Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Cadillac CTS

2001–2019 · 3 generationen · 26 dokumentierte Mängel · 4 Märkte
Generationen

Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.

SchweregradAlleMittelGering
Modelljahr
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This engineering Information (EI) ends the need for information from the field for a condition of oil leaking from the valve rocker arm oil control valve. If a vehicle is encountered with this condition, refer to SI for further diagnosis.

NHTSA · Herstellerbulletin10173419Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This engineering information PI ends the need for information from the field on a oil leak from the oil pan.

NHTSA · Herstellerbulletin10158870Modelljahre 2018Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This engineering information PI ends the need for information from the field on a oil leak from the oil pan.

NHTSA · Herstellerbulletin10158871Modelljahre 2018Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This technical bulletin provides a procedure to replace the crankshaft bearings and rear oil seal to correct the customers concer of an oil leak.

NHTSA · Herstellerbulletin10138672Modelljahre 2013Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015–0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that “mating” surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped.

NHTSA · Herstellerbulletin10137707Modelljahre 2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This Preliminary Information communication provides information to the technician how to diagnose and repair a vehicle with an engine that runs with an intermittent crank no start with a Diagnostic Trouble Code P0011 or P00C6 current or history. The Camshaft Position Actuator Solenoid Valve may be sticking or binding causing the valve timing to be retarded. Dealer will need to cycle the Camshaft Position Actuator Solenoid Valve by energizing it using Global Diagnostic System 2.

NHTSA · Herstellerbulletin10129061Modelljahre 2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This Preliminary Information communication provides information to the technician about vehicles that have a coolant loss and/or coolant odor after driving the vehicle. Technician will need to test the cooling system looking for leaks at the outer head bolts. If coolant is found replace the head the concern is present on.

NHTSA · Herstellerbulletin10129071Modelljahre 2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This technical bulletin provides repair information for replacement of the drive belt tensioner to correct a customer concern for a rattle noise at 48 km/h (30 mph) to 64 km/h (40 mph) when the engine is switching between V4 and V8 and/or they notice fluid leaking from the bellow on top of the tensioner.

NHTSA · Herstellerbulletin10126388Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015–0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that “mating” surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped

NHTSA · Herstellerbulletin10125098Modelljahre 2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This Preliminary Information communication provides information to the technician about vehicles that have a coolant loss and/or coolant odor after driving the vehicle. Technician will need to test the cooling system looking for leaks at the outer head bolts. If coolant is found replace the head the concern is present on.

NHTSA · Herstellerbulletin10118267Modelljahre 2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This technical bulletin provides a procedure to install a anti rattle spring on the actuator arm for the turbo and to correct the customers concern of a rattle noise heard from front of the engine.

NHTSA · Herstellerbulletin10116611Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015–0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that “mating” surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped.

NHTSA · Herstellerbulletin10114085Modelljahre 2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This Preliminary Information communication provides information to the technician how to diagnose and repair a vehicle with an engine that runs with an intermittent crank no start with a Diagnostic Trouble Code P0011 or P00C6 current or history. The Camshaft Position Actuator Solenoid Valve may be sticking or binding causing the valve timing to be retarded. Dealer will need to cycle the Camshaft Position Actuator Solenoid Valve by energizing it using Global Diagnostic System 2.

NHTSA · Herstellerbulletin10113913Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This Preliminary Information communication provides information to the technician about vehicles that the engine may run hot with the snow plow installed. Do not exceed 64 kilometers per hour / 40 miles per hour with a snow plow mounted to the vehicle even if equipped with VYU. The vehicle could overheat and be damaged.

NHTSA · Herstellerbulletin10111729Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This preliminary information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.00150.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that mating surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a corvette the oil tank with lines and oil cooler are both required to be replaced if equipped.

NHTSA · Herstellerbulletin10096046Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS II (2008) · 2007–2014
BulletinMittelMotorNA

Bulletin

Cadillac/chevrolet: See document search button for owner letter. Diagnostic system is incorrectly indicating leakage in fuel evaporative system due to evaporative emission canister vent solenoid valve failing to close properly. Model 2012 cts, camaro. *pe updated 6/16/15. *pe

NHTSA · Herstellerbulletin10057081Modelljahre 2012Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

Gm: The engine may be leaking from the front cover or oil filter adapter. This is not a recall. *js

NHTSA · Herstellerbulletin10052475Modelljahre 2013Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS II (2008) · 2007–2014
BulletinMittelMotorNA

Bulletin

Chevrolet/cadillac: Procedures for replacing evaporative emission canister vent solenoid (cvs) valve, in closed position, that is not fully sealed and indicates a false leakage. In diagnostic system. Model 2012 cadillac cts, chevrolet camaro. *pe

NHTSA · Herstellerbulletin10047239Modelljahre 2012Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS I (2003) · 2001–2007
BulletinMittelMotorNA

Bulletin

Coolant leak from head cup plugs on gen iii engines. *mr

NHTSA · Herstellerbulletin10007119Modelljahre 2004Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS I (2003) · 2001–2007
BulletinMittelMotorNA

Bulletin

3.6l ly7 engine- engine oil leak. *mr

NHTSA · Herstellerbulletin10006624Modelljahre 2004Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS I (2003) · 2001–2007
BulletinMittelMotorNA

Bulletin

3.6l ly7 engine, intermittent stall setting a diagnostic trouble code (dtc) p0336. *tt

NHTSA · Herstellerbulletin10004174Modelljahre 2004Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinGeringMotorNA

Bulletin

This service bulletin provides a service procedure to correct a condition of a Ticking Noise from the Engine.

NHTSA · Herstellerbulletin11002442Modelljahre 2019Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinGeringMotorNA

Bulletin

Das Motortausch-Programm für das Modelljahr 2014 ist beendet.

NHTSA · Herstellerbulletin10253369Modelljahre 2014Automatisch übersetzt · Original: EnglischDetails ansehen →
CTS III (2014) · 2013–2019
BulletinGeringMotorNA

Bulletin

Ingenieurtechnische Informationen.

NHTSA · Herstellerbulletin10252889Modelljahre 2014Automatisch übersetzt · Original: EnglischDetails ansehen →
CTS III (2014) · 2013–2019
BulletinGeringMotorNA

Bulletin

Engineering Information.

NHTSA · Herstellerbulletin10252898Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Ältere →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).