استدعاء
在配备 2.5 升发动机的车辆上,燃油系统可能会在节气门体喷射燃油供油管连接处发生泄漏,从而存在引擎盖下起火的可能性。
🔔 أنشئ حسابًا مجانيًا لتلقي تنبيهات البريد عن Pontiac Phoenix (كل الأجيال)
在配备 2.5 升发动机的车辆上,燃油系统可能会在节气门体喷射燃油供油管连接处发生泄漏,从而存在引擎盖下起火的可能性。
قد يتسرب نظام الوقود عند وصلة أنبوب تغذية الوقود بالحقن في جسم الخانق. العاقبة المترتبة على العيب: قد يؤدي هذا التسرب إلى نشوب حريق تحت غطاء المحرك، والذي قد ينتشر إلى مقصورة الركاب ويتسبب في إصابات حروق للركاب.
The brake proportioner valves may break and separate from the master cylinder during braking. This will result in a loss of brake fluid and a partial loss of braking action
The rear brake hoses were not fully seated into their fittings when the fittings were crimped onto the hose at the time of manufacture. Hose failure would cause loss of brake fluid and partial loss of braking action thereby increasing stopping distance.
Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.
Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.
The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. Continued operation of the vehicle may result in wear through of the insulation on the clutch cable. The resulting metal on metal contact could lead to failure of the brake pipe, loss of brake fluid, and partial loss of brake action.
Vehicles equipped with 4 speed manual transmissions. The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. This could eventually result in the failure of the brake pipe causing loss of brake fluid and due to the dual braking system, a partial loss of braking action. Should a partial loss ob braking action occur while the vehicle is in motion at a time when minimum stopping distances are required, a vehicle crash could occur without prior warning.
Vehicles equipped with v6 engines and power steering may have the power steering hoses incorrectly routed. This condition may allow the hoses to contact the exhaust manifold possibly resulting in hose failure. It is possible that power steering fluid could leak onto the manifold resulting in smoke and under hood fire. Such a fire could spread to the passenger compartment.
Vehicles equipped with automatic transmissions. The automatic transmission cooler line hoses may fail during vehicle operation. Transmission fluid leakage in the engine compartment may result in a vehicle fire.
There is a potential for interference between the clutch control cable and brake pipe in the master cylinder. This can result in rubbing contact when the clutch pedal is operated. Also, the brake pipe clearance to the transmission case may be inadequate. If this condition exists, it could eventually result in a failure in the brake pipe, causing loss of brake fluid and partial loss of braking action.
On certain vehicles, the front seat back locks may not lock under forward load conditions and are therefore not in compliance with CMVSS 207 - Seat Anchorages.
Some vehicles have bucket seat back locks that do not conform to federal motor vehicle safety standard 207, anchorage of seats. In event of a crash, the seat back lock may not function.
The brake proportioner valves may break and separate from the master cylinder. This would allow brake fluid to leak and would result in a partial loss of the brake system.
These vehicles may experience premature rear wheel skid when the brake pedal is applied. The absence of any corrective steering or braking action on the part of the driver could cause the rear of the vehicle to skid out of its lane of travel.
Under certain conditions, vehicles may experience premature rear wheel skid during braking. Rear wheel skidding is most likely to occur on a wet or slick surface.
Rear brake hoses may have been manufactured incorrectly when the metal end fittings were installed. Some rear brake hoses may separate from the metal end fittings when subjected to the pulling force specified by federal motor vehicle safety standard 106, "brake hoses".
Vehicles with manual transmissions. A low spring load on the pawl to engage quadrant teeth of the self adjusting clutch mechanism will result in slippage and prevent clutch release when the pedal is depressed to the floor.
Vehicles with manual transmissions. Vehicles may be equipped with defective brake proportioner valves which could cause the rear brakes to lock up prematurely during high deceleration braking. This could result in loss of vehicle control and vehicle crash without prior warning.
Under certain conditions, the rear brakes could lock up without prior warning during high deceleration braking. The problem may be caused by defective proportioner valves in the braking system.
The terminal that attaches the engine to body ground cable to the front lower tie bar may fracture resulting in reduced voltage to body grounded electrical components and cause erratic operation of the components.
The engine-to-body ground cable on certain vehicles may have been damaged during manufacture. The cable could eventually break due to the relative motion between the engine and body during vehicle operation.
The involved vehicles may have been assembled with the power steering hose incorrectly routed. The power steering hose may then contact the exhaust manifold, resulting in deterioration and eventual failure of the hose and leakage of power steering fluid onto the exhaust manifold.
The steering gear mounting plate on the involved vehicles may develop fatigue cracks at high mileage which would allow the steering gear attachment to become loose. If this condition exists, the driver may notice considerable "free play" in the steering wheel.
The steering gear mounting plate may develop fatigue cracks which would allow the steering gear attachment to become loose. The driver may notice that the steering wheel can be turned several degrees before a change in vehicle direction occurs.
المصادر: NHTSA (الولايات المتحدة، ملك عام)، وزارة النقل الكندية (رخصة الحكومة المفتوحة – كندا)، DVSA (المملكة المتحدة، رخصة الحكومة المفتوحة 3.0)، RappelConso وSafety Gate الأوروبي (فرنسا، الرخصة المفتوحة 2.0)، ووزارة MLIT اليابانية (رخصة البيانات العامة 1.0)، ووزارة MOLIT الكورية (car.go.kr).