Wheels
Cracks develop in the wheel mounting surface. If these cracks become severe enough, the wheel will completely separate from the vehicle.
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Oldsmobile كتلاس (كل الأجيال)
Cracks develop in the wheel mounting surface. If these cracks become severe enough, the wheel will completely separate from the vehicle.
Cracks develop in the wheel mounting surface. If these cracks become severe enough, the wheel will completely separate from the vehicle.
Left handed driver's side shoulder belt anchor plate may be upside down in lock pillar so that the unthreaded slot of the plate aligned with the hole in the lock pillar. This resulted in the anchor bolt being driven into the slot instead of the threaded hole of the anchor plate. Consequence of defect: In a vehicle crash, belt anchor bolt may pull loose from anchor plate, thus failing to comply with fmvss 210, seat belt assembly anchorages, and increases likelihood of injury to occupant.
في بعض المركبات، قد يؤدي التوسيع المفرط لثقب التوجيه في لوحة دعم فرامل الخلف إلى السماح بدوران أسطوانة الفرامل الطرفية، مما قد يؤدي إلى فقدان سائل الفرامل في الفرامل الخلفية وفقدان القدرة على الكبح الخلفي. سيؤدي ذلك إلى زيادة مسافات التوقف واحتمال وقوع حادث تصادم. ملاحظة: تنطبق هذه المعلومات على المركبات في أونتاريو وكيبيك فقط.
Excessive enlargement of the wheel cylinder pilot hole in the rear brake backing plate could allow the wheel cylinder to rotate and cause loss of brake fluid. Consequence of defect: A loss of brake fluid leads to loss of rear brake action, creating the potential for an accident. Front brakes would remain operational.
The axle retaining "c" clip in the differential may dislodge and allow the axle, wheel and brake drum to separate from the vehicle when subjected to side forces. Axle separation could result in loss of vehicle control and possible crash.
The tie rods are part of the steering linkage and transmit turning movements to the wheels. The bolts that fasten the tie rods to their adjusters may not be tight enough. This could allow the tie rod to loosen and detach itself from the adjuster.
The rear brake system brake pipe from the master cylinder to the proportioner valve on these vehicles may be contacting the air cleaner resonator bracket. Over an extended period of operation, the brake pipe could wear through sufficiently to cause a loss of brake fluid and a partial loss of braking action. If a vehicle happens to be in motion at a time when minimum stopping distance is required, this condition could result in a vehicle crash without prior warning. Models equipped with 5.7 l. V-8 diesel engines.
Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.
"tx" heavy duty wheels may have been manufactured with laminated steel. The wheel disc may fracture and the wheel and tire could partially or completely separate from the vehicle.
Vehicle description: Passenger vehicles and mini vans originally sold or currently registered in the following states: Connecticut, illinois, indiana, maine, massachusetts, michigan, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont and wisconsin. The rear cradle bolts pull through the retainers due to corrosion of the retainer. If both bolts pull through, the rear cradle would not longer be supported at these mounting locations and the steering intermediate shaft can separate from the steering gear.
Brake stoplamps may not illuminate or, in some cases, stoplamps will not stay illuminated all the time when brakes are applied due to a faulty stoplamp switch. Also in vehicles equipped with cruise control, a faulty stoplamp switch can result in resumption of the cruise control function upon release of the brake pedal.
Front shoulder belt guide loop attachment fastener may pull through door mounted anchor plate.
The electronic air conditioning control may not function when starting car that has been parked for a few hours with ignition off.
تقد أن تنزلق جلبة نايلون صغيرة في مفصل السلك (bail) لمحرك سيرفو مثبت السرعة، مما يتسبب في زيادة متقطعة وغير متوقعة في سرعة المحرك، أو في ظاهرة الاحتراق الذاتي (dieseling)، أي استمرار تشغيل المحرك بعد إيقاف الإشعال.
لا تتوافق هذه المركبات مع معيار c.M.V.S.S. 1105 الخاص بالانبعاثات التبخرية. قد تعاني المركبات من تعطل مفتاح الفراغ الحراري لتنقية العلبة (canister purge thermo vacuum switch).
These vehicles do not comply with c.M.V.S.S. 1105 - evaporative emissions. Vehicles may experience an inoperative canister purge thermo vacuum switch. Correction: Canister purge thermo vacuum switch will be replaced.
The parking brake cable may be disconnected from the left rear brake caliper.
Manual valve link in the transmission may have been improperly formed.
An incorrectly indexed wiring harness may cause the center high mounted stop lamp to remain illuminated when the headlights or parking lamps are on. Fmvss 108 lamps, reflective devices and associated equipment requires that this stop lamp be lighted only when the brakes are applied. Also, the opera lamps may come on when the brakes are applied. Consequence of defect: The center high mounted stop lamp provides additional warning that the vehicle is slowing or stopping. If this lamp malfunctions, it may contribute to a rear end accident.
على بعض المركبات، قد يؤدي التوسيع المفرط لثقب التوجيه في لوحة الدعم الخلفية إلى السماح لأسطوانة العجلة بالدوران، مما قد يؤدي إلى فقدان فعل الفرامل الخلفية.
On certain vehicles, the heads of the rear seatbelt anchor bolts may break off during normal vehicle use and in the event of an accident in which the rear seatbelts are in use, the probability of injury to the wearer will be increased.
On certain vehicles, the rear brake backing plates may develop a corrosion condition which could result in loss of rear brake fluid and loss of rear braking capabilities. This recall affects vehicles sold in the Maritime provinces only.
The vehicles were assembled with front seat belt retractors which may not perform adequately during a collision.
Rear axle assembly may have axles that were improperly manufactured. This condition may result in separation of the axle shaft and wheel assembly from the vehicle.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).