Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Cadillac CTS

2001–2019 · 3 generationen · 26 dokumentierte Mängel · 4 Märkte
Generationen

Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.

SchweregradAlleMittelGering
Modelljahr
CTS III (2014) · 2013–2019
BulletinMittelFahrwerkNA

Bulletin

Power Steering Control Module DTC U0415 Symptom 00.

NHTSA · Herstellerbulletin10252854Modelljahre 2013Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelFahrwerkNA

Bulletin

Power Steering Control Module DTC U0415 Symptom 00.

NHTSA · Herstellerbulletin10252853Modelljahre 2013Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelSonstigesNA

Bulletin

Revised Front License Plate Bracket Installation Instructions.

NHTSA · Herstellerbulletin10252852Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelSonstigesNA

Bulletin

Revised Front License Plate Bracket Installation Instructions.

NHTSA · Herstellerbulletin10252851Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelElektrikNA

Bulletin

Service Update for Inventory and Customer Vehicles Hazard Warning Lamps Activation When Vehicle Unattended Expires with Base Warranty

NHTSA · Herstellerbulletin10246809Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelGetriebeNA

Bulletin

Service Update. On a small number of the vehicles identified above, the electrical connector to the transmission valve body solenoids may not be fully seated. DTC P2718 or P2720 may set resulting in the Check Engine indicator illuminating, and the transmission reverting to a ?limp home? mode providing limited forward gear selection. Dealers are to access the transmission valve body solenoids and fully seat the connectors.

NHTSA · Herstellerbulletin10207999Modelljahre 2019Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelGetriebeNA

Bulletin

Service Update. On a small number of the vehicles identified above, the electrical connector to the transmission valve body solenoids may not be fully seated. DTC P2718 or P2720 may set resulting in the Check Engine indicator illuminating, and the transmission reverting to a ?limp home? mode providing limited forward gear selection. Dealers are to access the transmission valve body solenoids and fully seat the connectors.

NHTSA · Herstellerbulletin10207708Modelljahre 2019Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This engineering Information (EI) ends the need for information from the field for a condition of oil leaking from the valve rocker arm oil control valve. If a vehicle is encountered with this condition, refer to SI for further diagnosis.

NHTSA · Herstellerbulletin10173419Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS II (2008) · 2007–2014
BulletinMittelElektrikNA

Bulletin

Kein Durchdrehen/kein Start, leere Batterie aufgrund von Ruhestromverbrauch/Entladung.

NHTSA · Herstellerbulletin10254206Modelljahre 2011Automatisch übersetzt · Original: EnglischDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelElektrikNA

Bulletin

N192210220 - Special Coverage Adjustment - Certain vehicles may have a condition that could cause bearings in the engine supercharger to emit an excessive rattling or knocking noise that is especially prominent at idle. (A low-level mechanical thrumming noise from the supercharger at idle by contrast is normal in these vehicles and does not indicate a problem). The excessive noise at issue here will typically go away when the engine RPM is raised slightly above idle. However, if left uncorrected, the problem, over time, may lead to contamination of the lubricating grease and cause the bearing to squeal. If left unaddressed, the bearing may overheat and can cause supercharger seizure or a no-start condition. Dealers are to replace the supercharger as necessary. The repairs will be made at no charge to the customer.

NHTSA · Herstellerbulletin10163853Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelBremsenNA

Bulletin

This technical bulletin provides a procedure to replace the front and rear brake pads if the front brake pads are found the cause of the squealing or squeaking.

NHTSA · Herstellerbulletin10160085Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This engineering information PI ends the need for information from the field on a oil leak from the oil pan.

NHTSA · Herstellerbulletin10158870Modelljahre 2018Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This engineering information PI ends the need for information from the field on a oil leak from the oil pan.

NHTSA · Herstellerbulletin10158871Modelljahre 2018Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS II (2008) · 2007–2014
BulletinMittelElektrikNA

Bulletin

14264B - Special Coverage - Revised Warranty Transaction Information Section. Some vehicles equipped with 3.6L (LFX), or 6.2L (LS3, L99, LSA) engines may have an evaporative emission canister vent solenoid valve that may not properly close. If this condition occurs, the vehicle?s diagnostic system may incorrectly indicate a leak in the fuel evaporative system, a Malfunction Indicator Light (MIL) may illuminate and a diagnostic trouble code may be set. This condition will not result in the release of any fuel vapors into the atmosphere. Dealers are to replace the evaporative emission canister vent solenoid valve. The repairs will be made at no charge to the customer.

