الوسائد الهوائية:الأمامية:وحدة الاستشعار/التحكم-غير نشطة
على بعض المركبات الركابية، قد يتعرض جهاز مراقبة الوسادة الهوائية المدمج (IABM) للتلوث بالماء أو بسوائل أخرى، وقد يحدث له قصر كهربائي داخلي.
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Mercury Tracer (كل الأجيال)
على بعض المركبات الركابية، قد يتعرض جهاز مراقبة الوسادة الهوائية المدمج (IABM) للتلوث بالماء أو بسوائل أخرى، وقد يحدث له قصر كهربائي داخلي.
Vehicle description: Passenger vehicles equipped with 1.9l engines, built at the hermosillo assembly plant and originally sold or currently registered in arizona. Cracks can develop in the fuel tank near the heat shield attachment resulting in fuel leakage if the cracks go through the fuel tank wall.
Vehicle description: Passenger vehicles equipped with 1.9l engines, built at the hermosillo or wayne assembly plants and originally sold or currently registered in nevada, florida, hawaii, texas, california, louisiana, georgia, south carolina, mississippi, oklahoma, alabama and arkansas. Cracks can develop in the fuel tank near the heat shield attachment resulting in fuel leakage if the cracks go through the fuel tank wall.
DEFECT: THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.
وحدة الوسادة الهوائية على جانب السائق قد يكون بها مُنفِخ (أسطوانة الغاز) ملحوم بشكل غير كافٍ.
On vehicles with manual transmission, the roll pins securing the ignition lock cylinder in the steering column housing may not remain in place. This could cause the ignition lock cylinder to disengage from the steering column housing which could result in steering column lock-up and loss of steering control. Correction: Vehicles will be inspected and if roll pins are present and fully inserted, a plastic snap-on sleeve will be installed to prevent the pins from coming out. If one or both or the roll pins are missing or not fully inserted, the ignition lock housing assembly will be replaced (along with the door locks and the liftgate/deck-lid locks so that key compatibility is maintained).
Fatigue cracks may develop in the solder joint between the fuel return tube and the fuel pump sending unit located on the top of the fuel tank. This would allow fuel vapours to escape from the tank and when the tank is 7/8 or more full, a small amount of liquid fuel may leak from the crack presenting a potential fire hazard. Note: For escort models only gt and lxe lines involved. Correction: Vehicles will be inspected and fuel pump sending unit assembly will be replaced with one of improved strength.
Fatigue cracks can develop in the solder joint between the fuel return tube and the fuel pump sending unit located at the top of the fuel tank.
The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.
ملاحظة: تنطبق على المركبات الموجودة في أونتاريو وكيبيك والمقاطعات الأتلانتيكية. قد تتآكل مجموعة أسلاك مضخة الوقود بسبب ملح الطرق، مما قد يؤدي إلى تكوّن جسر كهربائي بين دائرة كهرباء مضخة الوقود وأطراف مرسل مقياس الوقود. قد يتسبب ذلك في أن تؤدي دائرة التأريض لمرسل الوقود إلى ارتفاع حرارة الأسلاك وصهر عازلها قبل انصهار المصهر في دائرة طاقة مضخة الوقود. سيؤدي ذلك إلى ظهور دخان ورائحة، وقد يترتب عليه فقدان إمداد الوقود إلى المحرك وتوقف المحرك. التصحيح: سيتم تركيب مجموعة أسلاك توصيل مزودة بمصهر في دائرة كهرباء مضخة الوقود/المرسل.
The roll pins securing the ignition lock in the steering column housing can separate or move out of position.
Vehicles may be equipped with stop lamp switches that potentially could intermittently malfunction and result in the stop lamps not illuminating when the brakes are applied. This could result in following motorists not being signaled that the vehicle is braking, which could result in an accident. Correction: Vehicles will be inspected and stop lamp switches replaced if necessary.
The stop lamp switches could intermittently malfunction resulting in the stop lamps not illuminating when the brakes are applied.
The front seat lap-shoulder belt retractors may lock repeatedly at low belt pull-out rates thereby discouraging people from using the seat belt. Correction: Lap-shoulder belt assemblies will be inspected and replaced if necessary.
Some lap shoulder belt retractors were built with certain out of tolerance components.
The front passenger seats may be equipped with incorrect inboard or outboard seat tracks. In this event the seat would not be latched when in the rearmost position, permitting unrestricted forward movement. In the event of a frontal collision, risk of injury to the front seat occupants would be increased. Correction: Seat tracks will be inspected and replaced if necessary.
Incorrect fuel filler neck attachment screws were used to attach the neck to the rear quarter panels.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).