Bulletin
Certain Model S and Model X vehicles were equipped with driver airbags that do not meet internal quality standards.
🔔 Kostenloses Konto anlegen und Benachrichtigungen zu Tesla X erhalten
Technische Bulletins (TSB) sind Reparaturanweisungen, die Hersteller ihren Händlern zu bekannten Problemen schicken. Sie sind keine Sicherheitsrückrufe, bestätigen aber oft einen Mangel.
Certain Model S and Model X vehicles were equipped with driver airbags that do not meet internal quality standards.
Some Model S Palladium and Model X Palladium vehicles were built without a hydraulic control unit (HCU) wake-up line, and in rare circumstances, braking and stability control related alerts may appear on the instrument cluster and touchscreen during the vehicle power-on process. Such faults can typically be corrected and the affected functionality restored with a vehicle power cycle.
On certain Model S and Model X vehicles, the 2nd generation High Voltage (HV) harness between the Front Junction Box (FJB) and the front drive unit might become disconnected, which could prompt a driver alert to bring the vehicle to a safe stop, advise the driver of limited acceleration, or prevent the driver from operating the vehicle upon startup. This condition does not affect steering or braking.
On some Model X vehicles, one or both intrusion sensors may have been incorrectly installed and may not function properly.
Some model x vehicles might have been built with incorrect front halfshafts. If full lock steering is applied while the suspension is fully extended, an incorrect halfshaft could overextend, damaging the dust boot or the constant velocity joint. This might lead to a knocking or grinding noise and/or a warning message on the instrument cluster.
On some model x vehicles, the a/c condenser pipes might have been installed on the incorrect condenser ports. This might cause poor or no a/c cooling performance, slow supercharging, and/or noise from the condenser pipes touching the front suspension sway bar.
Describes how to install the performance pedal set accessory.
On certain Model S and Model X vehicles built before November 1, 2021, the vehicle may lack Bluetooth headphone hardware support for the rear touchscreen audio.
On some Model X vehicles, the front roof applique and/or center spine applique may have been applied to the roof without the use of primer, which could cause the applique(s) to separate from the roof. This bulletin employs an improved inspection process which replaces the one for SB-20-12-005.
On some Model X vehicles, the front roof applique and/or center spine applique may have been applied to the roof without the use of primer, which could cause the applique(s) to separate from the roof. This bulletin employs an improved inspection process which replaces the one for SB-20-12-005.
On certain Model S and Model X vehicles built before November 1, 2021, the vehicle may lack Bluetooth headphone hardware support for the rear touchscreen audio.
Owners manual
On some Model X vehicles, the front door(s) may require manual assistance to fully close the doors because the cinch actuator(s) may not have been manufactured to Tesla specifications. The cinch actuators assist with the closing of the front doors on the automatic door feature. The front doors can always be manually opened or closed.
Certain Model X vehicles may have a split in the sheet metal on the LH and/or RH rear quarter inner panel(s). This condition, if present, is cosmetic in nature and does not impact the structural integrity, functionality, or safety of the vehicle.
On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the LH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.
On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the RH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.
On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the LH and RH side repeater cameras may lose electrical continuity over time, resulting in premature failure of the cameras.
Certain Model X vehicles were shipped with key fobs that were incorrectly manufactured. These key fobs are able to pair with the vehicle, but their functionality (e.g., press-to-unlock, passive locking and unlocking, etc.) might be impaired.
On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the LH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.
On certain Model S, Model X, and Fremont-built Model 3 vehicles, the Printed Circuit Board (PCB) for the RH side repeater camera may lose electrical continuity over time, resulting in premature failure of the camera.
Bestimmte Model X Fahrzeuge wurden mit Halterungen für die dreifache Kamera am Windschutzscheibenrahmen hergestellt, die nicht ordnungsgemäß befestigt waren. Die Halterung kann ungleichmäßig aussehen und/oder sich bewegen, wenn man sie berührt. Es gibt jedoch keine Auswirkungen auf die Autopilot-Funktionalität oder die Stabilität des Rückspiegels.
Certain Model 3, Model S, and Model X vehicles were equipped with 2nd generation Universal Mobile Connector (UMC) inline units having a proximity circuit resistor that is out of specification. This resistor within the affected UMC inline unit might prevent charging, might interrupt charging while in progress, and might affect the functionality of the UMC charge handle button when disconnecting the charge handle from the vehicle charge port.
Inspect Front Door Fixed Glass Seals
The rear node of some Model S and Model X vehicles might have damage in the forward mounting location of the rear subframe, resulting in noise, vibration, or harshness coming from that location.
Early front door latches are susceptible to water ingress, which might cause the touchscreen to show the door in the wrong position or prevent the door from opening and closing automatically. The door can still be opened with the inside handle.
Quellen: NHTSA (USA, gemeinfrei), Transport Canada (Open Government Licence – Canada), DVSA (Vereinigtes Königreich, Open Government Licence v3.0), RappelConso und EU-Safety-Gate (Frankreich, Licence Ouverte 2.0), MLIT (Japan, Public Data License 1.0) und MOLIT (Südkorea, car.go.kr).