Free to read · free account to contributeSuccessor to Anticars (2000)

Bentley Continental GT II

2011–2018 · 0 documented defects · 2 markets

This file gathers the known defects of the Bentley Continental GT II, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Most serious reported defects

No defect documented for this selection yet.

Latest official recalls

See all (8) →
RecallCriticalElectricalJP

Wiring

In the engine compartment bulkhead, the stud bolts that secure the battery cable terminals have nuts whose tightening torque is improper on some vehicles, so the nuts may loosen due to vibration during driving. If the vehicle continues to be used in this condition, the battery cable terminal may make poor contact, causing the engine to fail to start. In addition, the poor contact increases electrical resistance, which generates heat and, in the worst case, may lead to a fire.

MLIT · JapanNov 27, 20151222550Model years 2011–2014Auto-translated · original: JapaneseView details →
RecallCriticalElectricalEU

null The battery cable may be loose

null The battery cable may be loose. In very rare cases, the electrical connection can overheat whilst the vehicle is in use and lead to a vehicle fire.

EU Safety GateOct 29, 2015A12/1347/15Model years 2012–2015View details →

Latest service bulletins

See all (37) →
BulletinMinorSuspensionNA

Bulletin

Tyre tread/sidewall crack(s)

NHTSA · manufacturer bulletin11015371Model years 2017View details →
BulletinMinorBodyNA

Bulletin

15MY power boot PDI check (SC15/05) Technical background A significant design change has occurred on Continental GT and Continental GT Convertible power boot systems built from 15MY onwards. The striker is now powered whereas previously the latch was powered, and the ECU software for the close-cycle of the boot lid is modified. Due to these fundamental changes a different approach is required in rectifying issues. In a few cases, during manufacturing profile adjustment to the boot lid, the boot lid function may have been compromised The Pre Delivery Inspection (PDI) for 15MY onwards includes a specific function check for the power boot. In the event of a power boot failure to latch event during this specific 15MY PDI check then the rectification detailed for outcome of this campaign should be applied Remedy Check boot lid function and if necessary adjust boot lid striker and report adjustment

NHTSA · manufacturer bulletin10170167Model years 2015View details →
BulletinMinorBodyNA

Bulletin

Incorrect fuel filler door and bowl assembly (SC15/11) Technical background: For 16MY the method of storing the fuel filler cap during refuel has changed. A small number of 16MY Continental GT cars have the incorrect fuel filler bowl assembly fitted. Remedy: Fit the correct fuel filler flap and bowl assembly (part number 3W8809857M). Figure 1 shows the correct 16MY fuel filler flap and bowl assembly Figure 2 shows the incorrect assembly for 16MY Reference workshop manual, Rep. Gr.55 Fuel Filler Flap and Bowl To Remove and Fit

NHTSA · manufacturer bulletin10170228Model years 2016View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).