NHTSA · Herstellerbulletin10156985Modelljahre 2012Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelFahrwerkNA

Bulletin

18276 - Customer Satisfaction Program - Certain vehicles, may have a condition in which the power steering assist power pack is potentially missing ?welds? between the circuit board and the motor. If this condition exists, power steering may be lost, and the driver may experience unanticipated increased steering effort as the vehicle reverts to manual steering. A chime will also sound in the vehicle, and a ?Service Power Steering? message will appear on the Driver Information Center (DIC). Manual steering functionality will be maintained but will require additional effort, particularly at lower speeds. Dealers are to replace the complete power steering rack assembly

NHTSA · Herstellerbulletin10147332Modelljahre 2018Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelElektrikNA

Bulletin

18029 - Special Coverage. Certain vehicles listed above, may have an inoperative purge solenoid that could lead to excessive fuel vapors entering the combustion chamber from the fuel tank. This condition could result in no start, idle stall, and possible drivability issues such as hesitation. The driver may see a check engine light, and may notice a ticking noise, and variation in idle speed. The driver may experience this condition most immediately after filling up the vehicle with gas or while coming to a stop. This special coverage covers the condition described above for a period of 10 years or 120,000 miles (193,000 km), whichever occurs first, from the date the vehicle was originally placed in service, regardless of ownership. Dealers are to inspect for a leak in the solenoid assembly and replace if necessary. The repairs will be made at no charge to the customer.

NHTSA · Herstellerbulletin10143751Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This technical bulletin provides a procedure to replace the crankshaft bearings and rear oil seal to correct the customers concer of an oil leak.

NHTSA · Herstellerbulletin10138672Modelljahre 2013Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelBremsenNA

Bulletin

This preliminary informational bulletin provides information on applying the correct amount of copper paste to the brake pad to correct the customers concern of a brake squeal or noise.

NHTSA · Herstellerbulletin10138597Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelInnenraumNA

Bulletin

This informational bulletin provides information regarding the Passenger Presence System (PPS) May Command Seat Belt Reminder Chime and Passenger Airbag Indicator On When Electronic Devices or Conductive Objects are Placed on Front Passenger Seat

NHTSA · Herstellerbulletin10138552Modelljahre 2013Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelBremsenNA

Bulletin

This technical bulletin provides a procedure to replace the front and rear brake pads if the front brake pads are found the cause of the squealing or squeaking.

NHTSA · Herstellerbulletin10138069Modelljahre 2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelFahrwerkNA

Bulletin

This technical bulletin provides a procedure to reprogram the power steering control module back to the original software if the APA is found inop after the gear was replaced and the PSCM was updated at the time.

NHTSA · Herstellerbulletin10138055Modelljahre 2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelSonstigesNA

Bulletin

This Preliminary Information communication provides information to the technician about vehicles that have run hot and or has a tick noise. Technician should inspect the head gaskets to ensure are not installed backwards. Technician should replace the head gasket if they are found installed backwards.

NHTSA · Herstellerbulletin10137701Modelljahre 2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelMotorNA

Bulletin

This Preliminary Information communication provides information to the technician on the steps need to diagnose and repair vehicles that may have stalling shudder and/or hard shifting into 1st gear or reverse vibration on launch (with excessive crankshaft end play). Technician will test to determine if the crank shaft end play is within specification 0.0015–0.0086 inch. If end play is found to be out of specification, remove engine and inspect for possible crankshaft thrust bearing and/or crankshaft for wear. Inspect thrust bearing for wear on one side and crankshaft on that “mating” surface. If the thrust bearing has three vertical channels worn off replace connecting rod bearings, main bearings, thrust bearing and crankshaft. If working on a Corvette the oil tank with lines and oil cooler are both required to be replaced if equipped.

NHTSA · Herstellerbulletin10137707Modelljahre 2017Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelFahrwerkNA

Bulletin

This technical bulletin provides repair information for replacing the steering wheel airbag to correct a customer concern that the steering wheel airbag is not flush to the steering wheel and/or it is difficult to depress airbag to engage the horn.

NHTSA · Herstellerbulletin10137210Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
CTS III (2014) · 2013–2019
BulletinMittelBremsenNA

Bulletin

17488 - Service Update. Revised population. Certain vehicles may have a condition in which a rear brake caliper bolt may be loose or missing. A loose brake caliper bolt could cause a rattle noise in the rear of the vehicle. A missing bolt could cause a rattle or rubbing noise, or allow the brake caliper to rotate outward and contact the rim. Dealers will inspect the rear brake caliper mounting bolts and related components. Replace any missing caliper mounting bolt, and torque all rear brake caliper mounting bolts.

NHTSA · Herstellerbulletin10137153Modelljahre 2018Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Ältere →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).