This file gathers the known defects of the Bentley Continental GT I, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.
Most serious reported defects
No defect documented for this selection yet.
RecallCriticalElectricalJP
In the engine compartment bulkhead, the stud bolts that secure the battery cable terminals have nuts whose tightening torque is improper on some vehicles, so the nuts may loosen due to vibration during driving. If the vehicle continues to be used in this condition, the battery cable terminal may make poor contact, causing the engine to fail to start. In addition, the poor contact increases electrical resistance, which generates heat and, in the worst case, may lead to a fire.
RecallMinorBrakesJP
On vehicles equipped with ceramic disc rotors for the rear brakes, the bolts that attach the disc rotor to the bell housing are made of an inappropriate material. When used in environments with high salt concentration, these bolts may corrode and break, which can cause abnormal noise and vibration during driving.
RecallCriticalBrakesUK
Only on the rear axle of vehicles fitted with carbon ceramic brakes the stainless steel screws fixing the rotor to the metal bell may fail due to stress corrosion cracking if the vehicle has been used in extreme salt environments. The customer will experience a noise when a screw fails and the brake continues to be 100% effective. However if the affected disc was to lose 8 of the 10 screws there would be a loss of braking at that rear wheel. This may lead to a small increase in stopping distance and could lead to a crash.
BulletinMinorElectricalNA
12 Volt - Battery condition checks. Customer statement / workshop findings: 12 volt battery flat or unserviceable Technical background: For all 12 volt battery issues relating to warranty or a parts warranty claim refer to the instructions within the Measure section.
BulletinModerateBodyNA
HVAC refrigerant leakage suspected or reports of a damp/musty smell within the cabin - Diagnosis guidelines. Customer statement / workshop findings: HVAC not cooling / HVAC cooling less than expected / HVAC refrigerant leakage confirmed Or The customer reports a damp/musty smell within the cabin Note: For this scenario please see the pre requisites below - Should no HVAC leak be evident and a damp/musty smell has been reported/identified the operative should first confirm that water is not leaking into the cabin please refer to all VIN applicable TPIs - Should there be no water leaks evident, the operative should check the HVAC and body drains for blockages, in the event the drains are blocked the drains must be unblocked, once this has been completed the operative should confirm if the damp/musty smell is still evident.
BulletinMinorOtherNA
Spurious DTC identification. Customer statement / workshop findings: Customers will not be aware of any DTCs, workshop operatives may discover spurious DTCs whilst running Guided Fault Finding (GFF) when using ODIS Technical background: To determine the course of action which should be taken the operative should refer to the Bentley Hub referencing the following: Spurious DTC list for TPI 2072055 The document contains all known spurious DTCs for all applicable vehicle variants.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).