Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Ford Explorer I

1990–1994 · 28 dokumentierte Mängel · 2 Märkte
Modelljahr
RückrufKritischFahrwerkJP

定速走行装置

ブレーキのマスターシリンダーに取付けられている定速走行装置解除スイッチにおいて、当該解除スイッチ内部のシール構造が不適切なため、ブレーキ液が漏れて内部の電気端子にかかり、接点が腐食することがある。そのため、スイッチ内部の抵抗値が高くなり、スイッチが加熱されて溶解し、最悪の場合、火災に至るおそれがある。

MLIT · Japan12. Jan. 20101216280Modelljahre 1994Im Original (Japanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischElektrikJP

前照灯

灯火装置において、前照灯スイッチの内部構造が不適切なため、スイッチ内部の接点で電 気抵抗が増加して過熱、溶損し、前照灯が点灯しなくなるか、消灯しなくなることがあり 、最悪の場合、火災に至るおそれがる。

MLIT · Japan25. Jan. 20021209280Modelljahre 1994Im Original (Japanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischElektrikJP

その他(電気装置)

運転者席のドアに取り付けられている電動式ドアミラースイッチに雨水等が侵入した状態 でスイッチ操作を行うと、スイッチ内部が短絡することがあり、最悪の場合、火災に至る おそれがある。

MLIT · Japan28. Aug. 19971206510Modelljahre 1992–1994Im Original (Japanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischElektrikNA

Electrical

If a short circuit occurs in the power mirror switch there is the potential risk of fire at or near the mirror switch (located in the driver's door). Overheating of the switch assembly creates the risk of an unattended vehicle fire. Correction: A fused jumper harness will be installed in the power mirror electrical circuit.

Transport Canada9. Juni 19971997116Modelljahre 1993–1994Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischKarosserieNA

Visibility:Rearview mirrors/devices

A short circuit condition can occur in the remote power mirror control switch circuit board as a result of a separated part of the contact assembly bridging the switch positive battery pad and adjacent chassis ground pad.

NHTSA · USA5. Mai 199797V083000Modelljahre 1992–1994Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel System

The hot plate weld which attaches the vapour vent valve to the top of the plastic fuel tank may partially fracture, allowing vapour or fuel to escape from the top of the tank through the fracture. In the presence of an ignition source a fire could result. Correction: Tanks will be removed and inspected for the weld integrity of the vapour vent valve carrier. Tanks with inadequate welds will be replaced.

Transport Canada25. Feb. 19911991030Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel System

The corner of the front heat shield may contact the upper front corner of the plastic fuel tank. This could damage the tank and allow fuel or fuel vapour to escape. In the presence of an ignition source, a fire could occur. Correction: Heat shield will be relocated and fuel tank will be inspected. Fuel tanks damaged by heat shield will be replaced.

Transport Canada25. Feb. 19911991028Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel system, gasoline:Storage:Tank assembly

The hot plate weld which attaches the vapor vent valve carrier to the top of the plastic fuel tank may partially fracture, allowing vapor of fuel to escape from the top of the tank.

NHTSA · USA11. Feb. 199191V025000Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufKritischMotorNA

Fuel system, gasoline:Storage:Tank assembly

The front heat shield may contact the front of the plastic fuel tank, causing cuts or other damage to the extent of penetration.

NHTSA · USA11. Feb. 199191V024000Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelGetriebeKR

동력전달장치

파워 트레인 컨트롤 모듈 리프로그래밍 업데이트 시 과정의 일부인 학습 명령이 이루어지지 않을 수 있으며 이 조건으로 인해 차량의 작동에는 이상이 없으나 OBD시스템이 정상적으로 작동하지 않을 수 있는 결함

MOLIT · Südkorea21. Juli 20141417Im Original (Koreanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelFahrwerkJP

タイヤ

長期間(装着から3年以上を経過している場合)使用されたタイヤにおいて、引き続き使 用を続けると、トレッド部が剥離することがあり、最悪の場合、トレッド部又はトレッド 部とその内側のアウタースチールベルトが剥がれ落ち、走行安定性が損なわれるおそれが ある。

MLIT · Japan19. Okt. 20012201930Modelljahre 1994Im Original (Japanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelFahrwerkNA

Other

Certain vehicles, from Ontario to Newfoundland, could experience a corrosion related failure of the spare tire winch cable. If the cable breaks while the vehicle is being driven, the spare tire could drop down, potentially creating a roadway obstacle. Correction: Owners are to inspect the cable, and if corrosion or broken wire strands are present the vehicle is to be taken to a dealer for replacement of the winch assembly. Program ends September 30, 2003.

