주행장치 기타
정속주행장치 속도조절해제스위치의 오일링에서 브레이크 오일이 누유 될 경우 누유된 오일이 제어장치에 스며들어 화재가 발생될 수 있는 결함이 발견됨
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Ford Windstar I erhalten
정속주행장치 속도조절해제스위치의 오일링에서 브레이크 오일이 누유 될 경우 누유된 오일이 제어장치에 스며들어 화재가 발생될 수 있는 결함이 발견됨
Ford ruft Fahrzeuge der Modelljahre 1995–2003 des Windstar, 2000–2003 des Excursion mit Dieselmotor, 1993–1997 und 1999–2003 des F-250 SD bis F-550 SD mit Dieselmotor, 1992–2003 des E-150 bis E-550, 1995–2002 des Explorer, 1997 und 2002 des Mercury Mountaineer, 1995–1997 und 2001–2003 des Ranger sowie 1994 des F53 zurück, die mit dem Texas-Instruments-Schalter zur Deaktivierung der Geschwindigkeitsregelung (SCDS) ausgestattet sind. Der SCDS kann intern undicht werden und dann überhitzen, qualmen oder abbrennen.
와이퍼가 작동하지 않거나 과부하로 화재 발생 우려, 뒷좌석용 에어컨 송풍기의 과열로 인해 화재발생 우려(03.9.22 완료)
와이퍼가 작동하지 않거나 과부하로 화재 발생, 뒷좌석용 에어컨 송풍기의 과열로 인해 화재발생 우려(03.9.22 완료)
Vehicle description: Minivans which were originally sold or currently registered in the following hot weather states: Alabama, arizona, arkansas, california (10 southern counties), florida, georgia, hawaii, louisiana, mississippi, nevada (clark county only), oklahoma, south carolina and texas, can develop cracks in the fuel tank in the forward strap area of the standard 20 gallon tank due to a combination of factors that are present in certain very hot areas of the country.
Vehicle description: Passenger vehicles equipped with ax4s automatic transaxles. The low/intermediate servo cover can separate from the transaxle while the vehicle is being driven. If this occurs, transmission fluid will leak contacting the catalytic converter.
The passenger side supplemental restraint system (air bag) may have a cracked inflator body. If the vehicle is involved in a deployment level crash, the passenger side air bag may not inflate properly which could result in reduced occupant protection. In addition, the igniter plug could separate from the inflator, which could result in the release of hot gases and could ignite flammable material or potentially cause personal injury. Correction: Vehicles will be inspected and a new passenger side air bag module will be installed if necessary.
The alternator output wire may not be tightly connected to the power distribution box. This could result in overheating of the connection due to high electrical resistance and a possible underhood fire. Correction: Distribution box connection will be inspected and tightened. Vehicles with visible damage to the plastic box housing will have the underhood harness that includes the power distribution box replaced.
A brace that runs from the instrument panel to the cowl may contact, and in some cases, abrade insulation on a wire harness which could result in an electrical short and a possible fire. Correction: A shield will be installed on the instrument panel to cowl brace and a piece of convolute material will be installed on one of the adjacent harnesses.
The wiring harness insulation can abrade on a brace that runs from the instrument panel to the cowl.
The alternator output wire was not connected tightly to the power distribution box.
Ford Motor Company (Ford) ruft bestimmte Fahrzeuge der Modelljahre 1998 bis 2003 des Windstar zurück, die vom 2. September 1997 bis zum 3. Juli 2003 gefertigt wurden. Die betroffenen Fahrzeuge wurden zuvor nachgerüstet, um die Hinterachse vor Rissbildung durch Korrosion zu schützen. Die Halterungen der Nachrüstung könnten jedoch falsch montiert worden sein. Die fehlerhaften Montagen können die Wirksamkeit der Reparaturmaßnahmen für die NHTSA-Rückrufe 10V-385, 12V-193 und 12V-195 einschränken.
