Bei bestimmten Personenkraftwagen der Baujahre 1996 bis 1998, die in den Montagewerken Kansas City und Cuautitlán gefertigt wurden, oder bei Personenkraftwagen des Baujahrs 1999, die in den Montagewerken der Automotive Alliance International gefertigt wurden, kann die raue Oberfläche der Edelstahllamellen des Heizungsgebläse-Vorwiderstands die Kupferoberfläche des Kabelbaumsteckers beschädigen. Die Beschädigung kann mit der Zeit zu einem erhöhten Widerstand im Stecker führen und infolge der anschließenden Lockerung der Kontakte eine Leitungsunterbrechung verursachen.
Vehicle description: Bi-fuel vehicles. These vehicles may have a fuel tank filler pipe grommet that could have been damaged during the installation of the bi-fuel system. If the grommet is damaged, fuel could leak. Fuel leakage in the presence of an ignition source could result in a fire. Dealers will replace the fuel tank filler pipe grommet.
On certain vehicles, the fuel filler pipe vent hose may have less than the intended level of ozone resistance, which could result in the hose becoming brittle and cracking. A cracked hose could result in fuel leakage when the vehicle is being fueled. Fuel leakage in sufficient quantity in the presence of an ignition source could potentially result in a fire. Correction: Dealers will install a fuel filler vent hose containing the appropriate blend of PVC and nitrile rubber.
Transport Canada20. Sept. 19991999166Modelljahre 1996Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Vehicle description: Passenger vehicles. The fuel filler pipe vent hose may have less than the intended level of ozone resistance, which could result in the hose becoming brittle and cracking.
Vehicle description: Bi-fuel vehicles modified to run on either gasoline or compressed natural gas (cng). The natural gas fuel tanks have a solenoid shut-off valve that stops fuel flow from the fuel tank in the event of certain moderate to severe collisions. If the vehicle is in a collision and the natural gas fuel line is damaged, the system could leak natural gas.
The fuel tank filler pipe opening reinforcement, fabricated from two separately moulded pieces spin welded together, may eventually leak fuel at the weld joint. Fuel leakage in the presence of an ignition source, could potentially result in a fire. Correction: Fuel tank assemblies will be replaced with ones containing one piece moulded reinforcements.
Transport Canada9. Jan. 19961996002Modelljahre 1995Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The passenger side supplemental restraint system (air bag) may have a cracked inflator body. If the vehicle is involved in a deployment level crash, the passenger side air bag may not inflate properly which could result in reduced occupant protection. In addition, the igniter plug could separate from the inflator, which could result in the release of hot gases and could ignite flammable material or potentially cause personal injury. Correction: Vehicles will be inspected and a new passenger side air bag module will be installed if necessary.
Transport Canada21. Feb. 19951995032Modelljahre 1995Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The fuel filler opening reinforcement (an integral part of the fuel tank assembly) may leak fuel. In the presence of an ignition source, a fire could result. Correction: Fuel tank will be replaced on affected vehicles.
Transport Canada17. Okt. 19941994158Modelljahre 1995Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Fahrzeugbeschreibung: Personenkraftwagen, die im Montagewerk Kansas City gebaut und ursprünglich in den Bundesstaaten Connecticut, Delaware, Illinois, Indiana, Iowa, Maine, Maryland, Massachusetts, Michigan, Minnesota, Missouri, New Hampshire, New Jersey, New York, Ohio, Pennsylvania, Rhode Island, Vermont, West Virginia und Wisconsin sowie im District of Columbia verkauft wurden oder derzeit dort zugelassen sind. Die vorderen Schraubenfedern können in Umgebungen mit starker Korrosion infolge von Korrosion brechen. Je nach Lage des Bruchs könnte eine gebrochene Feder über den Federteller hinauswandern und einen Vorderreifen berühren.
Fahrzeugbeschreibung: Personenkraftwagen des Modelljahres 1995 mit den Motoren 2.0l und 2.5l sowie Fahrzeuge des Modelljahres 1996 mit Motoren 2.5l. Ein Festsitzen der Lager des Motorkühlerlüftermotors, bis hin zum Blockieren des Motors, kann zu einem erhöhten Motordrehmoment und einem höheren als normalen Motorstrom sowie einer damit einhergehenden hohen Motortemperatur führen.
