Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
Some customers may experience the check engine light on with DTC P0126:00 (Thermostat stuck open) stored. This is due to improper PCM logic control. To eliminate the concern, the PCM control software has been modified. REPAIR PROCEDURE 1. Verify the customer concern. 2. Reprogram the ECU with the Mazda Modular Diagnostic System (M-MDS), using Mazda Diagnostic and Repair Software (MDARS). Refer to MDARS ECU Reprogramming Procedure. NOTE: Be sure to submit Diagnostic Information (ODR) data as it is a required item and will be checked during warranty claim submission. Instructions can be found under M-MDS -> MDARS (Uploading Diagnostic Information (ODR) Data). 3. Clear any other DTCs. 4. Verify the repair by starting the engine (READY ON) and confirming there is no CHECK ENGINE light ON or abnormal warning lights present.
Connected vehicle remote functions inoperative and/or engine no start due to low battery voltage. Some customers may experience the following symptoms: Connected Vehicle Remote Functions inoperative after SSPC6 repair. Connected Vehicle Remote Functions inoperative on vehicles built March 20, 2021 and later.
Connected vehicle remote functions inoperative and/or engine no start due to low battery voltage. Some customers may experience the following symptoms: Connected Vehicle Remote Functions inoperative after SSPC6 repair. Connected Vehicle Remote Functions inoperative on vehicles built July 1, 2021 and later.
Connected vehicle remote functions inoperative and/or engine no start due to low battery voltage. Some customers may experience the following symptoms: Connected Vehicle Remote Functions inoperative after SSPC6 repair. Connected Vehicle Remote Functions inoperative on vehicles built July 1, 2021 and later.
Some customers may experience the following symptoms: Connected Vehicle Remote Functions inoperative after SSPC6 repair. Connected Vehicle Remote Functions inoperative on vehicles built July 1, 2021 and later. Engine no start due to low battery voltage.
Some customers may experience a no start because the battery is discharged after the vehicle is parked for more than 8 hours. This may be caused by one or more of the following, resulting in excessive parasitic draw (dark current) on the battery.
Some customers may experience an engine no start due to low battery voltage on 2019-2020 Mazda3 and 2020 CX30. Inform the customer that Mazda is actively investigating this issue and apologizes for any inconvenience. Mazda would like to request both dealer and customer support to expedite a repair. Customers having this concern should be instructed to contact Mazda Roadside Assistance and have their vehicle inspected by a local dealer.
MSP57 - 2020 CX-30 WIRELESS CHARGING PAD LED STAYS ON: Concern Outline: The Wireless Charging Pad power indicator LED light does not shut off when the vehicle ignition is cycled off and the accessory remains functional in all conditions which may drain power from the battery due to an incorrect installation procedure. Only vehicles with the accessory installed at Port Salamanca are affected. Action Required: The Wireless Charging Pad function will be inspected for proper operation. If found to remain functional with the vehicle turned off, the Wireless Charging Pad must be replaced and installed correctly with the current kit available by placing an order in eMDCS. There are 286 vehicles in dealer inventory that must be repaired prior to delivery. Vehicles in Dealer Inventory will be posted to MGSS and updated weekly. Vehicles delivered with this MSP57 not repaired are subject to a debit of the New Car Ready claim.
Some customers may experience an engine no start due to low battery voltage on 2019-2020 Mazda3 and 2020 CX-30. Inform the customer that Mazda is actively investigating this issue and apologizes for any inconvenience. Mazda would like to request both dealer and customer support to expedite a repair. Customers having this concern should be instructed to contact Mazda Roadside Assistance and have their vehicle inspected by a local dealer.
If you encounter any type of electrical concern (e.g, dead battery, engine no start, DTC(s) stored...), interview the customer before proceeding with normal Workshop Manual diagnosis. Aftermarket devices may be the cause of the electrical concern. Ask the customer if any aftermarket devices have been installed. Below are a couple of examples of unusual electrical concerns caused by aftermarket devices.
