Some engines are fitted with an additional water pump for the turbo charger. In some circumstances a crack may develop which then leads to melting of the plug connections and the housing. Further heat development may then lead to scorch damage. In exceptional cases such overheating can lead to smouldering of the water pump. If smouldering occurs an engine compartment fire and vehicle fire cannot be excluded.
DVSA · United KingdomApr 27, 2012R/2012/049View details →
It has been identified that the lower rubber mounting on the metal bush of the rear shock absorbers may fail to meet the quality requirement. Dependant on the mileage and operating conditions the rubber mounting may come completely free from the shock absorber. If this occurs the bodywork would no longer be supported above the wheels causing it to come into contact with the wheel concerned. Should this occur the possibility exists that a critical driving condition might occur or even the risk of an accident.
DVSA · United KingdomJul 6, 2006R/2006/119View details →
On certain 325E, 325ES, 528E, 535I, 635CSI and 735I vehicles, the center high mounted brake light could add sufficient electrical load to cause the brake light switch to overheat, eventually leading to melting of the plastic internal switch parts. This could cause the switch plunger to jam in the ON or OFF position. This would render the brake light permanently ON or OFF regardless of brake pedal operation. Correction: A brake light switch with an increased current load capacity will be installed on affected vehicles.
Transport CanadaNov 27, 19861986134Model years 1986–1987View details →
On certain 533I, 633CSI and 733I, during assembly of the brake booster and master cylinder, stresses or possibly cracks in the master cylinder connecting flange may have occurred. It is possible that, during operation of the braking system, new cracks could develop and/or the existing cracks could be aggravated. This could reulst in misalignment of components and impaired brake function.
Transport CanadaJan 25, 19841984011Model years 1984View details →
The power brake booster may have been improperly machined causing stress and possibly cracks in the master cylinder where it is attached to the power brake booster.
NHTSA · United StatesJan 19, 198484V006000Model years 1984View details →
On the involved vehicles, the self locking nuts that connect the lower steering column shaft to the flexible coupling may not have been sufficiently tightened. These nuts can come loose.
NHTSA · United StatesDec 9, 198282V122000Model years 1983View details →
On some of the involved vehicles, the knurled nut, part of the rubber mount assembly which supports the differential, may have been cracked due to over-torquing of the final drive attaching bolt. This bolt may become loose, and continued operation may cause it to fall out.
NHTSA · United StatesNov 2, 198282V108000Model years 1982–1983View details →
On certain 528E vehicles, at very cold temperatures, when the engine is warmed up, water vapour might condense and freeze in the throttle houseing after a period of steady driving, causing ice build-up around the throttle plate. The ice may prevent the throttle plate from closing when the driver releases the accelerator pedal. Note: This recall supersedes recall V82017.
Transport CanadaSep 27, 19821982079Model years 1981–1982View details →
On certain BMW 528E vehicles, at temperatures of -9 degrees celsius and colder and a warmed up engine, water vapour might condense and freeze in the throttle houseing after a period of steady driving, causing ice buildup around the throttle plate. The ice may prevent the throttle plate from fully closing when the driver releases the accelerator pedal.
Transport CanadaFeb 2, 19821982017Model years 1982View details →
On the involved vehicles, under a combination of low temperature conditions and a warmed up engine, water vapor in the warm air from the crankcase housing may condense and freeze after a period of steady state driving causing ice build up around the throttle plate. The ice might prevent the throttle plate from fully closing when the driver releases the accelerator pedal, causing a slower than normal deceleration rate and an increase of the idle speed.
NHTSA · United StatesJan 28, 198282V010000Model years 1982View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).