Free to read · free account to contributeSuccessor to Anticars (2000)

BuickBuick Electra VI

1984–1990 · 7 documented defects · 1 markets
Model year
MarketAllNA
RecallCriticalSuspensionNA

Steering

These vehicles may have insufficient clearance between the power steering pump return hose and the exhaust manifold due to incorrect routing. This condition could cause overheating of the hose, resulting in a fluid leak. This could result in an engine compartment fire without prior warning. Correction: Power steering pump hose will be replaced if it was incorrectly routed.

Transport CanadaNov 5, 19861986123Model years 1986View details →
RecallCriticalSuspensionNA

Steering:Hydraulic power assist:Hose, piping, and connections

There may not be enough clearance between the power steering pump return hose and the engine exhaust manifold. Consequence of defect: Hose could overheat, resulting in a hole and fluid leak, and a possible engine compartment fire without prior warning.

NHTSA · United StatesNov 3, 198686V145000Model years 1986View details →
RecallCriticalInteriorNA

Recall

Vehicles may have been assembled with a rubber fuel return hose which could allow a slow fuel leak while the engine is running. Under certain conditions this could result in a fire which could spread to the passenger compartment and cause burn unjuries to occupants.

Transport CanadaSep 6, 19841984099Model years 1984View details →
RecallModerateEngineNA

Engine

A small nylon bushing in the cruise control servo bail (bracket) may slip out of place resulting in possible intermittent increases in engine speed or dieseling. This condition could also cause the servo rod assembly to wear through the ball and catch on other components possibly resulting in a stuck throttle. This could result in loss of vehicle control and a possible crash. Correction: A bushing kit will be installed on the cruise control servo bail.

Transport CanadaJul 4, 19891989092Model years 1984–1988View details →
RecallModerateEngineNA

Vehicle speed control

A small nylon bushing in the cruise control servo bail may slip out of place, causing intermittent and unexpected increases in engine speed or dieseling (engine run on with ignition off).

NHTSA · United StatesJun 16, 198989V102000Model years 1984View details →
RecallModerateEngineNA

Emissions

These vehicles do not comply with c.M.V.S.S. 1105-evaporative emissions. Vehicles may experience an inoperative canister purge thermo vacuum switch.

Transport CanadaMar 14, 19891989036Model years 1984View details →
RecallModerateEngineNA

Engine

Excessive accelerator cable friction may restrict the cable's free movement between the accelerator pedal and the throttle body. This could prevent the throttle from returning to idle when the accelerator pedal is released and possibly result in loss of accelerator control and a vehicle crash without prior warning. Correction: Vehicles will be inspected and accelerator control cable will be replaced if required.

Transport CanadaMay 19, 19881988068Model years 1987View details →
RecallModerateBrakesNA

Brakes

On vehicles with antilock brakes,brake fluid may seep from the abs pressure/warning switch,eventually leading to the loss of the hydraulic pump motor.Also the pump motor and abs electrical relays may have been contaminated during assembly.This can cause loss of the hydraulic pump motor &/or the abs function.Loss of the pump motor would eventually lead to loss of the rear brakes & loss of power assist to the front brakes.This would result in increased stopping distance.An inoperative abs relay could cause loss of the abs function.Abs,pump motor relays,& 30 amp fuses will be replaced.

Transport CanadaJul 31, 19871987078Model years 1986–1987View details →
RecallModerateBrakesNA

Service brakes, hydraulic:Antilock/traction control/electronic limited slip

The anti lock brake system (abs) pressure/warning switch may exhibit brake fluid seepage which eventually can lead to loss of the brake system hydraulic pump motor. Additionally, the hydraulic pump motor and abs electrical relays may have been exposed to water contamination during vehicle assembly. This condition can cause loss of the hydraulic pump motor and/or loss of the abs function.

NHTSA · United StatesJun 23, 198787V093000Model years 1986View details →
RecallModerateElectricalNA

Exterior lighting:Headlights:Switch

The push pull headlight switch may have electrical contacts which allow an intermittent headlight circuit causing headlight to flicker or suddenly go out. Consequence of defect: Sudden loss of the headlights under severe weather or nighttime driving conditions could reduce driver visibility which might result in a vehicle crash without prior warning.

NHTSA · United StatesSep 19, 198686V131000Model years 1986View details →
RecallModerateEngineNA

Recall

These vehicles do not comply with c.M.V.S.S.1101-emission device.

Transport CanadaJan 16, 19861986007Model years 1985View details →
RecallMinorInteriorNA

Seat belts:Front:Webbing

Owners manuals did not fully explain how front shoulder belt comfort feature works.

NHTSA · United StatesJun 6, 199090V112000Model years 1990View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).