Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Mazda CX-50

2022– · 1 generationen · 7 dokumentierte Mängel · 1 Märkte
Generationen
Alle GenerationenCX-502022–77271

Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.

SchweregradAlleMittelGering
Modelljahr
MarktAlleNA
BulletinMittelMotorNA

Bulletin

Some customers may experience a hybrid system failure message appearing on the meter and the engine does not start, along with other numerous DTCs.

NHTSA · Herstellerbulletin11019993Modelljahre 2025Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

Some customers may experience the audio sound pausing when the engine restarts after i-stop operation under the following situations. The symptoms are caused by an improper part installation in the audio amplifier. A voltage drop error detection of the power source may be too sensitive.

NHTSA · Herstellerbulletin11011135Modelljahre 2023Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

Some customer's might state that they notice fluid or oil leaking/dripping on the ground when the vehicle is parked. For this concern, inspect the vehicle for any trace of a fluid or oil leak and use the following examples as a guide to determine if it is severe enough to require a repair, or just to clean the area and monitor it at the next service.

NHTSA · Herstellerbulletin11007010Modelljahre 2025Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinMittelMotorNA

Bulletin

Customers may report excess wind noise from the vehicle and that noise may be coming from the crossbars. As noted in the crossbar instructions, the crossbars should be removed when not in use to reduce fuel consumption from the increased drag and to reduce wind noise. Let the customer know that the instructions show how to install, remove, and adjust the crossbars.

NHTSA · Herstellerbulletin10213143Modelljahre 2023Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Some customers may complain about a rattle noise coming from the engine compartment when accelerating or idling. This may be caused by play at the turbocharger wastegate pivot arm creating a rattle-type noise. To eliminate this concern, a wave washer has been added.

NHTSA · Herstellerbulletin11012338Modelljahre 2024Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · Herstellerbulletin10235702Modelljahre 2023Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

When servicing SKYACTIV engine vehicles requiring to replace the Oil Galley Plug and Crush Washer, order the required part numbers below. These parts are not listed in GEPC and were previously listed as "non-serviceable" in the cylinder block diagram.

NHTSA · Herstellerbulletin10230865Modelljahre 2023Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines below to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.

NHTSA · Herstellerbulletin10226814Modelljahre 2023Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

Some customers may complain of signs of oil on the struts or shock absorbers. In most cases the oil that is present is normal, and a result of the oil that remains on the shaft during the normal sweeping process of the shaft seal. Follow the inspection guidelines below to determine if the condition is a result of the normal sweeping process or a failure of the shaft seal.

NHTSA · Herstellerbulletin10213185Modelljahre 2023Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
BulletinGeringMotorNA

Bulletin

A tapping/rattling noise may be noticed from the valve train area. This operating condition can occur on new vehicles which have been delivered to Mazda dealers (due to loading and unloading from transport trucks or customers moving their vehicles in and out of their garages to wash the vehicle, etc.). This condition may also occur if the engine is not allowed to warm up after multiple cold starts.

NHTSA · Herstellerbulletin10210884Modelljahre 2023Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).