This file gathers the known defects of the Audi S6 IV (C6), written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.
Owners often report problems with engine on this car (67 complaints), but no one has explained the cause yet. Do you know it?Write it up
Owners often report problems with transmission and drivetrain on this car (13 complaints), but no one has explained the cause yet. Do you know it?Write it up
13 owners in the United States reported problems with the transmission and drivetrain of this car to NHTSA (model years 2013–2016), typically at around 58,000 miles. Reported consequences: 1 crash, 1 injury.
✓ Mecafile analysis of official data2013–2016View details →
NHTSA, the US road safety agency, opened an engineering analysis (EA22001) into this problem on 4 April 2022 for 2013–2016 models; it was closed on 26 May 2023 without a recall.
✓ Mecafile analysis of official data2013–2016View details →
67 owners in the United States reported problems with the engine of this car to NHTSA (model years 2013–2017), typically at around 62,000 miles. Reported consequences: 1 crash, 1 injury.
✓ Mecafile analysis of official data2013–2017View details →
The oil strainer installed in the oil supply line to the turbocharger may be too fine in mesh size, which can cause oil sediment to adhere to the oil strainer. If the vehicle is used for a long period and the sediment builds up, the oil strainer may become clogged, making it impossible to supply sufficient oil to the turbocharger. In the worst case, this may result in reduced engine output or engine stall.
jpJul 25, 20231236510Model years 2012–2016Auto-translated · original: JapaneseView details →
The Data Bus Diagnosis Interface (DBDI) mounted under the rear seat may short-circuit inside the unit due to moisture from liquid spilled on the rear seat. As a result, a warning light may illuminate, and the engine may enter an emergency running mode that limits output, or the power steering assist may be reduced.
jpFeb 2, 20231235580Model years 2018Auto-translated · original: JapaneseView details →
The oil strainer installed in the oil supply line to the turbocharger may have its mesh size set too small, which can cause oil sludge to adhere to the oil strainer. If the vehicle is used over a long period and the sludge builds up, the oil strainer may become clogged, preventing sufficient oil from being supplied to the turbocharger. In the worst case, this may result in reduced engine output or engine stalling.
jpSep 1, 20221234660Model years 2012–2017Auto-translated · original: JapaneseView details →
NHTSA · manufacturer bulletin10228283Model years 2014View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).