Over time partial wear of the gearbox control harnesses may occur due to contact with surrounding components. Gear selection may be affected as a result of electrical faults in some rare cases including the lighting of the warning lamp on the instrument panel and the driveability of the vehicle may be compromised.
It has been established that the con-rod (big end) shell bearings may not have been manufactured to specification. This could lead to premature deterioration of the shells and if not identified it could result in engine failure.
Over a period of time a small crack can appear on the rear axle cross member particularly under conditions of repeated maximum suspension travel. The small crack could increase in size and eventually lead to the rear wheel rubbing on the wheel arch.
Due to incorrect machining it is possible that the crankshaft is not to the correct specification which can lead to insufficient lubrication of the crankshaft and subsequent engine failure.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).