Certain vehicles do not comply with the requirements of C.M.V.S.S. 209 - Seat Belt Assemblies. The seat belt assemblies may not withstand the force requirements of the standard. In a crash, if the belt buckle fails, there is an increased risk of injury to the occupant. Correction: Belt buckle assemblies will be inspected and replaced if necessary.
وزارة النقل الكندية23 أكتوبر 20002000232سنوات الطراز 2000–2001معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
A component within each front seat belt buckle may have received insufficient heat treatment. This may result in unintentional release of the set belt latch if it is subjected to a loading which exceeds the standard specified by EEC Regulation 16 during an accident.
DVSA · المملكة المتحدة4 أكتوبر 2000R/2000/089سنوات الطراز 2000معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
Vehicle description: Passenger vehicles equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."
NHTSA · الولايات المتحدة25 أغسطس 200000V228004سنوات الطراز 2000–2001معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).