Citroën Cross Carline Kraftstoffeinspritzung Common Rail.
Bei betroffenen Fahrzeugen kann ein Konformitätsproblem am Kraftstoffeinspritz-Common-Rail dazu führen, dass sich die Mutter lockert und es möglicherweise zu einem Kraftstoffleck kommt.
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Citroën Jumpy (alle generationen) erhalten
Bei betroffenen Fahrzeugen kann ein Konformitätsproblem am Kraftstoffeinspritz-Common-Rail dazu führen, dass sich die Mutter lockert und es möglicherweise zu einem Kraftstoffleck kommt.
Bei den betroffenen Fahrzeugen könnte eine mögliche Abweichung bei der Positionierung der Dichtung des Tankeinfüllstutzens in der Nähe des Tankdeckels dazu führen, dass beim vollständigen Befüllen des Tanks Kraftstoff austritt.
Bei betroffenen Fahrzeugen kann sich die Kraftstoff-Rücklaufleitung unter bestimmten Bedingungen an der Verbindung zum Injektor lockern. In diesem Fall kann Kraftstoff aus der Verbindung austreten. Kraftstoff kann sich im Motorraum ansammeln, und Fahrzeugnutzer nehmen möglicherweise einen Kraftstoffgeruch wahr.
Es wurde festgestellt, dass der Zylinderkopf des Motors möglicherweise nicht den Fertigungsspezifikationen entspricht. Dies kann zu einem Ölaustritt führen, der, sofern er nicht behoben wird, zu einem Brand führen kann, wenn das Öl mit heißen Motorteilen in Berührung kommt.
It is possible that the fuel return pipe may chaff on the diesel fuel filter support in the engine compartment. This can if not identified result in a fuel leak.
Es wurde festgestellt, dass im Motorraum ein Kontakt zwischen der Kraftstoffrücklaufleitung und der Motorabschirmung auftreten kann. Tritt dieser Kontakt auf, kommt es zu Scheuerstellen an der Leitung, die im schlimmsten Fall zu einem Kraftstoffaustritt führen können.
Bei betroffenen Fahrzeugen kann es aufgrund einer Produktionsabweichung zu einer Fehlfunktion der Wasserpumpe kommen, wodurch die Motorleistung nachlassen und der Motor abgestellt werden kann.
Vehicles may be affected by incorrect performance of the On-Board-Diagnostics related to Selective Catalytic Reduction system and/or Diesel Particle Filter. The Malfunction Indicator Light (MIL) may not illuminate in the event of a malfunction and therefore does not comply with emission regulations.
Some vehicles may have been equipped with an incorrectly positioned fuel pipe.
The cooling system strategy and the maximum temperature alert could cause the engine to overheat this may cause an oil leak from the sump drain cap. Due to the incorrect operation of the warning system there is no driver alert.
On the affected vehicles the tightening of a sealing plug on the engine oil gallery may not be correct to specification.This could lead over time to an oil leak which in rare cases could result in oil leaking on to the road.
An engine component may not be to specification which could result in loss of engine performance. This may lead to the engine stalling and potentially causing an engine failure. In very unlikely circumstances the vehicle speed may increase without warning but will stop on its own after a few seconds.
The fuel filter's integrated heater may be defective and could cause the cover to distort. This could cause air ingress and fuel egress. Either could cause poor starting and a warning light should illuminate
An inadequate weld on the bottom engine mounting tie bar may fail and cause a serious engine vibration and separation of one of the driveshafts.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).