Free to read · free account to contributeSuccessor to Anticars (2000)

BuickBuick Roadmaster

1991–1996 · 1 generations · 11 documented defects · 1 markets
Generations
All generationsVIII1991–199611209
Model year
MarketAllNA
RecallCriticalSuspensionNA

Suspension

The wheel lug nuts on these vehicles may not have been tightened to specification during assembly. This may result in fracture of the wheel studs, which could cause the wheel to separate from the vehicle. If this were to occur while the vehicle was in motion, a crash could occur without prior warning. Correction: Wheel lug nuts will be tightened to specification.

Transport CanadaDec 13, 19961996205Model years 1996View details →
RecallCriticalEngineNA

Fuel System

The fuel tank attachment strap fasteners are below the specified torque. These loose fasteners could, in time, become completely detached. This could allow the fuel tank to sag down to the point of striking something in the road or the road surface resulting in a possible fuel leak and an under-vehicle fire. Correction: Fuel tank strap fasteners will be torqued to the proper specifications.

Transport CanadaNov 3, 19941994170Model years 1994View details →
RecallCriticalEngineNA

Fuel system, gasoline:Storage:Tank assembly:Mounting

The fuel tank attachment strap fasteners were not properly tightened. The fasteners can completely detach, eventually allowing the fuel tank to sag and the bottom of the tank to strike the roadway.

NHTSA · United StatesOct 25, 199494V210000Model years 1994View details →
RecallCriticalSuspensionNA

Wheels:Lugs/nuts/bolts/studs

Paint on the wheel mounting surfaces can act as a shim between the wheel and the rotor/drum. As the vehicle is driven, the wheel imbeds into the paint, loosening the lug nut and causing a loss of clamp load.

NHTSA · United StatesApr 16, 199494V076000Model years 1994View details →
RecallCriticalEngineNA

Engine

On certain vehicles, the engine oil cooler inlet hose may contact the steering gear and wear through. This could allow engine oil to leak onto hot engine components and cause an engine compartment fire. Correction: Oil cooler hose will be repositioned and inspected. If wear is evident, the hose will be replaced.

Transport CanadaMar 25, 19941994064Model years 1994View details →
RecallModerateBrakesNA

Brakes

The abs modulator may corrode and leak fluid from the front brake circuit. Brake fluid leakage could reduce brake effectiveness and increase stopping distances. This could result in a crash without prior warning. Correction: Dealers will remove existing corrosion from the abs modulator and install a kit to prevent future corrosion.

Transport CanadaDec 11, 19971997219Model years 1992View details →
RecallModerateSuspensionNA

Suspension

Note: Includes caprice police sedans, taxi cabs and special service wagons; fleetwood hearse and limousine. The lower control arm ball joint attachment may be loose. This condition can cause the lower control arm ball joint to loosen, fatigue and separate from the front suspension knuckle. If separation were to occur with the vehicle in motion, loss of vehicle control could occur, which could result in a vehicle crash. Correction: Front lower control arm ball joint attachment nuts will be inspected for proper torque. If the ball joint has loosened from the knuckle, both the ball joint and knuckle will be replaced.

Transport CanadaFeb 12, 19961996025Model years 1995–1996View details →
RecallModerateBodyNA

Structure

These vehicles do not comply with c.M.V.S.S. 102 - transmission shift control sequence. A misadjusted transmission shift control linkage may allow the transmission to be shifted out of the "p"(park) position with the ignition key removed. In the event of this condition occurring, the vehicle may roll from its parked position and cause potential damage and/or injury. Correction: Shift control linkage system will be adjusted.

Transport CanadaNov 29, 19951995211Model years 1995View details →
RecallModerateGearboxNA

Power train:Automatic transmission

These vehicles were produced with an improperly adjusted transmission shift control linkage. This does not meet with the requirements of fmvss no. 114, "theft protection."

NHTSA · United StatesNov 16, 199595V221000Model years 1995View details →
RecallModerateEngineNA

Engine

Certain vehicles do not comply with CMVSS 124 - Accelerator Control Systems. At low temperatures there may be excessive movement friction in the accelerator pedal assembly. In the event of a failure of a throttle return spring the engine speed may not decrease to the level anticipated by the driver when the foot is lifted from the accelerator pedal. Loss of accelerator control could result in a vehicle crash without prior warning. Correction: Accelerator pedal assembly will be replaced.

Transport CanadaApr 24, 19951995074Model years 1994–1995View details →
RecallModerateEngineNA

Vehicle speed control:Springs

These vehicles fail to conform to fmvss no. 124, "accelerator control systems." at low temperatures, excessive friction can occur in the accelerator pedal assembly.

NHTSA · United StatesApr 24, 199595V082000Model years 1994–1995View details →
RecallModerateInteriorNA

Seat belts

The shoulder belt guide loop plastic covering may crack and expose the steel sub-plate.

NHTSA · United StatesJul 1, 199292V094000Model years 1991–1992View details →
RecallModerateInteriorNA

Seats And Restraints

Note: 1991 caprice sedans and wagons and roadmaster wagons and 1992 roadmaster sedans. The shoulder belt guide loop plastic covering may crack and expose the steel sub-plate. In the event of a severe vehicle crash, the exposed steel sub-plate may cut the safety belt webbing and result in an increased possibility and/or severity of injury to the affected seat occupant. Correction: New shoulder belt guide loops will be installed on involved vehicles.

Transport CanadaJun 29, 19921992076Model years 1991–1992View details →
RecallModerateBodyNA

Structure

The secondary hood latches on these vehicles can corrode causing a very high latch release effort and possibly preventing the hood from latching properly when it is closed. If the secondary hood latch is not properly engaged the hood could open unexpectedly. If this were to occur while the vehicle was in motion, the driver's forward vision would be impaired possibly resulting in a vehicle crash. Correction: A new scondary hood latch assembly with improved corrosion resistance will be installed on affected vehicles.

Transport CanadaOct 31, 19911991147Model years 1991–1992View details →
RecallModerateBodyNA

Latches/locks/linkages:Hood:Latch

Secondary hood latch assemblies can corrode, causing a high latch release effort and possibly preventing the hood from latching properly when it is closed.

NHTSA · United StatesOct 29, 199191V186000Model years 1991–1992View details →
RecallMinorInteriorNA

Air bags

These vehicles were shipped with both the supplemental inflatable restraint caution label and a roof rack caution label installed on the same side of the sun visor. This does not meet the requirements of fmvss no.208, "occupant crash protection."

NHTSA · United StatesNov 3, 199595V215000Model years 1995–1996View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).