Free to read · free account to contributeSuccessor to Anticars (2000)

BuickBuick Skyhawk

1981–1989 · 1 generations · 10 documented defects · 1 markets
Generations
Model year
MarketAllNA
RecallCriticalEngineNA

Fuel System

On vehicles with 2.0l engines, the fuel feed and return hose assemblies may have been manufactured with improperly crimped fittings.A hose assembly with this condition may crack or separate from the fittng, allowing fuel to leak in the underhood area. This could result in an underhood fire. Correction:Hose assemblies will be replaced.

Transport CanadaNov 25, 19871987126Model years 1987View details →
RecallCriticalEngineNA

Engine and engine cooling:Engine

The engine air cleaner plastic trim cover could fall off the air cleaner assembly and land on the exhaust manifold creating a fire hazard. Consequence of defect: If the car is being operated at the time that the plastic trim cover falls off, an engine compartment fire could occur without warning.

NHTSA · United StatesMay 28, 198686V073000Model years 1985View details →
RecallCriticalBrakesNA

Recall

The brake proportioner valves may break and separate from the master cylinder during braking. This will result in a loss of brake fluid and a partial loss of braking action

Transport CanadaOct 7, 19841983084Model years 1983View details →
RecallCriticalEngineNA

Fuel system, gasoline:Storage:Tank assembly:Filler pipe and cap

Under certaain conditions, the hose clamps on the fuel tank filler pipe and fuel tank filler vent pipe could fracture. The fracture of these clamps could cause fuel leakage at any of the four pipe to hose connections. Leakage can occur during refueling, or while driving, if the fuel tank is above 3/4 full.

NHTSA · United StatesMar 8, 198282V021000Model years 1982View details →
RecallCriticalElectricalNA

Recall

Under certain conditions the hose clamps on the fuel filler pipe and fuel tank filler vent pipe could fracture. This could cause seepage of fuel at any one of the four pipe to hose connections when the fuel tank is above 3/4 full creating the possibility of fire.

Transport CanadaMar 3, 19821982026Model years 1982View details →
RecallModerateBodyNA

Structure

On vehicles with a manually adjusted driver's seat, the metal floor pan anchor bar could fatigue and break around the left front outer seat adjuster stud. This could allow the stud to separate from the anchor bar and cause the driver's seat to tip rearward unexpectedly, resulting in possible loss of control and vehicle crash without prior warning. Correction: A reinforcement bracket will be installed on the floor pan anchor bar.

Transport CanadaMay 25, 19871987053Model years 1983–1984View details →
RecallModerateInteriorNA

Seats

The metal floor pan anchor bar could fatigue and break around the left front outer seat adjuster stud of the drivers seat, allowing the stud to separate from the floor pan anchor bar.

NHTSA · United StatesMay 7, 198787V079000Model years 1983–1984View details →
RecallModerateBrakesNA

Parking brake:Conventional:Mechanical

Parking brake lever mechanisms may not properly engage when applied as required by fmvss 105. Consequence of defect: Vehicle could unexpectedly roll away uncontrolled, which could result in a vehicle crash.

NHTSA · United StatesSep 15, 198686V128000Model years 1987View details →
RecallModerateBodyNA

Recall

These vehicles do not comply with c.M.V.S.S.108 - lighting equipment. Buick skyhawk custom 2 and 4 door sedans and limited 4 door sedans.

Transport CanadaJan 23, 19861986013Model years 1986View details →
RecallModerateElectricalNA

Exterior lighting

Incorrect tail lamp lens were installed, lens do not conform to fmvss 108, lamp reflective device and associated equipment. Consequence of defect: In times of reduced visibility, an approaching vehicle may not be aware of this vehicle which could result in a vehicle crash without prior warning.

NHTSA · United StatesNov 18, 198585V149000Model years 1986View details →
RecallModerateInteriorNA

Seats And Restraints

On certain vehicles, the front seat back locks may not lock under forward load conditions and are therefore not in compliance with CMVSS 207 - Seat Anchorages.

Transport CanadaFeb 27, 19841984027Model years 1984View details →
RecallModerateInteriorNA

Seats:Front assembly:Recliner

Some vehicles have bucket seat back locks that do not conform to federal motor vehicle safety standard 207, anchorage of seats. In event of a crash, the seat back lock may not function.

NHTSA · United StatesFeb 6, 198484V011000Model years 1984View details →

Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).