Free to read · free account to contributeSuccessor to Anticars (2000)

BuickBuick Century IV

1982–1996 · 20 documented defects · 2 markets

This file gathers the known defects of the Buick Century IV, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.

Owners often report problems with brakes on this car (78 complaints), but no one has explained the cause yet. Do you know it?Write it up
Owners often report problems with engine and cooling on this car (68 complaints), but no one has explained the cause yet. Do you know it?Write it up

Most serious reported defects

See all (20) →
m
CriticalBrakesNA

Brakes: problems reported by owners

78 owners in the United States reported problems with the brakes of this car to NHTSA (model years 1983–1995), typically at around 95,000 miles. Most often named: antilock/traction control/electronic limited slip (33%), foundation components (31%). Reported consequences: 10 crashes, 6 injuries.

✓ Mecafile analysis of official data1983–1995View details →
m
CriticalEngineNA

Engine and cooling: problems reported by owners

68 owners in the United States reported problems with the engine and cooling of this car to NHTSA (model years 1984–1995), typically at around 95,000 miles. Most often named: engine:gasoline (53%), engine (19%). Reported consequences: 2 crashes, 6 fires, 1 injury.

✓ Mecafile analysis of official data1984–1995View details →
m
CriticalElectricalNA

Electrical system: problems reported by owners

57 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 1983–1995), typically at around 230,000 miles. Most often named: ignition (25%), ignition:module (18%), alternator/generator/regulator (16%). Reported consequences: 3 crashes, 9 fires, 5 injuries.

✓ Mecafile analysis of official data1983–1995View details →

Latest official recalls

See all (44) →
RecallMinorInteriorNA

Seats And Restraints

These vehicles do not comply with c.M.V.S.S. 210 - seat belt assembly anchorage. Vehicles were assembled with rear outboard seat belt anchorages that may not withstand the required load. During loading, stress could cause the attachment metal to tear and allow the anchorage to separate from the body. Correction: Dealers will replace the existing anchor bolts with new shoulder bolts and thread locking adhesive. Noise control patches will also be applied at each anchorage.

Transport CanadaSep 20, 19951995165Model years 1989–1995View details →
RecallModerateInteriorNA

Seat belts:Front:Anchorage

These vehicles were assembled with rear outboard safety belt anchorages that may not withstand the required load. This does not comply with fmvss no.210, "seat belt assembly anchorages."

NHTSA · United StatesSep 15, 199595V173000Model years 1989–1995View details →
RecallCriticalSuspensionNA

Suspension

Note: Vehicles located in ontario(4) and british columbia(1). These vehicles may have an under torqued right hand front spindle nut. If this nut were to fall off, the wheel could separate from the vehicle possibly resulting in a crash without prior warning. Correction: Vehicles will be inspected and if the right hand front spindle nut is under torqued, the wheel bearing assembly and nut will be replaced.

Transport CanadaOct 4, 19941994151Model years 1994View details →

Latest service bulletins

See all (6) →
BulletinMinorEngineNA

Bulletin

Prom calibration replacement for nox emissions. *yc

NHTSA · manufacturer bulletin602341Model years 1994View details →
BulletinMinorBrakesNA

Bulletin

Abs dtc 34 and/or 35 may be set (replace/repair harness). *sd

NHTSA · manufacturer bulletin45825Model years 1994View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).