Stalling problems (US safety investigation)
NHTSA, the US road safety agency, received a defect petition (DP84020) about this problem on 8 August 1984 for 1982–1983 models; it was closed on 11 April 1985 without a recall.
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Nissan Stanza III
يجمع هذا الملف الأعطال المعروفة لـNissan Stanza III، التي كتبها المجتمع ووثّقها بالمصادر. القراءة مجانية، والحساب المجاني يتيح المساهمة. يحصل العطل على الختم عندما يعتمده عدد كافٍ من المساهمين الموثوقين.
NHTSA, the US road safety agency, received a defect petition (DP84020) about this problem on 8 August 1984 for 1982–1983 models; it was closed on 11 April 1985 without a recall.
NHTSA, the US road safety agency, received a defect petition (DP88001) about this problem on 29 September 1987 for 1985 models; it was closed on 19 February 1988 without a recall.
NHTSA, the US road safety agency, opened a preliminary evaluation (PE88025) into this problem on 9 February 1988 for 1985 models; it was closed on 11 May 1988 without a recall.
Incorrect tire inflation pressures were printed on certification labels.
If a certain type of rear end collision occurs, the edge of a welded bracket on the floor panel subframe may pierce the fuel filler pipe. Consequence of defect: Fuel leakage would occur which could result in a fire. Vehicles would not comply with fmvss 301.
The involved vehicles do not conform to federal motor vehicle safety standard no. 105, "hydraulic brake systems", due to the brake pedal height being adjusted lower than specifications. If a vehicle has such a misadjustment it could also experience partial brake system disablement.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0).