Bulletin
A faulty electric auxiliary heater may have been installed in the certain vehicles. This could result in thefailure of the electric auxiliary heater, utilized for the vehicle interior.
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu BMW i4 (alle generationen) erhalten
Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
A faulty electric auxiliary heater may have been installed in the certain vehicles. This could result in thefailure of the electric auxiliary heater, utilized for the vehicle interior.
A faulty electric auxiliary heater may have been installed in the certain vehicles. This could result in the failure of the electric auxiliary heater.
A faulty electric auxiliary heater may have been installed in the certain vehicles. This could result in the failure of the electric auxiliary heater.
There is coolant leaking from under the car Low heater output Possible Check Control message Drive, you can continue driving (ID49) Possible fault codes stored in these BEV vehicles: 224163 Electric auxiliary heater for the high-voltage battery unit: Undervoltage or internalcommunication fault 8049AA - Coolant level sensor, expansion tank: Coolant level low or short circuit to ground or linedisconnection 80124F Electric auxiliary heater: Communication in electric auxiliary heater faulty 224F60 - Coolant level sensor, expansion tank: Coolant level low or short circuit to ground or linedisconnection 224111 - Cooling system for power electronics: Coolant loss detected 224107 - Cooling system for high-voltage battery unit, component protection: Detection of coolantloss
A manufacturing defect in high-voltage cells of the high-voltage battery can result in electrolyte leakage which might result in a conductive connection with surrounding components. Depending on the contact resistance, a yellow or red Check Control message will then be displayed; it is permitted for you to continue driving, but this will result in a charging interruption during charging.
A check control message for the restraint system appears. In the instrument cluster, the red air bag warning light lights up permanently. One of the following fault codes is stored in the ACSM (air bag control unit): 930949 - Knee airbag, driver: short circuit to negative terminal 93094F - Knee airbag, front passenger: short circuit to negative terminal 93094C - Knee airbag driver's side: Resistance too great 930952 - Knee airbag, front passenger: Resistance too great.
Vehicle cannot be opened or closed using comfort access, engine start is not possible, and the vehicle may not start when placing the key against the steering column. Note: Opening, closing and starting via the BMW Digital Key or the Digital Key Card are not affected.
The customer states that the hazard warning lights flash and cannot be switched off.
Check Control message: "You can continue driving. Drivetrain (00029) is displayed. The following fault code is stored in the CCU fault memory: 224188 Accelerator pedal module, pedal sensor, sensor 1, sensor 2: Signals implausible. There may or may not be a drivability complaint associated with the fault.
Mirror Glass Return
A whistling noise is heard from the centerconsole/instrument panel when using theheating and air conditioning (HVAC) system. Heard with the blower motor set tospeed 2 or above Noise goes away on high blower speed Noise is loudest with the vents on theback of the center console in the closedposition Noise is heard the most near thecharging tray (where center consolemeets instrument panel)
Charging sessions cannot be started or they are interrupted while using a Level 2 AC high-power chargingstation, or with a Level 3 DC charging station. Charging may start normally but can interrupt after some time. Level 2 (240 V) Flex Charger and Wall boxmay also be affected. The red or white LED is displayed on the high-voltage charging socket; however, no associated fault codesare stored.
The vehicle will no longer move when put into gear. There may also be loud noise coming from the HEAT*(electric drivetrain)/Rear axles.
Gen 5 BEV/PHEV vehicles may set the Combined Charging Unit (CCU) in programming abort due to no communication to the HV charge socket electronics.
Charging sessions cannot be started or they are interrupted while using a Level 2 AC high-power charging station, or with a Level 3 DC charging station. Charging may start normally but can interrupt after some time. Level 2 (240 V) Flex Charger and Wall box may also be affected. The red or white LED is displayed on the high-voltage charging socket; however, no associated fault codes are stored.
High Voltage Connection Return
A manufacturing defect in a bearing of the electronic drive unit could result in bearing damage. This is caused by an unusual acoustic signal in the area of the drive unit. The bearing could fail completely at a later stage, which will be displayed to you by means of a red Check Control message. In this case, the driver is asked to call BMW Roadside Assistance.
In certain driving situations there can be a loss of traction or wheel slip followed by a throttle or torque requirement that can potentially damage the axle shafts. Damage of the drive shaft can cause it to break.
RSU availability. BMW AG is conducting a Service Action on certain Model Year 2025 - 2026 BMW vehicles that were produced between March 17, 2021 November 6, 2025. In certain driving situations there can be a loss of traction or wheel slip followed by a throttle or torque requirement that can potentially damage the axle shafts. Damage of the drive shaft can cause it to break.
The Combined Charging Unit (CCU) may not have been built to specifications.
While attempting to fuel/charge the vehicle,the fuel/charge door will not open.
Inspection and Return - Linkage for Wiper System
Delivery Stop Electric Auxiliary Heater
The Check Control message (CCM): "You can continue driving. Drivetrain (00029) is displayed, togetherwith the following fault code: 224188 Accelerator pedal module, pedal sensor, sensor 1, sensor 2: Signals implausible Note: There may or may not be a drivability complaint associated with this fault.
Wiper System Return
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).