قراءة مجانية · حساب مجاني للمساهمةخليفة Anticars (2000)

Mercedes-BenzMercedes-Benz الفئة إي V213

2016–2023 · 22 أعطال موثّقة · 3 أسواق

يجمع هذا الملف الأعطال المعروفة لـMercedes-Benz الفئة إي V213، التي كتبها المجتمع ووثّقها بالمصادر. القراءة مجانية، والحساب المجاني يتيح المساهمة. يحصل العطل على الختم عندما يعتمده عدد كافٍ من المساهمين الموثوقين.

يشتكي المالكون كثيرًا من مشكلات في engine في هذه السيارة (93 شكوى)، لكن لم يشرح أحد السبب بعد. هل تعرفه؟اكتب الإدخال
يشتكي المالكون كثيرًا من مشكلات في electrical system في هذه السيارة (84 شكوى)، لكن لم يشرح أحد السبب بعد. هل تعرفه؟اكتب الإدخال

أخطر الأعطال

عرض الكل (22) →
m
حرجالمحركNA

Engine: problems reported by owners

93 owners in the United States reported problems with the engine of this car to NHTSA (model years 2016–2023), typically at around 23,000 miles. Reported consequences: 10 fires, 1 injury.

✓ تحليل Mecafile لبيانات رسمية2016–2023معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
m
حرجالكهرباءNA

Electrical system: problems reported by owners

84 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 2016–2023), typically at around 18,000 miles. Reported consequences: 6 fires, 3 injuries.

✓ تحليل Mecafile لبيانات رسمية2016–2023معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
m
حرجالمقصورةNA

Airbags: problems reported by owners

57 owners in the United States reported problems with the airbags of this car to NHTSA (model years 2016–2019), typically at around 10,000 miles. Reported consequences: 7 crashes, 6 injuries.

✓ تحليل Mecafile لبيانات رسمية2016–2019معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →

أحدث الاستدعاءات الرسمية

عرض الكل (540) →
استدعاءمتوسطناقل الحركةKR

동력전달장치 기타

공급업체의 생산 공정의 편차로 인해 시간이 지남에 따라 드라이브 샤프트의 유니버셜 조인트가 마모될 수 있으며, 이로 인해 유니버셜 조인트에서 윤활유 손실이 발생하여 유니버셜 조인트가 파손될 수 있음. 그 결과로 트랜스퍼 케이스와 전륜 구동 장치 간의 연결이 끊어져 추진력을 잃을 수 있고 충돌 위험이 증가할 수 있음이 확인됨에 따른 리콜 <대상차량별 생산일자> S 450 4MATIC: 2018.01.25~2019.11.14 S 560 4MATIC: 2019.08.30~2019.09.12 CLS 400 d 4MATIC: 2019.02.25~2019.04.11 S 350 d 4MATIC: 2019.04.09 E 450 4MATIC: 2019.02.05 S 400 d 4MATIC: 2017.12.11

MOLIT · كوريا الجنوبية30 سبتمبر 20266389سنوات الطراز 2017–2019معروض باللغة الأصلية (الكورية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءمتوسطناقل الحركةUK

SRPC2603 - Drive Shaft Joint

Mercedes-Benz AG has determined that on certain 4MATIC E-Class (213 platform) S-Class Coupé (217 platform) S-Class (222 platform) E-Class Coupe/Convertible (238 platform) GLC (253 platform) and CLS (257 platform) vehicles increased wear of the universal joint on the drive shaft might occur.

