Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
Flash: Aktualisierungen des Antriebsstrang-Steuermoduls (PCM)
Kunden müssen eine Leuchte der Motorkontrollanzeige (Malfunction Indicator Lamp, MIL) aufleuchten sehen, und das Fahrzeug muss einen oder mehrere der folgenden Diagnostic Trouble Codes (DTCs) anzeigen/speichern: **P0420 - Katalysator-Systemwirkungsgrad unterhalb des Schwellenwerts Bank 1. P0430 - Katalysator-Systemwirkungsgrad unterhalb des Schwellenwerts Bank 2.** P0456 - EVAP-System, kleine Leckage. **Kunden können außerdem Folgendes bemängeln: Fahrzeug besteht die Abgasuntersuchung (Emissionsprüfung) nicht.* Bei dieser Technischen Information wird das PCM mit der neuesten verfügbaren Software neu programmiert.
Part Description: Mirror, Side View Issue Description: New mirror now includes a grommet on the electrical wire. If the mirror being removed from the vehicle does not have a grommet and the new mirror does, this is not an issue. Install the new mirror and grommet.
Kundenzufriedenheitsmitteilung T12 VECI-Etikett
Das Fahrzeugemissions-Kontrollinformations-Etikett (VECI-Etikett) bei etwa 120.000 der oben genannten Fahrzeuge enthält möglicherweise keine Emissionskontrollinformationen. Das VECI-Etikett wird häufig bei der Prüfung und Wartung im Betrieb (Inspection and Maintenance, I/M) verwendet, um die ordnungsgemäße Funktion emissionsrelevanter Bauteile zu überprüfen. Falsche Angaben auf dem VECI-Etikett könnten im Bundesstaat Kalifornien zur Verweigerung der Fahrzeugzulassung führen. Ein neues VECI-Etikett muss installiert werden.
Part Description: Mirror, Side View Issue Description: New mirror now includes a grommet on the electrical wire. If the mirror being removed from the vehicle does not have a grommet and the new mirror does, this is not an issue. Install the new mirror and grommet.
SEAL, Input If looking to replace stubshaft due to ATX fluid leaking, do not replace PTU seals. None of the seals from the PTU side will need to be replaced whenever the ATX stubshaftis replaced, even though V-seal (68408748A$) is in direct contact with the stubshaft,it will not avoid grease/oil leakage from transmission side. PTU V-seals are intended to act as a dust cover for stubshaft-PTU input shaft spline interface. PTU Input shaft seal (68408749A$) is intended to hold PTU oil and debris ingress; it should be replaced only if the fluid leakage is confirmed to be PTU oil and not ATX trans. fluid.
Part Description: Mirror, Side View Issue Description: New mirror now includes a grommet on the electrical wire. If the mirror being removed from the vehicle does not have a grommet and the new mirror does, this is not an issue. Install the new mirror and grommet.
Oem torque specifications for the steering shaft have been identified and are now being used in the installation of the vmi steering extension. This sb notifies the technicians to ensure the torque specifications for the steering extension have been complied with at the factory. This will bring the van into conformance with vmi updated processes
Oem torque specifications for the steering shaft have been identified and are now being used in the installation of the vmi steering extension. This sb notifies the technicians to ensure the torque specifications for the steering extension have been complied with at the factory. This will bring the van into conformance with vmi updated processes
"flash: Powertrain diagnostic and system improvements this bulletin involves selectively erasing and reprogramming the powertrain control module (pcm) with new software. Symptom/condition: A small number of customers may experience a malfunction indicator lamp (mil) illumination. Upon further investigation the technician may find one or more of the following diagnostic trouble codes (dtcs) set in the pcm: Jc vehicles 3.6l: P0335 - crankshaft position sensor circuit. P2610 - pcm internal engine off timer performance. U0140 - lost communication with body control module (bcm). P0456 - evap system small leak. P0108 - manifold absolute pressure sensor circuit high (2012 my only). The following transmission enhancements are also included in this software update: Continuous cycling of fuel pump relay when using remote start. 1 - 2 upshift clunk or bump. 3 - 4 harsh upshift at closed throttle after a wot stab in 1st or 2nd gear. 4 - 5 upshift clunk or bump. 5 - 6 upshift clunk or bump. 5- 4 downshift clunk or bump. 6 - 5 downshift clunk or bump. Rpm fluctuating or jerking while operating in cruise control. Condition is more noticeable when the vehicle is going up and down grades. Improves the consistency of how shifts are controlled during upshifts torque management. Delayed downshifts. Jc vehicles 2.4l: **u0140 - lost communication with body control module (bcm).** p0456 - evap system small leak. The following transmission enhancements are also included in this software update: 1 - 2 upshift clunk or bump. 3 - 4 harsh upshift at closed throttle after a wot stab in 1st or 2nd gear. 4 - 5 upshift clunk or bump. Rpm fluctuating or jerking while operating in cruise control. Condition is more noticeable when the vehicle is going up and down grades. 1 - 2 harsh upshift going down a grade. 3 - 2 downshift clunk or bump. 4 - 3 downshift clunk or bump.
Chrysler/dodge: When braking, steering wheel would shake, brake pedal pulsates and/or floor pan vibrates and need to replace, both, front brake rotors, right and left front lower control arms, brake linings and resurfacing, and install new right and left front lower control arms. Model 2011-2012 caravan, town and country. *pe
PLATE, TORQUE CONVERTER DRIVE For 3.6L with 62TE NOTE: FOR ALL PROMASTER (VF) 3.6L/62TE EQUIPPED VEHICLES: IF THE TRANSMISSION BRACKET TO THE TRANSMISSION CASE FASTENERS ARE REMOVED DURING SERVICING, THE FASTENERS (Part Number 06511385A$) ARE ONE TIME USEAGE & MUST BE REPLACED & PROPERLY TORQUED TO 105NM Replace the eight bolts (8) 06503465 drive plate to crank shaft and the four TC bolts 06504383 as they have sealants Vehicle miles < 30K: Mandatory replacement of transmission and driveplate Vehicle miles > 30K: Replace driveplate only (shot peened)
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).