قراءة مجانية · حساب مجاني للمساهمةخليفة Anticars (2000)

Infiniti EX I

2007–2013 · 4 أعطال موثّقة · 4 أسواق

يجمع هذا الملف الأعطال المعروفة لـInfiniti EX I، التي كتبها المجتمع ووثّقها بالمصادر. القراءة مجانية، والحساب المجاني يتيح المساهمة. يحصل العطل على الختم عندما يعتمده عدد كافٍ من المساهمين الموثوقين.

يشتكي المالكون كثيرًا من مشكلات في airbags في هذه السيارة (21 شكوى)، لكن لم يشرح أحد السبب بعد. هل تعرفه؟اكتب الإدخال
يشتكي المالكون كثيرًا من مشكلات في steering في هذه السيارة (16 شكوى)، لكن لم يشرح أحد السبب بعد. هل تعرفه؟اكتب الإدخال

أخطر الأعطال

عرض الكل (4) →
m
حرجالمقصورةNA

Airbags: problems reported by owners

21 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2008–2012), typically at around 82,000 miles. Reported consequences: 3 crashes, 3 injuries.

✓ تحليل Mecafile لبيانات رسمية2008–2012معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
m
حرجالتعليقNA

Steering column separation (US safety investigation)

NHTSA, the US road safety agency, opened a preliminary evaluation (PE14034) into this problem on 4 November 2014 for 2008 models; it was closed on 27 February 2015 without a recall.

✓ تحليل Mecafile لبيانات رسمية2008معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
m
متوسطالتعليقNA

Steering: problems reported by owners

16 owners in the United States reported problems with the steering of this car to NHTSA (model years 2008–2013), typically at around 68,000 miles.

✓ تحليل Mecafile لبيانات رسمية2008–2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →

أحدث الاستدعاءات الرسمية

عرض الكل (8) →
استدعاءحرجالتعليقEU

Wear on the upper steering column bearing could lead to increased friction during steering

Wear on the upper steering column bearing could lead to increased friction during steering. Continued use of the damaged steering column could lead to full loss of steering power, increasing the risk of an accident.

Safety Gate · الاتحاد الأوروبي11 أغسطس 2020A12/01147/20سنوات الطراز 2007–2008معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطالتعليقNA

Steering

On certain vehicles, the steering column upper bearing retainer may fail due to a manufacturing defect. if this occurs, the upper bearing may experience additional stress causing excessive play in the steering wheel. This could result in vehicle instability and increase the risk of injury and/or damage to property. Correction: Dealers will replace steering shaft on EX35/FX35/45 and replace steering column assembly on GT-R.

وزارة النقل الكندية11 فبراير 20152015060سنوات الطراز 2008معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالتعليقNA

Steering:Column

Nissan North America, Inc. (Nissan) is recalling certain model year 2008 Infiniti EX35 vehicles equipped with the power tilt/telescope option included in the premium package, manufactured June 29, 2007, to April 25, 2008, 2009 Infiniti FX35 and FX45 vehicles manufactured October 31, 2007, to April 16, 2008, and 2009 Nissan GT-R vehicles manufactured March 14, 2007, to April 25, 2008. The steering column outer tube may not be round, resulting in extra stress being applied to the upper steering bearing. This stress may cause the bearing retainer to fracture, creating extra play in the steering wheel or a possible loss of steering.

NHTSA · الولايات المتحدة2 فبراير 201515V054000سنوات الطراز 2008معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →

أحدث النشرات الفنية

عرض الكل (34) →
نشرةطفيفأخرىNA

نشرة

TELEMATICS CONTROL UNIT RESET AFTER AUTOMATIC COLLISION NOTIFICATION SERVICE INFORMATION The Telematics Control Unit (TCU) has the ability to send an automatic collision notification when the vehicle is involved in an accident. Once an automatic collision notification is performed, the function becomes disabled and the TCU must be reset to re-enable the automatic collision notification function. Some models will store DTC B2E1B-97 for Automatic eCAll locked as CURRENT when this function is disabled. This bulletin describes how to reset the TCU after an automatic collision notification has been performed. For models with B2E1B-97 for Automatic eCAll locked set as CURRENT, complete the SERVICE PROCEDURE starting on page 2, and then erase DTCs after confirming the TCU condition is UNLOCK.

NHTSA · نشرة المصنع11006966سنوات الطراز 2012معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
نشرةطفيفالكهرباءNA

نشرة

BATTERY QUICK CHARGE NOTICE SERVICE INFORMATION When charging the vehicles 12 volt battery with the high amperage quick charge function, the ignition should never be ON, or turned ON, while charging. Attempting to start the vehicle, or turning the ignition ON, while using the high amperage quick charge could potentially damage the fuel pump control module. Only turn the ignition ON when either the ESM or a technical service bulletin service procedure states to do so, and only while using a battery maintainer or smart charger set to reflash mode, or a similar setting. Battery voltage should not exceed 16V during a reprograming operation.

NHTSA · نشرة المصنع10208943سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
نشرةطفيفالكهرباءNA

نشرة

CLEANING FRONT OR REAR COMBINATION LAMP ASSEMBLIES This bulletin has been amended. See AMENDMENT HISTORY on the last page. Please discard previous versions of this bulletin.

NHTSA · نشرة المصنع10206343سنوات الطراز 2013معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →

المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0).