أحزمة الأمان
وظيفة القفل العادية لبكرة الحزام الآلي (السلبي) قد تتسبب في تعطل تجميع الونش المحرك للحزام، بحيث لا ينشر نظام الحزام السلبي أو لا يعمل، أو يعلق عند نقاط مختلفة على المسار، مما يؤدي إلى التواء كابله أو انكساره أو انفصال اللسان.
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Jaguar 1990 (كل الأجيال)
وظيفة القفل العادية لبكرة الحزام الآلي (السلبي) قد تتسبب في تعطل تجميع الونش المحرك للحزام، بحيث لا ينشر نظام الحزام السلبي أو لا يعمل، أو يعلق عند نقاط مختلفة على المسار، مما يؤدي إلى التواء كابله أو انكساره أو انفصال اللسان.
زيت قد يتسرب من موضع التثبيت بالتجعيد (الكبس) على خرطوم الضغط العالي لنظام التوجيه بمساعدة القدرة الهيدروليكية. وقد يؤدي ذلك إلى فقدان مساعدة القدرة في التوجيه.
قد ينتقل سلك الجهد العالي من ملف الإشعال من موضعه الأصلي في التصنيع إلى مكان أقرب من خرطوم الحاقن #4a. وقد يؤدي ذلك إلى تحلل خرطوم الحاقن بفعل الأوزون واحتمال تسرب الوقود. وقد تتسبب هذه التسربات في حريق تحت غطاء المحرك. التصحيح: سيتم استبدال أسلاك الجهد العالي لكل من البنك "a" والبنك "b". سيتم فحص خرطوم الحاقن #4 بحثًا عن علامات التشقق أو الانشقاق، وسيتم استبداله عند الضرورة.
إن كابل الجهد العالي القادم من ملف الإشعال يمكن أن يتحرك من موضعه الأصلي في المصنع ويقترب من خرطوم حاقن الوقود رقم 4a. وقد يؤدي ذلك إلى تشقق أو تمزق الخرطومين الخارجي والداخلي للحاقن بسبب تدهورهما نتيجة التعرض للأوزون.
Note: 1978-90 models excessive fuel vapour pressure can occur such that a weakening of the fuel tank structure can result in fuel leaks. In the presence of an ignition source, a vehicle fire could result. Correction: Dealers will install a revised fuel purge system which eliminates excessive vapour pressure build-up.
Excessive fuel vapor pressure can occur that, after prolonged cycling, could weaken the fuel tank structure.
Xj-s 1982-90 xj12/vanden plas 1980-90 dirt ingress may cause the electronically controlled valves in the cruise control actuator to malfunction. If this occurs, the cruise control will fail to disengage under normal operating conditions resulting in possible loss of driver control. Correction: Cruise control actuator operation will be checked and an additional vacuum dump will be installed.
Excessive fuel vapor pressure can occur.
Seals of lower fuel tank gauge could fail causing gas to leak into lower fuel tank cavity and possibly into passenger compartment.
Electrical wiring harness may have been incorrectly installed and could cause a short circuit.
Possible fuel leakage from the engine fuel injection system, particularly in the area of the hose/clip fittings. Consequence of defect: The presence of an ignition source, with fuel leakage, could result in an engine compartment fire or the destruction of ignition distributor cap.
Due to misalignment of fuel rail halves and effects of temperature change on the connections, there is the possibility of fuel leakage at the fuel rail joints. Fuel leakage could present the potential for fire. Vin - xj12 - 310613 to 365261 xjs - 104146 to 111980
Fuel leakage may develop at the two main fuel rail connections. Deterioration at these two connections has been traced to a combination of misalignment of the two rail halves and the effect of temperature changes.
Certain vehicles could be subject to a fuel leakage in the engine compartment due to the possibility of deterioration in the integrity of the high pressure fuel hose connections.
Deterioration of high pressure fuel hoses in the engine bay can cause fuel leakage which could result in possible engine compartment fire
يمكن أن يلامس قمّ المحرك مع لوحة حماية صمام التمدد الخاص بمكيف الهواء، مما يؤدي إلى احتكاك وتآكل في القمّ. Note: "harness" here means wiring harness (كابلات/أسلاك الحزام الكهربائي), so the more accurate translation is below. يمكن أن يلامس حزام أسلاك المحرك لوحة حماية صمام التمدد الخاص بمكيف الهواء، مما يؤدي إلى احتكاك الحزام وتآكله.
Electronically controlled valves in the cruise control actuator may not function properly due to dirt entering the valves.
V.I.N. Xj12 - 310613 إلى 431598 XJS - 104146 إلى 125224 يوجد احتمال لحدوث تسرب من نظام توصيل الوقود، مما قد يؤدي إلى نشوب حرائق في حجرة المحرك.
The supplier of the fuel cut-off inertia switch made unauthorized changes to the switch contacts. Under certain conditions a high electrical resistance and open circuit may result, preventing current flow to the fuel pump.
Certain vehicles may be fitted with an unauthorized fuel pump electrical inertia switch. This switch has a tin coating added to the contacts that create the potential for a high electrical resistance. This could cause overheating and possible distortion of the plastic mounting around the fixed contact. This could result in inability to start the vehicle since there is a flow of current to the fuel pump.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).