Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

BuickBuick Skylark V

1979–1985 · 9 dokumentierte Mängel · 1 Märkte
Modelljahr
MarktAlleNA
RückrufKritischKarosserieNA

Rückruf

Bei Fahrzeugen mit 2,5-Liter-Motoren. Das Kraftstoffsystem kann an der Einspritzverbindung des Drosselklappenhauses undicht werden, was die Gefahr eines Brandes unter der Haube darstellt.

Transport Canada29. März 19851985032Modelljahre 1984Automatisch übersetzt · Original: EnglischDetails ansehen →
RückrufKritischMotorNA

Kraftstoffsystem, Benzin: Lieferung: Schläuche, Leitungen/Leitungen und Anschlüsse

Das Kraftstoffsystem kann an der Verbindung der Gasklappeneinspritzung und der Kraftstoffzufuhrleitung undicht werden. Folge des Defekts: Dieses Leck könnte zu einem Brand unter der Motorhaube führen, der sich auf den Fahrgastraum ausbreitet und Verbrennungen bei den Insassen verursacht.

NHTSA · USA29. März 198585V034000Modelljahre 1984Automatisch übersetzt · Original: EnglischDetails ansehen →
RückrufKritischBremsenNA

Rückruf

Die Befestigungsschrauben des hinteren Querarmhalters, die bei bestimmten dieser Fahrzeuge verwendet werden, können brechen. Ein Ausfall aller vier Schrauben auf einer Seite kann dazu führen, dass der Querlenker so weit absinkt, dass der hintere Bremsschlauch durchtrennt wird. Ein solcher Schnitt führt zu Flüssigkeitsverlust und teilweisen Bremswirkungsverlusten. Dies führt zu vergrößerten Bremswegen, und sollte ein Ausfall während der Fahrt des Fahrzeugs zu einer Zeit mit minimalen Bremsabständen auftreten, kann es zu einem Unfall kommen.

Transport Canada28. Nov. 19841984151Modelljahre 1984Automatisch übersetzt · Original: EnglischDetails ansehen →
RückrufKritischFahrwerkNA

Suspension:Rear

The rear axle control arm locates and helps control axle movement; it attaches to the frame with a bracket. The rear control arm bracket attaching bolts used on some of the involved vehicles may fracture. Fracture of all four bolts on one side of the vehicle can result in the control arm dropping enough to cut the rear brake hose. A severed brake hose would result in brake fluid loss and partial loss of braking ability.

NHTSA · USA28. Nov. 198484V153000Modelljahre 1984Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischBremsenNA

Rückruf

The brake proportioner valves may break and separate from the master cylinder during braking. This will result in a loss of brake fluid and a partial loss of braking action

Transport Canada7. Okt. 19841983084Modelljahre 1983Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischBremsenNA

Rückruf

The rear brake hoses were not fully seated into their fittings when the fittings were crimped onto the hose at the time of manufacture. Hose failure would cause loss of brake fluid and partial loss of braking action thereby increasing stopping distance.

Transport Canada26. Jan. 19831983009Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel system, gasoline:Storage:Tank assembly:Filler pipe and cap

Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.

NHTSA · USA8. März 198282V021000Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischElektrikNA

Rückruf

Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.

Transport Canada3. März 19821982026Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischGetriebeNA

Power train:Clutch assembly:Pedal/hand lever(motorcycle)

The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. Continued operation of the vehicle may result in wear through of the insulation on the clutch cable. The resulting metal on metal contact could lead to failure of the brake pipe, loss of brake fluid, and partial loss of brake action.

NHTSA · USA2. März 198282V018000Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischBremsenNA

Rückruf

Vehicles equipped with 4 speed manual transmissions. The clutch cable may rub against the master cylinder brake pipe when the clutch pedal is operated. This could eventually result in the failure of the brake pipe causing loss of brake fluid and due to the dual braking system, a partial loss of braking action. Should a partial loss ob braking action occur while the vehicle is in motion at a time when minimum stopping distances are required, a vehicle crash could occur without prior warning.

