Bulletin
Steering wheel slightly off center. *tw
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Mazda MX-3 erhalten
Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
Steering wheel slightly off center. *tw
Speedometer replacement procedure
In accordance with Federal regulations, follow the procedure listed below when replacing a speedometer. NOTE: Tampering with a motor vehicle odometer is strictly prohibited by Federal, and State laws. It is the dealers responsibility to comply with Federal, State, and local laws concerning odometer and related documentation requirements when providing a repair or replacement. Mazda vehicles are manufactured with tamper-proof speedometers. When a speedometer is replaced, the new speedometer will read zero (0) miles. This procedure is extremely important to accurately represent actual vehicle mileage. Prior to speedometer removal, complete the information required on the Speedometer Replacement Label. Labels can only be ordered through Mazda eStore. In an effort to achieve a higher level of Customer Experience and retain the value of Mazdas vehicles, MNAO Warranty Operations is allowing all Mazda dealers to utilize a third party, SPECMO Enterprises, Inc., for Instrument Panel Cluster (IPC) odometer setting service. With the use of SPECMOs services, it is possible that the odometer will be set between 10 to 31 miles over the odometer mileage at the time of replacement for both warranty and customer pay repairs. Please make sure that the customer is aware that there may be a slight variance to the odometer, in which case the customer may have to accept the slightly higher mileage. Since odometer setting service is not part of the warranty repair, it is not warrantable nor required, but optional. However, Mazda Warranty policy provides after- warranty assistance (AWA) or DSA that can be utilized to cover this service expense.
Subject regarding paint damage - iron particles / industrial fallout / acid rain. *tt
Experienceing a metallic tapping noise heard from the right ( rear ) cylinder head exhaust cam area. *yc
Subject pertaining to tach needle which is stuck on wrong side of stopper pin. *yc
Complaints of tach needle stuck on wrong side of stopper pin. *yc
Subject pertaining to mtx overhaul information. *yc
Descriptions of typical engine noises. *yc
Tach needle stuck on wrong side of stopper pin. *tw
Unknown
Unknown
Unknown
Engine idle vibration in d range. *tw
Clutch squealing noise. *tw
Frozen door/hatch lock cylinders. *tw
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0).