Ford ruft bestimmte Fahrzeuge des Modelljahres 1998 bis 2003 der Baureihe Windstar zurück, die zwischen dem 1. September 1997 und dem 3. Juli 2003 gefertigt wurden und derzeit in Virginia zugelassen sind oder ursprünglich dort verkauft wurden. Im Laufe der Zeit kann Korrosion die Hinterachse schwächen, wodurch sie anfällig für Torsionsbelastung wird. Korrosion und Belastung können zu Rissen führen, die, sofern sie unentdeckt bleiben, anwachsen und einen vollständigen Bruch der Achse zur Folge haben können.
Ford is recalling certain model year 1998-2003 windstar vehicles manufactured from september 1, 1997, through july 3, 2003, registered in puerto rico. Due to increased stresses caused by high cycles of torsional loading, specific to this market, the rear axle can crack.
Ford is recalling certain model year 1998-2003 windstar vehicles manufactured from september 1, 1997 through february 28, 2003 and currently registered or originally sold in connecticut, delaware, district of columbia, illinois, indiana, iowa, kentucky, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin. After many years of vehicle service in these areas, corrosion can weaken the rear axle, making it susceptible to torsional stress. Corrosion and stress can lead to cracks which if undetected can propagate and result in a complete fracture of the axle.
On certain minivans originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, wisconsin, and the district of columbia. During assembly, some brake lines were installed in a twisted position, causing contact with the dash panel insulator above the catalytic converter. This contact could abrade the brake line corrosion protection, consequently, salt or water absorbed in the dash panel insulator would promote corrosion. This corrosion could ultimately lead to a leak in the brake line.
On certain minivans originally sold in or currently registered in the states of connecticut, delaware, illinois, indiana, iowa, maine, maryland, massachusetts, michigan, minnesota, missouri, new hampshire, new jersey, new york, ohio, pennsylvania, rhode island, vermont, west virginia, and wisconsin, and in the district of columbia. The front coil springs could fracture as a result of corrosion. Depending on the location of the fracture, a broken spring could move past the spring seat and contact a front tire.
Vehicle description: Mini vans, light pickup trucks, and sport utility vehicles. Off lease canadian vehicles equipped with daytime running lights which meet canadian requirements and not the photometric requirements of fmvss 108, "lamps, reflective devices, and associated equipment." according to ford, the vehicles were imported into the u.S. Erroneously.
Vehicle description: Minivans. The brake fluid master cylinder is recessed and oriented in the engine compartment so that the brake fluid warning statement embossed on both the top of the filler cap and the side of the reservoir body are not entirely visible by direct view. These vehicles may not fully comply with requirements of fmvss no. 135, "passenger car brake systems."
These vehicles may have had incorrect service replacement brake rotors installed which will cause an improper wheel to hub abutment condition to occur. With an incorrect rotor installed, the driver may experience wheel shudder on braking or shimmy at highway speeds. If the vehicle is not serviced this condition could eventually cause the wheel studs to break. Correction: Front rotors and brake pads will be replaced on affected vehicles.
Under certain conditions the bond between the inner and outer hood panels can begin to separate. Highway driving can cause air to enter between the inner and outer panels which can force the outer panel upward, and could result in total separation of the outer hood panel. This can result in a road hazard and a possible crash without prior warning. Correction: Vehicles will be inspected and those with evidence of bond separation will have the hood replaced. Where there is no evidence of bond separation, additional adhesive will be applied between the inner and outer hood panels.
Vehicle description: Passenger vehicles and mini vans. Tearing of the bond between the inner and outer hood panels during minor front end collisions can result in a gap at the leading edge of the hood. Air forced between the inner and outer panels can produce enough pressure to force the outer panel upward.
On certain vehicles, the rack and pinion steering gears may have damaged input shaft bearings. This condition could increase steering efforts, potentially affecting steering control. Correction: Dealers will replace the steering rack assembly.
Vehicle description: Passenger vehicles and mini-vans. The rack and pinion steering gears may have damaged input shaft bearings.
Note: Vehicles equipped with second row bench seats and integrated child seat (ics). All vehicles in this recall have been corrected. The headrest lockout mechanism may not engage and lock the headrests in the "down" position, as intended when the ics is deployed. Consequently, a vehicle occupant could move the headrest to the "up" position, and as a result a child in the ics would receive less than the intended protection in the child head area. Correction: Second row bench seats have been replaced with seats built with revised headrest lockout mechanisms.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).