Free to read · free account to contributeSuccessor to Anticars (2000)

BMW X7

2018– · 1 generations · 10 documented defects · 5 markets
Generations
All generationsX72018–10128303

Service bulletins (TSBs) are repair instructions manufacturers send to their dealers about known problems. They are not safety recalls, but they often confirm a defect.

Model year
MarketAllNA
BulletinModerateOtherNA

Bulletin

Water leaks onto the carpet from the heating and air conditioning (HVAC) system after the vehicle has hadprior HVAC system repairs.

NHTSA · manufacturer bulletin11039090Model years 2026View details →
BulletinModerateOtherNA

Bulletin

A small number of vehicles were produced without the evaporator condensate drain hose being installed.This is not immediately apparent to the customer. However, condensation water that has drained into thefront footwell can cause subsequent damage.

NHTSA · manufacturer bulletin11037846Model years 2026View details →
BulletinModerateBrakesNA

Bulletin

After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might belower than when handed over to the workshop for the repair.

NHTSA · manufacturer bulletin11036380Model years 2024View details →
BulletinModerateElectricalNA

Bulletin

Due to an implementation error in various OBD diagnostics in the vehicle's control units, in very rare cases itmay happen that stored fault memory codes (DTCs) and the MIL (warning light) are not automaticallydeleted even though the underlying malfunction has already been rectified. This does not comply with the statutory OBD specifications.

NHTSA · manufacturer bulletin11034449Model years 2025View details →
BulletinModerateSuspensionNA

Bulletin

When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises may be heard.

NHTSA · manufacturer bulletin11031574Model years 2024View details →
BulletinModerateBrakesNA

Bulletin

It was determined that your vehicle was fitted with a brake booster that potentially has a faulty hydraulic valve. This may result in a modified pedal feel and a sporadic red Check Control message. The brake booster should be replaced.

NHTSA · manufacturer bulletin11030319Model years 2025View details →
BulletinModerateOtherNA

Bulletin

Various external influences can cause premature aging of the tension strut hydro-mount elastomer; which can lead to cracks in the material, and leakage.

NHTSA · manufacturer bulletin11029047Model years 2024View details →
BulletinModerateBrakesNA

Bulletin

The wheel bearing and the brake disc are not correctly aligned; are not concentric (circled). When applicable work is being performed, it is therefore difficult to remove the wheel bolts from, or fasten them into the wheel bearing hub.

NHTSA · manufacturer bulletin11025672Model years 2026View details →
BulletinModerateSuspensionNA

Bulletin

When turning the steering wheel while stationary or when driving on uneven roads; cracking, creaking, or knocking noises may be heard.

NHTSA · manufacturer bulletin11021817Model years 2024View details →
BulletinModerateSuspensionNA

Bulletin

The seat lumbar system Massage will not function if the module needs to be initialized. This can occur toeither the drivers and/or passenger side seat. Here is a list of possible faults: Seat pneumatics module front right SPNM _ VR 025908 - SPNMVR: Control unit is not coded 02590B - SPNMVR: Control unit is not encoded for the vehicle 806927 - SPNMVR: Installation location not taught in Seat pneumatics module front left SPNM _ VL 025308 - SPNMVL: Control unit is not coded 02530B - SPNMVL: Control unit is not encoded for the vehicle 8067A7 - SPNMVL: Installation location not taught in Seat Module Driver FAS SMFA 80301E - No seat adjustment because of engine start conditions Seat Module Passenger BFS SMBF 802C1E - No seat adjustment because of engine start conditions Seat Module Drivers Side Rear FAH SMFAH 802E1E - No seat adjustment because of engine start conditions Seat Module Passenger Side Rear BFH SMBFH 802A1E - No seat adjustment because of engine start conditions

NHTSA · manufacturer bulletin11020931Model years 2024View details →
BulletinModerateBrakesNA

Bulletin

After programming from the I-Levels between 24-03-505 and lower than 24-03-540 to I-Level 24-11-530 or higher, the following CCM may be displayed: CCM-2525: Brake system. Drive at moderate speed

NHTSA · manufacturer bulletin11020910Model years 2024View details →
BulletinModerateElectricalNA

Bulletin

When navigation is selected, only the start animation with the text Starting navigation system... isdisplayed. The Navigation application does not start. This only applies to vehicles where Navigation hasbeen enabled and has been verified to work previously.

NHTSA · manufacturer bulletin11019572Model years 2025View details →
BulletinModerateSuspensionNA

Bulletin

The air line on the air suspension supply system may not be properly installed. In the event of a fault, residual pressure is maintained in the struts and corresponding check control message.

NHTSA · manufacturer bulletin11019565Model years 2025View details →
BulletinModerateSuspensionNA

Bulletin

The air line on the air suspension supply system may not be properly installed. In the event of a fault, residual pressure is maintained in the struts and corresponding check control message.

NHTSA · manufacturer bulletin11018563Model years 2025View details →
BulletinModerateElectricalNA

Bulletin

There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.

NHTSA · manufacturer bulletin11016472Model years 2020View details →
BulletinModerateBrakesNA

Bulletin

After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might be lower than when handed over to the workshop for the repair.

NHTSA · manufacturer bulletin11013438Model years 2024View details →
BulletinModerateBrakesNA

Bulletin

After replacement of the Integrated Braking system (IB)/Power Brake the total distance covered might be lower than when handed over to the workshop for the repair.

NHTSA · manufacturer bulletin11013040Model years 2024View details →
BulletinModerateBrakesNA

Bulletin

Improved diagnostic software for the brake system.

NHTSA · manufacturer bulletin11008992Model years 2024View details →
BulletinModerateBrakesNA

Bulletin

Improved diagnostic software for the brake system.

NHTSA · manufacturer bulletin11008107Model years 2024View details →
BulletinModerateElectricalNA

Bulletin

Due to an installation error, the crankshaft sensor connector may not have been properly locked. In very rare cases, the plug connection may become disconnected. If no signal is sent by the crankshaftsensor, the engine will switch to emergency operation and a Check Control message will occur.

NHTSA · manufacturer bulletin11008104Model years 2024View details →
BulletinModerateElectricalNA

Bulletin

There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.

NHTSA · manufacturer bulletin11006766Model years 2023View details →
BulletinModerateElectricalNA

Bulletin

Please have the starter motor checked and, if necessary, replaced in the vehicles concerned (according tothe vehicle identification number selection) if possible before vehicle delivery. If vehicles have already been delivered, please have the measure carried out the next time the vehiclesenter the workshop. A bolting fault on the long bolt screws can cause the magnets in the starter motor to twist. As a result, thepower of the starter motor decreases. As a result, the engine does not start.

NHTSA · manufacturer bulletin11006719Model years 2024View details →
BulletinModerateElectricalNA

Bulletin

There is a jerking or shuddering during either or both of the following: Cornering or accelerating from low speeds Driving with low to medium loads There are no warning lights or Check Control messages.

NHTSA · manufacturer bulletin11002858Model years 2023View details →
BulletinModerateSuspensionNA

Bulletin

Incorrect adjustment of the front and rear axles may result in steering wheel drift or increased tire wear onthe vehicle.

NHTSA · manufacturer bulletin11000635Model years 2024View details →
BulletinModerateSuspensionNA

Bulletin

At low outside temperatures (below 40 degrees F) and slow driving speeds (i.e. when parking, maneuvering)with a large steering angle, the front end can be slightly axially misaligned.

NHTSA · manufacturer bulletin11000563Model years 2024View details →
Older →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).