Diese Akte sammelt die bekannten Mängel des Nissan Murano IV, verfasst und belegt von der Community. Lesen ist frei; mit einem kostenlosen Konto kannst du beitragen. Ein Mangel erhält das Siegel, sobald genug angesehene Mitwirkende ihn bestätigt haben.
Schwerwiegendste Mängel
Für diese Auswahl ist noch kein Mangel dokumentiert.
RückrufGeringGetriebeNA
Problem: Bei bestimmten Fahrzeugen könnte ein Softwareproblem dazu führen, dass das Display des Infotainmentsystems beim Starten des Fahrzeugs schwarz bleibt. Dadurch wird das Bild der Rückfahrkamera nicht angezeigt, wenn das Getriebe in den Rückwärtsgang geschaltet wird.
Hinweis: Dieser Rückruf betrifft nur bestimmte Ausstattungsvarianten.
Sicherheitsrisiko: Ein nicht angezeigtes Bild der Rückfahrkamera kann die Fähigkeit des Fahrers beeinträchtigen, beim Rückwärtsfahren den Bereich hinter dem Fahrzeug zu sehen. Dadurch kann das Unfallrisiko steigen.
Korrekturmaßnahmen: Das Unternehmen wird die Halter per Post benachrichtigen und ihnen empfehlen, ihr Fahrzeug zu einem Händler zu bringen, um die Software des Infotainmentsystems aktualisieren zu lassen.
RückrufGeringElektrikNA
Nissan North America, Inc. (Nissan) is recalling certain 2025 Murano, 2025-2026 Armada, and Infiniti QX80 vehicles. A software error may occur in the In-Vehicle Infotainment (IVI) system at vehicle startup, resulting in the rearview camera image not displaying when the vehicle is shifted into reverse. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 111, "Rear Visibility."
RückrufMittelBremsenNA
Issue: On certain vehicles, the front brake calipers may not have been manufactured correctly. As a result, the caliper(s) could crack and cause reduced braking. Safety Risk: Reduced braking could cause extended stopping distances and increase the risk of a crash. Corrective Actions: Nissan will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace front brake caliper(s).
BulletinGeringSonstigesNA
BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH This bulletin is no longer active. Please discard previous versions of NTB26-047.
BulletinGeringElektrikNA
BSW WARNING WITH C1E00-47 AND/OR C1E80-47 STORED IN SIDE RADAR REAR LH AND/OR SIDE RADAR REAR RH IF YOU CONFIRM The BSW warning was displayed, and one or more of the following DTCs are stored as Current: C1E00-47 for "Control Unit" stored in the Side radar "Rear Left" C1E80-47 for "Control Unit" stored in the Side radar "Rear Right" ACTION 1. Confirm the current part number of the Side Radar (Rear LH) and/or Side Radar (Rear RH) that corresponds to the stored DTC(s). 2. Based on the DTCs stored, individually reprogram each applicable Side Radar (Rear LH) and/or Side Radar (Rear RH).
BulletinMittelFahrwerkNA
ENGINE NO START WITH KEY SYSTEM ERROR AND DTC B2C20-24 STORED IN THE BCM IF YOU CONFIRM The customer states the engine will not start and Key System Error warning is displaying in the Information Display (Combination Meter) (Figure 1), AND DTC B2C20-24 for "STARTER CONTROL RELAY" is stored in the BCM. Figure 1 HINT: This DTC and warning message (Figure 1) may occur if the customer does not place the vehicle in Park Gear according to the Owners Manual for shifter operation. ACTION 1. Confirm the current ECM part number. 2. Confirm the current TCM part number. 3. Reprogram the ECM, and then the TCM, if applicable. 4. Erase the DTCs. IMPORTANT: The purpose of ACTION (above) is to give you a quick idea of the work you will be performing. You MUST closely follow the entire SERVICE PROCEDURE as it contains information that is essential to successfully completing this repair.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0).