Im Kombiinstrument kann es aufgrund einer ungeeigneten Schaltungsauslegung zu einem Kurzschluss im Netzteil kommen, wenn der Fahrzeuginnenraum längere Zeit feuchter Luft ausgesetzt ist und sich auf der Instrumentenplatine Kondenswasser bildet. Dadurch kann die Instrumentenplatine Rauch entwickeln und im schlimmsten Fall ein Brand entstehen.
Subaru of America, Inc. (Subaru) ruft bestimmte Forester-Fahrzeuge von 2009-2013, 2008-2011 Impreza-Fahrzeuge, 2008-2014 WRX-Fahrzeuge, 2005-2014 Legacy-Fahrzeuge, 2005-2014 Outback-Fahrzeuge und Tribeca-Fahrzeuge von 2006-2008 mit einem mechanischen Schlüsselzünder als Ersatzteil zurück. Die Kugelfeder im Schalter kann brechen und so die Festigkeit des Zündschalters verringern. Falls dies passiert, könnten das Gewicht am Schlüsselring und bestimmte Straßenverhältnisse dazu führen, dass der Zündschalter aus der Betriebsposition in die Zubehörposition wechselt und der Motor abgeschaltet wird.
Subaru of America, Inc. (Subaru) is recalling certain model year 2007-2009 model year Legacy and Outback vehicles, 2008-2014 Impreza vehicles and 2009-2013 Forester vehicles, all equipped with turbo-charged engines. The relay that controls the secondary air injection pump may fail, causing the pump to continuously operate and overheat.
Subaru is recalling certain model year 2012 Outback and Legacy vehicles manufactured from April 6, 2011, through May 12, 2011. Components inside the wiper motor bottom cover may overheat.
NHTSA · USA5. März 201313V078000Modelljahre 2012Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Subaru is recalling certain model year 2010 and 2011 Legacy and Outback vehicles, certain model year 2006 through 2012 Tribeca vehicles sold before January 2012, and certain model year 2009 through 2012 Forester vehicles sold before January 2012. Up to 78,650 of these vehicles may have been equipped with accessory puddle lights that, when illuminated, brighten the area under the doors of the vehicle. A short circuit can develop when either the puddle light or connector are exposed to an electrolytic moisture source (such as road spray that has road salt in it) and it penetrates the circuit board of the puddle light or the pins of the puddle light connector(s).
Im Datenkommunikationsmodul, einem Bestandteil des Telematiksystems, führt ein unzureichendes Steuerungsprogramm dazu, dass die Kommunikationsfunktion nach Ablauf einer bestimmten Zeit nach der Fahrzeugherstellung ausfällt. Dadurch entspricht das Fahrzeug nicht den Anforderungen des § 43 Abs. 8 der Straßenverkehrs-Zulassungs-Ordnung (STVZO) bzw. der Sicherheitsstandards (Anforderungen an automatische Notrufeinrichtungen bei Unfällen).
Bei den Kabelbaumsteckern für die elektrische Feststellbremse kann es aufgrund ungeeigneter Auswahl des Kunststoffmaterials durch Einwirkung von Streusalz und ähnlichen Mitteln zu Rissen im Stecker kommen. Dadurch können sich die Kabelbaumstecker durch Fahrzeugvibrationen lösen, die Warnleuchte aufleuchten und die elektrische Feststellbremse nicht betätigt werden oder sich nicht lösen lassen.
Bei dem im Abgasrückführungssystem (AGR) verbauten AGR-Drucksensor bestand eine unzureichende Beständigkeit gegenüber Abgasen. Dadurch kann es durch Korrosion infolge der Abgase zu einer Fehlfunktion des Sensorsignals kommen, die zum Aufleuchten der Warnleuchte und zu Beschleunigungsmängeln führen kann. Im schlimmsten Fall besteht die Gefahr, dass der Motor nicht mehr gestartet werden kann.
Der Stecker des Kraftstoffpumpenkabelbaums kann überhitzen und schmelzen, wodurch die Kraftstoffpumpe ausfallen kann. Infolgedessen geht der Motor aus oder lässt sich nicht starten, was das Unfallrisiko erhöht.
Subaru of America, Inc. (Subaru) is recalling certain 2018 Subaru Legacy and Outback vehicles. Due to a software error, the low fuel warning light may not illuminate at the intended remaining fuel level and the miles-to-empty display may incorrectly indicate a positive number despite the tank being empty.
Certain vehicles do not comply with the marking requirements of CMVSS 108 - Lighting System and Retroreflective Devices. The High/Low beam headlamp on these vehicles does not bear a "DOT" marking which is required by the standard. Correction: All High/Low beam headlamp bulbs installed since February 8, 2000 have the correct marking. Since the subject bulbs meets or exceed the performance and design requirements of the standard, and the missing marking will not cause a person to replace, fit or use the bulb in a manner for which they are not intended, no further action will be taken.
Transport Canada30. März 20012001070Modelljahre 2000Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
On certain vehicles, the headlamp assemblies may not comply with the marking requirements of CMVSS 108 - Lighting System and Retroreflective Devices. The bulb center mark on the lens has been interchanged between 2-bulb headlamps and 4-bulb headlamps. Correction: No corrective action will be taken due to the inconsequence to vehicle safety. The manufacturing process has been remedied to assure correction of the non-compliance on vehicles manufactured since January 30, 2000.
Transport Canada31. März 20002000087Modelljahre 2000Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Certain vehicles do not comply with Cthe requirements of CMVSS 108 - Lighting System and Retroreflective Devices. The H1 low-beam headlamp bulbs do not bear a "DOT" marking as required by the standard. Correction: Since these bulbs comply with all performance and design requirements of the standard, no corrective action will be taken.
Transport Canada17. März 20002000068Modelljahre 2000Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
The hazard warning flasher button can bind in the housing causing continued operation of the hazard warning lamps, or their being turned off but the turn signals becoming inoperable. Correction: Dealers will install a modified hazard warning switch.
Transport Canada18. Nov. 19971997200Modelljahre 1997Im Original (Englisch) angezeigt · Übersetzung ausstehendDetails ansehen →
Vehicle description: Passenger vehicles. Insufficient clearance within the hazard warning light switch housing can cause a binding between the actuating button and the housing.
Subaru of America, Inc. (Subaru) is recalling certain 2020 Legacy and Outback vehicles equipped with "high" grade and "mid" grade multimedia navigation. The August 2020 over-the-air software update may have timed out without completing the installation, corrupting the data, and causing the rearview display to shutoff intermittently. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 111, "Rear Visibility."
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).