Transport Canada16. Juli 20012001193Modelljahre 1991–1994Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelFahrwerkJP

緩衝アーム/ロッド

前輪緩衝装置において、スタビライザーバーとロアアームを連結するリンクの強度が不足 しているため、そのままの状態で使用を続けると、当該リンクが折損し、最悪の場合、ス タビライザーバーがロアアームから外れ、走行安定性が損なわれるおそれがある。

MLIT · Japan5. Juli 20011208831Modelljahre 1994Im Original (Japanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelMotorKR

기타장치

점화케이블 불량, 부품교환

MOLIT · Südkorea5. Juni 1998510Im Original (Koreanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelElektrikKR

기타장치

연료게이지의 계기 지시오차 발생, 수리

MOLIT · Südkorea5. Juni 1998512Im Original (Koreanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelKarosserieNA

Structure:Body:Roof and pillars

Vehicle description: Multi-purpose passenger vehicles equipped with factory installed sunroof. The sunroof glass panel assembly can separate while the vehicle is moving due to incorrect hinge engagement. This was caused by improper sunroof installation of the glass panel.

NHTSA · USA18. Dez. 199797V235001Modelljahre 1991–1993Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Betriebsbremsen, hydraulisch: Servounterstützung: Hydraulisch

Die Stehbolzen, mit denen der Hauptbremszylinder an der Unterdruck-Bremskraftverstärkereinheit befestigt ist, können nach längerem Betrieb in der Region Südkalifornien Spannungsrisskorrosion entwickeln.

NHTSA · USA5. Feb. 199696V024001Modelljahre 1991–1994Automatisch übersetzt · Original: EnglischDetails ansehen →
RückrufMittelKarosserieJP

ドア

後面扉を開けたときの支持棒を取り付けているブラケットの溶接に不適切なものがあり 、そのままの状態で使用を続けると、ブラケットが外れ、最悪の場合、後面扉が不用意に 降下するおそれがある。

MLIT · Japan14. Dez. 19952200950Modelljahre 1992–1994Im Original (Japanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelKarosserieNA

Structure

Defect: The hydraulic lift cylinders on these vehicles are attached to brackets that are welded to the liftgate. Under certain conditions, the bracket welds may fracture due to the brackets being inadvertently mislocated relative to the liftgate. There may be a potential for the liftgate bracket to gradually bend inward which might allow the lift cylinder ball stud to disengage. Correction: Reinforcement brackets will be installed.

Transport Canada30. Aug. 19951995155Modelljahre 1992–1993Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Brakes

Note: This recall affects vehicles with manual transmission. The parking brake control self-adjust pawl may skip over one or more teeth in the self-adjust ratchet during parking brake application, which could prevent the system from achieving full tension. This could result in parking brake ineffectiveness which would allow the vehicle to roll freely if it is not left in gear. Correction: A wedge will be installed which will serve to lock the parking brake self-adjust mechanism pawl into engagement with the ratchet.

Transport Canada17. Okt. 19941994157Modelljahre 1993–1994Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelBremsenNA

Parking brake:Conventional

The parking brake control self-adjust pawl does not line up properly with the self-adjust rachet causing the pawl to slip over one or more teeth in the rachet.

NHTSA · USA7. Sept. 199494V169001Modelljahre 1993–1994Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seats And Restraints

Seat belt buckles on these vehicles may experience conditions whereby the buckle may not unlatch when the release button is depressed or may not latch, or in some cases, may latch partially but not sufficiently to provide occupant restraint in the event of a collision. Note: Only end-release buckles on "rigid" mountings are susceptible to this malfunction. Correction: Factory installed end-release seat belt buckles will be replaced with redesigned buckles.

Transport Canada29. Sept. 19921992120Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
RückrufMittelInnenraumNA

Seat belts:Front:Buckle assembly

The rigid mounted safety belt buckles are defective in three ways. First, a fastened safety belt buckle will not unlatch when the release button is depressed. This results from interference between the buckle ejector finger and the buckle tongue window. The second defect is the safety belt buckle may not latch. The third possible defect is that the tongue may be retained by the buckle, but it may not be latched sufficiently to provide occupant protection.

NHTSA · USA17. Aug. 199292V113000Modelljahre 1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Ältere →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).