DEFECT: THE (Takata) ABS PLASTIC FRONT SEAT BELT RELEASE BUTTONS ON THESE VEHICLES MAY BREAK ALLOWING PLASTIC PIECES TO FALL INTO THE BUCKLE ASSEMBLY. IF THIS SHOULD HAPPEN, A NO LATCH, FALSE LATCH OR FAILURE TO UNLATCH CONDITION COULD OCCUR CREATING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH OR SUDDEN STOP. CORRECTION: FRONT SEAT BELT BUCKLES WILL BE REPAIRED OR REPLACED AS NECESSARY.
Transport Canada5. Juni 19951995107Modelljahre 1987–1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Insufficient clearance between the relocated alternator wiring and the solenoid hose alternator wiring stay bracket can cause wire chaffing and an electrical short.
NHTSA · USA9. März 198888V029000Modelljahre 1988Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The front safety belt buckle release buttons can break. These red plastic release buttons are marked "press." if a button breaks, pieces can fall into the buckle assembly causing the buckle to operate improperly.
NHTSA · USA24. Mai 199595V103006Modelljahre 1987–1991Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Certain vehicles do not comply with CMVSS 108 - Lighting. The resinous reflex reflectors of the front parking/side marker lamps do not meet the photometric requirements of the Standard. Correction: Front parking/side marker lamps will be replaced on affected vehicles.
Transport Canada12. März 19911991043Modelljahre 1989–1990Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Due to the design of the transmission case dipstick and the fluid level checking method, there may be insufficient lubrication of the 4 wheel drive extension housing bearing.
On vehicles with 5 speed transmission and 4wd the design of the transmission case dipstick and the fluid level checking method described in the owner's manual may result in insufficient lubrication of the 4wd extension bearing. This could lead to bearing seizure and possible rear wheel lock-up which could in turn lead to loss of vehicle control and a crash without prior warning. Correction: Vehicles will be inspected and the transmission case will be filled to the proper fluid level. A modified dipstick will be installed and an insert for the owner's manual describing the correct fluid level checking procedure will be provided.
Transport Canada8. März 19891989031Modelljahre 1988–1989Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).