On certain passenger vehicles equipped with 3800 v6 (l36) engines and certain delphi fuel pressure regulators, the regulators have a much higher than usual rate of fuel leaks. A leak can allow fuel to enter the intake manifold through a vacuum line. If the engine does not start when cranked, the fuel from the leaking regulator and a mistimed spark can cause a backfire.
NHTSA · United StatesFeb 24, 200404V090000Model years 1998–2000View details →
These vehicles may exhibit a backfire during engine starting that can cause breakage of the upper intake manifold. This can cause a no-start condition and possibly an engine compartment fire. Also, if a person was in the vicinity of the intake manifold when the hood was open, and this backfire condition occurred, it could result in personal injury. Correction: The pcm (powertrain control module) will be reflashed with new programming software.
Transport CanadaJul 11, 19961996099Model years 1996–1997View details →
These vehicles do not comply with c.M.V.S.S. 1101 - emission device. Improper calibration of the powertrain control module (pcm) can result in uncontrolled spark knock, setting an mil (malfunction indicator lamp), misfire, rough idle, audible knock and/or possible engine damage. Correction: Vehicle pcm will be reflashed with new calibration softwear.
Transport CanadaFeb 20, 19981998034Model years 1998View details →
A small nylon bushing in the cruise control servo bail (bracket) may slip out of place resulting in possible intermittent increases in engine speed or dieseling. This condition could also cause the servo rod assembly to wear through the ball and catch on other components possibly resulting in a stuck throttle. This could result in loss of vehicle control and a possible crash. Correction: A bushing kit will be installed on the cruise control servo bail.
Transport CanadaJul 4, 19891989092Model years 1984–1987View details →
A small nylon bushing in the cruise control servo bail may slip out of place, causing intermittent and unexpected increases in engine speed or dieseling (engine run on with ignition off).
NHTSA · United StatesJun 16, 198989V102000Model years 1984–1988View details →
The fuel rollover valve may not have been installed on the affected vehicles. In the event of an accident where the vehicle became inverted, a missing fuel rollover valve assembly could allow fuel spillage in excess of the amount prescribed by c.M.V.S.S. 301 - fuel system integrity. Correction: Fuel sender and pump assembly will be replaced.
Transport CanadaSep 2, 19881988126Model years 1989View details →
These vehicles do not comply with c.M.V.S.S. 1103 - exhaust emissions. - mass airflow sensor failure - note : Vehicles with 3.0 litre and 3.8 litre engines.
Transport CanadaJan 27, 19871987007Model years 1987View details →
Accelerator pump lever retaining pin may loosen after repeated heavy accelerator pedal applications. This could cause the throttle to become stuck in the open position.
NHTSA · United StatesAug 19, 198383V077000Model years 1981View details →
Under certain vehicle operating conditions, the governor weight retainer in the injection pump may fail. The throttle valve could stick, preventing return to idle and shut down of the engine by the driver.
NHTSA · United StatesJan 3, 198282V012000Model years 1982View details →
The maintenance schedule specifies a 30,000 mile (48,000 km) interval between spark plug changes instead of the correct 22,500 mile (36,000km) interval. The incorrect interval if followed may affect air emission control performance. These vehicles do not comply with canada motor vehicle safety standard 1103 - exhaust emissions.
Transport CanadaJun 12, 19801980091Model years 1980View details →
Vehicles equipped with 5.7 litre engines. Vehicles may have been assembled with improper functioning exhaust gas recirculation (egr) valve. These vehicles do not comply with canada motor vehicle safety standard 1103 - exhaust emissions. Gas recirculation (egr) valve. These vehicles do not comply with canada motor vehicle safety standard 1103 - exhaust emissions.
Transport CanadaJan 11, 19801980009Model years 1980View details →
Certain vehicles do not comply with the requirements of CMVSS 1101 - Emission Device. Vehicles were built with incorrect emission control labels. The emission control (tune up) labels have an incorrect emission vacuum hose routing schematic. Correction: Dealers will install a new vehicle emission control label on the radiator support.
Transport CanadaJun 28, 19991999128Model years 1998–1999View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).