DVSA · المملكة المتحدة21 سبتمبر 2026R/2026/148سنوات الطراز 2019معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
استدعاءحرجالتعليقEU

Motorrijtuigen en aanhangwagens - stuurinrichting

De drie aluminium schroeven waarmee de power-pack aan de stuurinrichting is bevestigd, kunnen door blootstelling aan water en strooizout roesten.

rdw28 أغسطس 2026MGP230033سنوات الطراز 2016معروض باللغة الأصلية (الهولندية) · الترجمة قيد الانتظارعرض التفاصيل →

أحدث النشرات الفنية

عرض الكل (488) →
نشرةمتوسطالتعليقNA

نشرة

Complaint Diverse functional limitations in the vehicle in combination with various warning and fault messages in the instrument cluster display. Cause Communication timeouts mean that communication errors may occur in the onboard electrical system, which can result in various fault messages being displayed in the instrument cluster. This could be down to delayed feedback from the drivetrain control unit (N127) (CPC) to other control units networked to the CAN bus. Information: Only valid for vehicles through production period 10/2025. Not valid for vehicles with control unit CDCC (N125, central controller charging and driving) It may not be possible to attribute any communication errors stored in the control units on the CAN bus to a specific cause In rare instances, there may be a brief activation of the yellow warning lamp for engine diagnosis or there may be a sporadic delay with the start enable. There may not be any specific fault codes present that indicate a specific component. Example image: Fault messages in instrument cluster: The reason for this could be down to delayed feedback from the control unit CPC3 to other control units networked on the CAN bus. Remedy Do not replace any components!!! ******************************************************************************************************* 1. Connect charger (see AR54.10P1127WT). Note: An adequate voltage from the onboard electrical system battery must be guaranteed for the entire duration of the work procedure. Otherwise, the control units could be damaged if an undervoltage occurs. Information: Observe the operating instructions of the charger. Information: Use the charger to ensure an adequate voltage (at least 12.5 V) from the onboard electrical system battery. 2. Connect diagnostic system (see AD00.00P200006FR). Note: Always use the latest XENTRY Diagnostics software release. Information: Strict compliance with the operation steps in XENTRY Diagnostics is absolutely essential. 3. Select control unit N127 (CPC) via the direct link using XENTRY Diagnosis. Information: To do so, select the following menu items: Control units view Drive systems N127 "Drivetrain" control unit (CPC) 4. Update software for control unit N127 (CPC) (see AR54.21P001401Y). Info: To do so, select the following menu items: Adaptations Control unit update Update control unit software. Information: You are then automatically guided through the steps "Update of control unit software" and "SCN coding". Always observe the following operation steps at all times 5. Disconnect diagnostic device from vehicle (see AD00.00P200006FR). 6. Disconnect charger from vehicle (see AR54.10P1127WT).

NHTSA · نشرة المصنع11038925سنوات الطراز 2023معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →
نشرةطفيفالهيكلNA

نشرة

الشكوى: صوت طقطقة معدني صادر من منطقة مكبرات الصوت الموجودة في الأبواب. السبب: قيد التحليل. الإجراء العلاجي: لتضييق نطاق السبب، قم أولاً بإزالة تغطية الباب الداخلية. إذا استمر الصوت حتى بعد إزالة تغطية الباب، فتابع التشخيص باتجاه مكبر الصوت، وإذا لزم الأمر، أنشئ حالة TIPS مع فيديو توضيحي كمرفق. ملاحظة: يرجى الرجوع إلى هذه الوثيقة في مطالبة الضمان، وبعد اكتمال التشخيص، اختر رمز العطل بحسب الجزء المكوّن الذي يسبب المشكلة. إذا توقف الصوت عند إزالة تغطية الباب، فيرجى المتابعة وفقاً لـ LI72.10P067691. معلومات: في هذه الحالة، لا تستخدم رمز عطل لمكبرات الصوت في مطالبة الضمان!

NHTSA · نشرة المصنع11038217سنوات الطراز 2018–2023ترجمة آلية · اللغة الأصلية: الإنجليزيةعرض التفاصيل →
نشرةمتوسطالتعليقNA

نشرة

Complaint Slight creaking noises when steering. Cause Noises may come from one or more sleeves of the horn contact plate. Remedy Remove the horn contact plate and check the sleeves for noise; see attached video. If necessary, apply lubricant to the sleeves.

NHTSA · نشرة المصنع11038188سنوات الطراز 2017–2023معروض باللغة الأصلية (الإنجليزية) · الترجمة قيد الانتظارعرض التفاصيل →

المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).