Transport Canada25. Feb. 19821982022Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischFahrwerkNA

Rückruf

Vehicles equipped with v6 engines and power steering may have the power steering hoses incorrectly routed. This condition may allow the hoses to contact the exhaust manifold possibly resulting in hose failure. It is possible that power steering fluid could leak onto the manifold resulting in smoke and under hood fire. Such a fire could spread to the passenger compartment.

Transport Canada16. Okt. 19801980132Modelljahre 1981Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischGetriebeNA

Rückruf

Vehicles equipped with automatic transmissions. The automatic transmission cooler line hoses may fail during vehicle operation. Transmission fluid leakage in the engine compartment may result in a vehicle fire.

Transport Canada26. Sept. 19791979162Modelljahre 1980Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischBremsenNA

Service brakes, hydraulic:Foundation components:Hoses, lines/piping, and fittings

There is a potential for interference between the clutch control cable and brake pipe in the master cylinder. This can result in rubbing contact when the clutch pedal is operated. Also, the brake pipe clearance to the transmission case may be inadequate. If this condition exists, it could eventually result in a failure in the brake pipe, causing loss of brake fluid and partial loss of braking action.

NHTSA · USA5. Apr. 197979V090000Modelljahre 1980Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelMotorNA

Rückruf

Diese Fahrzeuge entsprechen möglicherweise nicht der CMVSS 1101 – Emissionseinrichtungen.

Transport Canada23. Okt. 19841984135Modelljahre 1980Automatisch übersetzt · Original: EnglischDetails ansehen →
RückrufMittelKarosserieNA

Vehicle speed control:Springs

The throttle linkage may bind because during normal operation, the throttle body case may interfere with the linkage. This interference could prevent the throttle from closing even though the driver has removed his foot from the accelerator pedal.

NHTSA · USA16. Okt. 198484V132000Modelljahre 1985Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seats:Front assembly:Recliner

Some vehicles have bucket seat back locks that do not conform to federal motor vehicle safety standard 207, anchorage of seats. In event of a crash, the seat back lock may not function.

NHTSA · USA6. Feb. 198484V011000Modelljahre 1984Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Rückruf

These vehicles may experience premature rear wheel skid when the brake pedal is applied. The absence of any corrective steering or braking action on the part of the driver could cause the rear of the vehicle to skid out of its lane of travel.

Transport Canada28. März 19831983035Modelljahre 1980Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Service brakes, hydraulic:Foundation components

Under certain conditions, vehicles may experience premature rear wheel skid during braking. Rear wheel skidding is most likely to occur on a wet or slick surface.

NHTSA · USA24. Feb. 198383V018000Modelljahre 1980Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Service brakes, hydraulic:Foundation components:Hoses, lines/piping, and fittings

Rear brake hoses may have been manufactured incorrectly when the metal end fittings were installed. Some rear brake hoses may separate from the metal end fittings when subjected to the pulling force specified by federal motor vehicle safety standard 106, "brake hoses".

NHTSA · USA1. Jan. 198383V007000Modelljahre 1982Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelGetriebeNA

Rückruf

Vehicles with manual transmissions. A low spring load on the pawl to engage quadrant teeth of the self adjusting clutch mechanism will result in slippage and prevent clutch release when the pedal is depressed to the floor.

Transport Canada25. Aug. 19811981089Modelljahre 1980–1981Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Rückruf

Vehicles with manual transmissions. Vehicles may be equipped with defective brake proportioner valves which could cause the rear brakes to lock up prematurely during high deceleration braking. This could result in loss of vehicle control and vehicle crash without prior warning.

Transport Canada17. Aug. 19811981087Modelljahre 1980Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelElektrikNA

Electrical system:12v/24v/48v battery:Cables

The engine-to-body ground cable on certain vehicles may have been damaged during manufacture. The cable could eventually break due to the relative motion between the engine and body during vehicle operation.

NHTSA · USA24. März 198181V038000Modelljahre 1981Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelFahrwerkNA

Steering:Hydraulic power assist:Hose, piping, and connections

The involved vehicles may have been assembled with the power steering hose incorrectly routed. The power steering hose may then contact the exhaust manifold, resulting in deterioration and eventual failure of the hose and leakage of power steering fluid onto the exhaust manifold.

NHTSA · USA8. Okt. 198080V129000Modelljahre 1981Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Ältere →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).