Free to read · free account to contributeSuccessor to Anticars (2000)

BMW X5 (G05)

2018– · 0 documented defects · 8 markets

This file gathers the known defects of the BMW X5 (G05), written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Most serious reported defects

No defect documented for this selection yet.

Latest official recalls

See all (121) →
RecallCriticalOtherEU

The starter rsw22 with reinforced water sealing (rwt) can suffer increased abrasion of the contact…

The RSW22 starter with reinforced water sealing (RWT) may experience increased abrasion of the magnetic contact, causing deposits to build up at the lowest point inside the relay. These deposits can increase the contact resistance of the relay, leading to starting failures or short circuits. If a short circuit occurs, either when attempting to start the vehicle or while driving due to deposit movement caused by vibration, it could cause a thermal event and increase the risk of fire.

EU Safety Gate · RappelConso · FranceOct 1, 2026sr/02180/26Model years 2020–2026Auto-translated · original: FrenchView details →
RecallModerateEngineEU

The hollow shaft of the servo motor was not welded properly

The hollow shaft of the brake booster was not welded correctly. The weld may be unable to withstand the build-up of high brake pressure and may break. In this case, reduced braking performance requires greater force, and the braking distance may increase. In addition, the ABS and DSC brake control systems are not assisted. This increases the risk of an accident.

EU Safety Gate · RappelConso · FranceJul 2, 2026sr/00053/25Model years 2022–2024Auto-translated · original: FrenchView details →
RecallModerateBrakesNA

Brakes

Issue: On certain vehicles, the recall repairs completed by a BMW dealer during Transport Canada recall number 2024-456 may not have been done correctly. As a result, another repair is required. On certain vehicles, a problem with the integrated brake system could cause reduced power brake assist. As a result, there may be reduced braking, and the antilock braking system (ABS) and dynamic stability control (DSC) may not work. Safety Risk: Reduced braking can cause extended stopping distances and could increase the risk of a crash. Additionally, antilock brakes and stability control systems that don't work could increase the risk of a crash. Corrective Actions: The company will notify owners by mail and advise you to take your vehicle to a dealership to inspect and, if necessary, replace the integrated brake system.

Transport CanadaJul 1, 20262026321Model years 2024View details →

Latest service bulletins

See all (342) →
BulletinMinorBodyNA

Bulletin

Delivery stop: Exterior mirror

NHTSA · manufacturer bulletin11039098Model years 2026View details →
BulletinModerateBrakesNA

Bulletin

The Integrated Brake (IB) power supply cable is covered with mesh protection and contact with the brakeline causes wear on the protective coating of the brake line. This wear leads to corrosion on the brake line

NHTSA · manufacturer bulletin11038939Model years 2026View details →
BulletinMinorBodyNA

Bulletin

Although the rear bumper is not equipped with a rear fog light, the Park Distance Control (PDC) wiringharness includes an unused fog light connector located in an area exposed to moisture. During production, the connector was wrapped in black electrical tape, which does not provide sufficientprotection against moisture and may allow water to enter the wiring harness.

NHTSA · manufacturer bulletin11037513Model years 2026View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).