Steering bolts may not be tightened correctly
Incorrect assembly of the steering rack which could cause the loss of the mechanical link between the steering pinion valve and the steering rack during parking manoeuvres at full lock.
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Citroën Jumpy (alle generationen) erhalten
Incorrect assembly of the steering rack which could cause the loss of the mechanical link between the steering pinion valve and the steering rack during parking manoeuvres at full lock.
The bolts retaining the front shock absorber could come loose. This may adversely affect the steering control of the vehicle.
The tightening torque of one of the nuts of the connection between the brake servo unit and the brake pedal may be not correct to specification. This may allow air to enter the servo
The fuel filter's integrated heater may be defective and could cause the cover to distort. This could cause air ingress and fuel egress. Either could cause poor starting and a warning light should illuminate
null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air to enter the fuel system which could lead to stalling of the engine and loss of control of the car.
null Front brake discs with the incorrect thickness may have been fitted. If this has happened, breakage of the brake discs cannot be ruled out.
An internal fault with the wiper motor could cause it to stop working. In some rare cases the windscreen wipers may stop working while in operation.
On certain vehicles the front brake discs may not be the required thickness for the vehicle definition. This concern may result in reduced braking efficiency.
De massa van de ruitenwissermotor via de reguliere bedrading is onvoldoende. Hierdoor kan de ruitenwissermotor uitvallen.
null The connection between the steering column and the steering wheel can become loose and lead to the failure of the steering.
Einige Reifen können beim Transport des Fahrzeugs oberflächliche Schäden erlitten haben. Der vordere linke Reifen kann lokal begrenzte Schäden an der Lauffläche oder an der Innenseite aufweisen. Der Reifen kann reißen und Luft verlieren.
It is possible that the wiring harness for the power assisted steering motor may come in contact with other components in the engine bay. Should this occur then it is possible that the power steering assistance on this large vehicle may become affected.
In very rare circumstances the vacuum pump one way valve may not function correctly which could affect the level of braking assistance.
It has been identified that the position of the exterior lighting control ring may not be detected by the lighting management system and the lights may switch off without warning.
The threaded portion of the brake linkage rod in the brake control system may not be to conformity. This could result in a reduction of braking efficiency.
It has been identified that water may ingress the brake drums causing premature brake lining wear. Should this occur the brake effort produced by the rear wheels may be reduced.
It has been identified that due to incorrect positioning of the exterior lighting control ring by the lighting management system the lights may switch off unexpectedly.
It has been identified that on affected vehicles a non conformity within the accelerator pedal assembly may cause interference and prevent the pedal from returning to its original position. This may result in the vehicle maintaining a degree of acceleration which can be overcome by firm braking.
It has been identified that poor protection of the power steering pump earth terminal; could result in loss of power assistance to the steering.
The seat belt locking action may not be as fast as it is designed to be.
An inadequate weld on the bottom engine mounting tie bar may fail and cause a serious engine vibration and separation of one of the driveshafts.
Water ingress into the underbonnet vacuum electrovalves may cause a reduction in power assistance at the brake pedal. Malfunction of the electrovalves could also adversely affect the engine exhaust emissions.
Premature wear of the handbrake ratchet pawl may lead to inadvertent release of the handbrake. Problem of material hardness discovered in Quality Control tests.
On affected vehicles the radio display fixing screws may be missing allowing a potential detachment of the display during a collision.
L’étiquette vin (numéro d’identification du véhicule) du fabricant affiche un poids incorrect. cela peut entraîner un accident si le poids maximal autorisé est remorqué.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).