Vehicle description: Passenger vehicles, light duty trucks, sport utility vehicles, and mini vans equipped with trw seat belt buckle assemblies. The buckle base of these seat belt assemblies were not properly heat treated and therefore do not pass the load bearing requirement of federal motor vehicle safety standard no. 209, "seat belt assemblies."
NHTSA · USA18. Aug. 200000V228001Modelljahre 2000Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Fahrzeugbeschreibung: Personenkraftwagen ohne Antiblockiersystem (ABS). Ein druckabhängiges Reduzierventil (pcrv) in den Hinterradbremsen kann korrodieren und zu einer Fehlfunktion führen, wenn das Fahrzeug in Gebieten betrieben wird, in denen zur Enteisung oder Staubbindung Salzverbindungen auf der Fahrbahn eingesetzt werden.
Vehicle description: Passenger vehicles. The air bag sensor wiring pigtail insulation can become brittle and crack over time due to accumulation of water in the pigtail protective convolute in combination with high underhood temperatures related to the routing of the wiring pigtail near the radiator. This can result in environmental stress cracking of the insulation.
Vehicle description: Passenger vehicles. The accelerator cable may have been manufactured with a burr on or near the end of the cable sleeve interior. This burr could fray the core wire resulting in the accelerator not returning to idle when the accelerator is released.
NHTSA · USA20. Juli 199999V194000Modelljahre 1998Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Vehicle description: Passenger vehicles. The terminals at the headlight switch and wiring harness connector can experience heat damage as a result of overheating.
NHTSA · USA5. Mai 199999V103000Modelljahre 1996–1998Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Vehicle description: Passenger vehicles built with automatic transmissions which utilize a park/lock solenoid. It is possible to rotate the ignition key to the lock position and remove the key without the shift lever and transmission being in park. These vehicles do not comply with the requirements of fmvss no. 114, "theft protection."
NHTSA · USA17. März 199999V060000Modelljahre 1999Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Certain vehicles do not comply with CMVSS 205 - glazing materials. The windshields on were produced without the "AS1" mark as required by American National Standards Institute (ANSI) Z26.1. These windshields fully meet all of the requirements of Standard 205. Correction: Since the absence of the AS1 mark is highly unlikely to produce any risk of injury, no corrective action will be taken.
Transport Canada21. Dez. 19981998243Modelljahre 1998–1999Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Certain vehicles may not comply with CMVSS 1105 - evaporative emissions. The rear fuel lines may allow fuel to seep and evaporate at the metal line to nylon tube joint at the rear of the vehicle near the fuel filter. This may cause evaporative emissions in excess of the standard. Correction: Vehicle will be inspected for signs of fuel escaping a joint between a nylon tube and a metal fuel line. If wetness or fuel odor are detected a reinforcement kit will be installed.
Transport Canada23. Nov. 19981998234Modelljahre 1999Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
On certain vehicles, the floor shift automatic transmission control may be damaged if subjected to certain vehicle interior cleaning products. If exposed to these products, the transmission gear position indicator may deteriorate and not correctly indicate the actual gear position. If this occurs, the shifter will continue to operate normally, but there is the potential for incorrect gear selection. Correction: Automatic transmission floor shift control will be replaced.
Transport Canada21. Okt. 19981998208Modelljahre 1995–1998Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Vehicle description: Passenger vehicles. The floor shift automatic transmission control can be damaged if subjected to certain interior cleaning products. The gear position indicator can deteriorate and not correctly indicate the actual gear position.
Note: Vehicles equipped with 2.5 litre engines. These vehicles may not comply with c.M.V.S.S. 1103 - exhaust emissions. Premature failure of the catalyst substrate material in the catalyst and exhaust manifold assemblies (light-off catalysts) can result in restricted exhaust gas flow, loss of power and exhaust emission levels in excess of those specified in the standard. Correction: Left and right hand light-off catalysts will be replaced. Underbody catalyst will be inspected and replaced if necessary.
Transport Canada20. Mai 19981998103Modelljahre 1995–1996Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).