Some customers may experience the master warning light turning on and a lack of power with DTC P2BF6:00 (Exhaust shutter valve position sensor circuit low input (1DC)) stored in memory. This is caused by improper logic written in the PCM for the exhaust shutter valve position sensor.
Some customers may experience an engine no start due to low battery voltage on 2019-2020 Mazda3 and 2020 CX30. Inform the customer that Mazda is actively investigating this issue and apologizes for any inconvenience. Mazda would like to request both dealer and customer support to expedite a repair. Customers having this concern should be instructed to contact Mazda Roadside Assistance and have their vehicle inspected by a local dealer.
Some customers may experience an engine no start due to low battery voltage on 2019-2020 Mazda3 and 2020 CX30. Inform the customer that Mazda is actively investigating this issue and apologizes for any inconvenience. Mazda would like to request both dealer and customer support to expedite a repair. Customers having this concern should be instructed to contact Mazda Roadside Assistance and have their vehicle inspected by a local dealer.
Some customers may experience the master warning light and/or the "In-Vehicle Network Malfunction" warning message in the instrument cluster on with DTC B119F:01, B119F:13 and/or B119F:2B stored when the vehicle position cannot be displayed correctly. (TCU - Tel antenna No. 1 malfunction) (TCU - TEL antenna No.1 circuit malfunction) (CMU - GPS antenna signal circuit malfunction). This concern may be caused by incoming noise disturbing the reception of GPS signals, resulting in the wrong vehicle location and the DTC stored. To eliminate this concern, the GPS antenna has been modified.
SiriusXM Traffic Plus and Travel Link are displayed with Mazda in-vehicle factory navigation systems. Both of these services provide information in the U.S. & Canada. NOTE: SiriusXM Traffic Plus and Travel Link subscription is free of charge for 3 years only if equipped with factory installed navigation system. NOTE: 2019-2020 Mazda3 and 2020 CX-30 are not equipped with factory installed navigation system,however, it is available as a dealer installed accessory. SiriusXM Traffic Plus and Travel Link are available on the 2019-2020 Mazda3 and 2020 CX-30 Preferred Package and above, as a paid subscription. Traffic Plus feature requires in-vehicle navigation SD card. SiriusXM Satellite Radio trial subscription is free of charge for 3 months.
If you encounter a vehicle with the oil pressure warning light on or a check engine light on with DTC P0524 and/or P055F, and no driveability concerns or mechanical noises, perform the following inspection:
WIRELESS CHARGING PAD INSTALLATION INSTRUCTIONS CORRECTION: Section 6 of the Wireless Charging Pad instructions call for the use of an "ultrasonic cutter" to cut a rectangular hole for the harness to pass through and to serve as an access point to pop the wireless charger base out should service be required. Since an "ultrasonic cutter" is not readily available, follow the Repair Procedure to cut the rectangular hole.
Some customers may complain about: Intermittent engine no start Instrument cluster red security indicator light ON Engine Start/Start Button Amber indicator light flashing Battery discharge Electrical relay buzzing noise DTC B13D3:94 (Communication error with remote transmitter) stored.This may be caused by: A key in a purse near a cell phone. The cell phone radio waves may interrupt the immobilizer system. An aftermarket cell phone charger. The charger may produce electrical noise that interrupts the immobilizer system. An aftermarket GPS tracker. Some aftermarket devices that are wired to the vehicless wiring harness may create unusual electrical symptoms.
FSC dynamic aiming (mid-drive aiming) may not complete if the vehicle is driven on a road as described below: The road lane markings are covered by snow and are not visible. There are no road lane markings on the road surface. The road is winding and the vehicle cannot drive straight (300 m / 984 ft or more turning radius is required). FSC dynamic aiming is completed if the following conditions are met: 1. "Forward Sensing Camera Calibration Mode" message (1) on instrument cluster MID disappears. 2.The i-ACTIVSENSE warning light (2) turns off. 3. Steps 1 and 2 are completed within 20 minutes from start of aiming.
