This file gathers the known defects of the Chevrolet Corvette (C4), written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.
35 owners in the United States reported problems with the brakes of this car to NHTSA (model years 1986–1995), typically at around 85,000 miles. Most often named: antilock/traction control/electronic limited slip (29%). Reported consequences: 6 crashes, 3 injuries.
✓ Mecafile analysis of official data1986–1995View details →
35 owners in the United States reported problems with the electrical system of this car to NHTSA (model years 1984–1995), typically at around 34,000 miles. Most often named: ignition (26%). Reported consequences: 1 crash, 4 fires.
✓ Mecafile analysis of official data1984–1995View details →
23 owners in the United States reported problems with the accelerator and cruise control of this car to NHTSA (model years 1984–1995), typically at around 77,000 miles. Reported consequences: 8 crashes, 5 injuries.
✓ Mecafile analysis of official data1984–1995View details →
These vehicles may not comply with c.M.V.S.S. 1105 - evaporative emissions. Two (2) suspect evaporative emission hoses may deteriorate, crack and leak. Correction: Suspect evaporative emission hoses will be replaced with improved hoses which will be secured with hose clamps.
Transport CanadaMay 28, 19931993075Model years 1988–1989View details →
The power steering inlet hose may fracture causing power steering fluid to spray out of the hose and, in the presence of an ignition source, an engine compartment fire could result. Correction: Power steering gear inlet hose will be replaced on involved vehicles.
Transport CanadaNov 3, 19921992137Model years 1992–1993View details →
Campaign bulletin introduces a recall for certain 1995 corvettes equipped with 5.7 engines, to install tie strap on the harness of the throttle body coolant hose to prevent the hose from contacting the power steering pulley. Contact of the vent harness with the pulley may cause the harness to wear through and and could eventually result in a distributor failure. Vehicles built with vacuum harness 12553223 will not require any modification. Vehicles equipped with vacuum harness 12554393 will require the tie strap.
NHTSA · manufacturer bulletin45837Model years 1995View details →
NHTSA · manufacturer bulletin43011Model years 1995View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0).