر زاوية عمود المرفق الإلكتروني مع المواصفات، مما قد يتسبب في حدوث دائرة مفتوحة عند درجات حرارة التشغيل العالية. وقد يؤدي ذلك إلى توقف المركبة عن العمل.
NHTSA · الولايات المتحدة11 مايو 199494V090000سنوات الطراز 1994ترجمة آلية · اللغة الأصلية: الإنجليزيةعرض التفاصيل →
Deterioration of the reed valve subassembly may lead to a malfunction within the secondary air supply portion of the emission control system. The screws which attach the reeds to the reed valve subassembly may rust, and if the rusting becomes severe, the screw heads will erode and allow the reeds to separate from the reed valve subassembly. Corrosion may also occur on the reed valve subassembly, deforming the reed seats and preventing the reeds from closing properly. Separation of the reeds from the reed valve subassembly or improper closing of the reeds allow hot exhaust gases to flow backward into the plastic secondary air filter case when the vehicle is being driven. These hot exhaust gases may melt the secondary plastic air filter case.
NHTSA · الولايات المتحدة31 ديسمبر 199191V225000سنوات الطراز 1986–1989معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
The lock washer located under the nut that secures the front hub to the driveshaft may crack due to improper heat treatment. This could result in wheel bearing freeplay and bearing damage with possible wheel lock-up or brake caliper knockback. Correction: Washer will be replaced note: All units have been corrected.
وزارة النقل الكندية18 مايو 19901990072سنوات الطراز 1990معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
The possibility exists that under certain braking conditions, front brake fade may occur,thus reducing braking effectiveness. Correction: Improved semi-metallic brake pads will be installed.
وزارة النقل الكندية27 نوفمبر 19871987127سنوات الطراز 1986–1987معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
The cotter pin that retains the brake clevis pin may have been omitted or incorrectly installed. If the cotter pin was omitted or if it were to fall out of the clevis pin,the vehicles' brakes would be subject to failure without warning.
وزارة النقل الكندية29 مارس 19861986033سنوات الطراز 1986معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
A cotter pin in the brake pedal to brake master cylinder linkage assembly may be missing. This pin acts as a retainer for the brake master cylinder pushrod clevis pin. Consequence of defect: The clevis pin may slide out causing the master cylinder/brake pedal linkage to become disengaged. If this linkage becomes disengaged the service brakes cannot be applied, creating the risk of a crash without prior warning.
NHTSA · الولايات المتحدة17 مارس 198686V043000سنوات الطراز 1986معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
If cruise control main switch is in the on position when engine is started, system can be affected by a short duration voltage drop caused by optional hi-power (h340) radio.
NHTSA · الولايات المتحدة19 يونيو 198989V100000سنوات الطراز 1986–1989معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).