Subject: Notification of Dealer Re-Work (DRW59) 2026MY CX-30 and 2026MY Mazda3 - Check Engine Light On With DTC P0126:00 Dear Mazda Dealer Colleagues, Mazda Motor Corporation has decided to conduct a Dealer Re-Work on certain 2026MY CX-30 and Mazda3 vehicles. Concern Outline: On certain subject vehicles, the check engine light may illuminate with DTC P0126:00 (Thermostat stuck open) stored due to improper PCM control logic. Repair Outline: Reprogram the PCM with the Mazda Modular Diagnostic System (M-MDS), using Mazda Diagnostic and Repair Software (MDARS) by following TSB 01-006/26 repair instructions. ACTION ITEM - STOP DELIVERY: All affected vehicles in inventory can be sold but not delivered until repaired. There are approximately 17,942 new vehicles in dealer stock and/or in transit to dealers. All affected dealer inventory types with this DRW must be repaired prior to delivery. The number of affected units at your dealership can be seen in Inventory & Sales 2.0 in eMDCS and a VIN list (via an internal MNAO campaign reporting) will also be provided to your District Service Manager by 5pm (Pacific Time) on the date this dealer email is sent. Owner Notification: There is no Owner Notification with this or any Dealer Re-Work. PARTS INFORMATION: There are no parts required for this repair.
NOTE: This service information only applies to vehicles with PYUKD engine and EGR. DESCRIPTION DTC P0402 EGR malfunctions may be falsely detected due to an internal malfunction of the MAP sensor. REPAIR PROCEDURE 1. Using MDARS, verify DTC P0402 is set in current or past history.
Mazda Service Program (MSP61) - 2024 CX-30 and 2024 Mazda3, equipped with 6 speakers Connectivity Master Unit (CMU) software concern When using a Bluetooth connected smartphone and talking with handsfree function on a vehicle with 6 speakers, the person on the other end of the line may have difficulty hearing the drivers voice. OUTLINE OF REPAIR: Reprogram the CMU software using a USB memory stick. COVERAGE LIMITATION: Vehicles under 3 year/36,000 mile warranty : All repairs in MSP6 1 will be covered under Mazda's New Vehicle Limited Warranty. Vehicles outside the 3 year/36,000 mile warranty : Please submit to Warranty pre - authorization. The repair will be reviewed on a case by case basis. ALL RETAIL , CPO, USED OR UNSOLD IN-STOCK VEHICLES: When an applicable retailed vehicle is brought into the dealer for any type of repair or scheduled maintenance, review the Warranty Vehicle Inquiry page in eMDCS to check the status of MSP6 1. If the status is "OPEN" for MSP6 1, repair the vehicle according to the procedures contained in this service bulletin.
Mazda Service Program (MSP61) - 2024 CX-30 and 2024 Mazda3, equipped with 6 speakers Connectivity Master Unit (CMU) software concern When using a Bluetooth connected smartphone and talking with handsfree function on a vehicle with 6 speakers, the person on the other end of the line may have difficulty hearing the drivers voice. OUTLINE OF REPAIR: Reprogram the CMU software using a USB memory stick. COVERAGE LIMITATION: Vehicles under 3 year/36,000 mile warranty : All repairs in MSP6 1 will be covered under Mazda's New Vehicle Limited Warranty. Vehicles outside the 3 year/36,000 mile warranty : Please submit to Warranty pre - authorization. The repair will be reviewed on a case by case basis. ALL RETAIL , CPO, USED OR UNSOLD IN-STOCK VEHICLES: When an applicable retailed vehicle is brought into the dealer for any type of repair or scheduled maintenance, review the Warranty Vehicle Inquiry page in eMDCS to check the status of MSP6 1. If the status is "OPEN" for MSP6 1, repair the vehicle according to the procedures contained in this service bulletin.
Some vehicles may exhibit the check engine light ON with DTC P2112 (Throttle valve actuator control motor current system: Characteristic malfunction). The DTC is stored when the engine is started at sub-zero ambient temperatures. To eliminate this concern, the PCM logic has been modified. REPAIR PROCEDURE Reprogram the PCM with the Mazda Modular Diagnostic System (M-MDS), using Mazda Diagnostic and Repair Software (MDARS). Refer to MDARS ECU Reprogramming Procedure.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).