Fuel system, gasoline:Fuel injection system
Vehicle description: Passenger vehicles equipped with v6 engines. An internal seal of the fuel injector can malfunction, allowing fuel leakage in the engine compartment.
🔔 Create a free account to get email alerts about Audi 80 (all generations)
Vehicle description: Passenger vehicles equipped with v6 engines. An internal seal of the fuel injector can malfunction, allowing fuel leakage in the engine compartment.
The bolts securing the front suspension struts to the wheel bearing housings may fracture due to brittleness. This could lead to loss of steering control.
Improperly manufactured steering lock bolts could break if driver applies excessive force to a locked steering wheel in an attempt to disengage the steering lock.
Under adverse weather conditions, outer rubber layer of brake hoses may become brittle and develop cracks. Consequence of defect: Cracks could lead to loss of brake fluid resulting in an increase in stopping distance and possibly an accident.
In the rear trunk area, the right rear side member for the mounting buffer may not have been welded according to specifications. In the event of an accident resulting in rear end damage it is possible that the right rear side member could break loose, damaging the fuel tank and causing fuel leakage.
The interior surface of the threaded hole for the front brake caliper brake hoses may contain porous spots which would allow brake fluid to seep out of the calipers during heavy brake applications. Prolonged seepage will eventually reeduce brake fluid level in the reservoir and may lead to complete brake failure.
The computer that controls the engine's fuel injection quantity and related functions has an inappropriate program. As a result, when the vehicle decelerates while the air conditioner is in use (or under similar conditions), the engine speed may become unstable, causing the engine speed to rise or the engine to stop.
In weather conditions which favour the build up of static electricity the air bag may deploy spontaneously if the driver enters or leaves the vehicle while carrying a high static charge. This can only happen when the car is stationery and not while it is in motion.
The airbag system built into the steering wheel (handle) of the steering system may have improper grounding. When the driver gets in or out of the vehicle, static electricity charged on the body may discharge, and in the worst case, the airbag may deploy automatically.
Vehicle description: Passenger vehicles. Some air bag sensors do not comply with audi's durability standards over the lifetime of the vehicle.
In some cases the alloy wheel retaining bolts may be of insufficient length and fail to achieve sufficient penetration into the threads in the hub.
ブレーキ倍力装置のバキュームポンプ(真空倍力補正装置)内にある樹脂製の羽根(羽 根を回転することにより負圧を発生させる。)が材質不良のため、当該羽根とバキューム ポンプ本体の内部側面が徐々に摩耗して、気密性が損なわれ、このままの状態で使用する と倍力装置に適正な負圧が得られなくなり、制動停止距離がのびるおそれがある。
動力式かじ取り装置(パワーステアリング)のロータリーバルブ(油圧経路を切り換え る弁)に組み付けられている油圧を保持するための樹脂製リングに材質不良のものがあり 、冷間時に当該リングが収縮し、オイルが漏れて、このままの状態で使用するとハンドル が重くなるおそれがある。
Power steering fluid may leak from the top seal of the steering assembly pinion housing into the vehicle passenger compartment.
On vehicles with automatic transmission, a low oil level in the differential could cause premature bearing and gear wear and eventual failure of the differential. This could result in possible drive wheel lock-up and loss of vehicle control. Correction: Differential will be drained and oil will be replaced with an advanced design high performance gear oil. Owners will be provided with a revised maintenance schedule.
The differential oil of the transaxle is lost over time due to evaporation. Low oil levels cause premature bearing and gear wear and eventual failure of the differential.
On vehicles with automatic transmission, the idle stabilizer valve may experience excessive wear. Such wear causes idle fluctuations which are barely noticeable at first, but ultimately could result in unsatisfactory driveability. Correction: Idle stabilizer valve will be replaced. V.I.N. Range wau***8**fa000001 to wau***8**ga138778
Excessive wear of idle stabilizer could cause idle fluctuations.
The seat belt buckles manufactured by afg and located on the rear seat of the audi 4000 and the right front seat of the audi 5000 may not lock securely, although the metal tongue of the seat belt has been fully engaged. In the event of an abrupt brake application or on impact, these buckles could become unlocked. Correction: Vehicles will be inspected and all seat belt buckles manufactured by afg will be replaced. V.I.N. Range audi 4000 - wau***8*ga*124887 to wau***8*ga*137554 audi 5000 - wau**44*g**087473 to wau**44*g**099448
Rear or front right seat belt locks may not properly engage. Consequence of defect: Seat belts could separate in event of heavy brake application or impact and thus subject passengers to injury.
The fuel pump may stop functioning without warning. This can occur because an electrical connector in the fuse panel may overheat and interrupt the electrical circuit.
Rear bumper system on certain vehicles may not have been properly welded during assembly. In the event of a rear end collision, the right side bumper supportor could break loose, damage the fuel tank and allow fuel to leak.
On certain vehicles, porous spots may have developed on the interior surface of the threaded hole for the brake hose during the moulding process. These spots allow brake fluid to seep from the calipers during heavy brake applications.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).