Frei lesbar · kostenloses Konto zum MitmachenNachfolger von Anticars (2000)

Nissan Juke

2010– · 3 generationen · 21 dokumentierte Mängel · 5 Märkte
Generationen
Modelljahr
Juke I · 2010–2019
RückrufKritischElektrikNA

Electrical

On certain vehicles, due to a manufacturing defect the start/stop button could stick inside of its housing. If this occurs, vibration could cause the electrical components inside the button to contact repeatedly in quick succession and initiate the emergency engine shut off procedure while the vehicle is in motion. This could result in increased steering and braking effort, a loss of motive power and would disable the supplemental restraint systems (SRS), increasing the risk of a crash causing injury and/or damage to property. Correction: Dealers will inspect and repair defective start/stop switch as necessary.

Transport Canada25. Juni 20152015282Modelljahre 2013–2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Juke I · 2010–2019
RückrufKritischElektrikEU

null The fuel rail pressure sensor of some vehicles may be tightened insufficiently to the fuel rail of…

null The fuel rail pressure sensor of some vehicles may be tightened insufficiently to the fuel rail of the engine and it may loosen gradually due to heat and vibration of the engine. If left undetected and the vehicle continues to be driven in this condition, in an extreme case, fuel leakage may occur between the fuel rail pressure sensor and the fuel rail.

Safety Gate · EU5. Dez. 2014A12/1975/14Modelljahre 2012–2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Juke I · 2010–2019
RückrufKritischElektrikJP

コモンレール

エンジンの燃料供給レールに取り付けている燃料圧力センサの締付けが不充分なため、エンジンの振動等により締付けが緩むものがある。そのため、燃料圧力センサの取付け部のねじを伝って燃料が漏れるおそれがある。

MLIT · Japan23. Feb. 20121128970Modelljahre 2010–2011Im Original (Japanisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Juke I · 2010–2019
RückrufMittelElektrikUK

Rear oxygen sensor may fail

If an electrical short occurs in the supply to the rear oxygen sensor the senor will fail but the driver will not see an immediate warning. A MIL warning may display after continued driving depending on driving/vehicle characteristics.

DVSA · Vereinigtes Königreich25. Juli 2016R/2016/157Modelljahre 2014–2016Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Juke I · 2010–2019
RückrufMittelElektrikEU

null Der Sensor des hinteren Lambdasonde kann ausfallen, ohne dass ein Diagnosefehlercode (DTC) gesetzt wird in…

Der Sensor des hinteren Lambdasensors kann ausfallen und setzt im Falle einer unzulässigen Abgaszusammensetzung keinen Diagnosefehlercode (DTC). In solchen Fällen wird der Benutzer nicht über die Motorkontrollleuchte (MIL) im Armaturenbrett gewarnt.

Safety Gate · EU13. Juli 2016A12/0879/16Modelljahre 2014–2016Automatisch übersetzt · Original: EnglischDetails ansehen →
Juke I · 2010–2019
RückrufMittelElektrikEU

null An incorrect calibration setting in the Engine Control Module (ECM) software may cause miscalculation…

null An incorrect calibration setting in the Engine Control Module (ECM) software may cause miscalculation of sulfur oxide (SOx) levels captured within the Lean NOx Trap (LNT) component of the exhaust’s Diesel Particulate Filter (DPF). This miscalculation could, with extended operation under certain driving conditions, affect the purge process applied to remove SOx particles from the DPF-LNT. In this condition, the capacity of the DPF-LNT may become saturated and, as a result, the nitrogen oxide (NOx) emissions from the vehicle could exceed the permitted level.

Safety Gate · EU26. Feb. 2016A12/0267/16Modelljahre 2015Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Juke I · 2010–2019
RückrufMittelElektrikNA

Electrical system:Ignition:Switch

Nissan North America, Inc. (Nissan) is recalling certain model year 2014 Versa Sedan vehicles manufactured July 16, 2013, to January 29, 2014, 2013-2014 Cube vehicles manufactured July 3, 2013, to October 21, 2013, and 2013-2014 Juke vehicles manufactured July 3, 2013, to October 22, 2013. When exposed to hot temperatures, the affected vehicles have an engine start/stop button that may stick inside the button housing.

NHTSA · USA1. Juli 201515V418000Modelljahre 2013–2014Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Juke I · 2010–2019
RückrufMittelElektrikJP

過給機

(1)過給気導入ダクトにおいて、過給圧センサブラケット溶着部の加工が不適切なため、当該ブラケットの溶着強度が不足したものがある。そのため、そのままの状態で使用を続けると、過給圧センサブラケットが剥離して過給圧が正しく測定されず、警告灯が点灯するおそれがあり、最悪の場合、走行中にエンストし再始動できなくなるおそれがある。

MLIT · Japan8. Dez. 20111128621Modelljahre 2010–2011Im Original (Japanisch) angezeigt · Übersetzung ausstehendDetails ansehen →

Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).