その他(燃料装置)
燃料タンクの給油口において、給油時にガソリンが大量に溢れ出た際に、気化したガソリンがエンジン冷却用ファンにより、ラジエーターに吸い込まれることがある。そのため、ラジエーターが高温になっている場合、気化したガソリンがラジエーターまたはエンジンルーム内の排気管表面に付着することにより、最悪の場合、火災に至るおそれがある。
🔔 Create a free account to get email alerts about Chevrolet Corvette (all generations)
燃料タンクの給油口において、給油時にガソリンが大量に溢れ出た際に、気化したガソリンがエンジン冷却用ファンにより、ラジエーターに吸い込まれることがある。そのため、ラジエーターが高温になっている場合、気化したガソリンがラジエーターまたはエンジンルーム内の排気管表面に付着することにより、最悪の場合、火災に至るおそれがある。
燃料タンクの給油口において、給油時にガソリンが大量に溢れ出た際に、気化したガソリンがエンジン冷却用ファンにより、ラジエーターに吸い込まれることがある。そのため、ラジエーターが高温になっている場合、気化したガソリンがラジエーター表面に付着することにより、最悪の場合、火災に至るおそれがある。
General Motors, LLC (GM) is recalling certain 2023â2026 Chevrolet Corvette vehicles equipped with a left-side radiator/fan combination. Excess fuel may spill into the vehicle fuel-filler pocket during refueling and leak onto an ignition source.
Some of the left and right fuel tank connections were found to have had foreign matter get in during manufacturing. If the vehicle continues to be used in this condition, cracks may develop at the connections and fuel may leak.
These vehicles may have a torn seal between the fuel tank and sending unit pump. This may cause a fuel odour and/or leakage at the attachment location. In the presence of an ignition source, a fire could occur. Correction: Left and right hand fuel tank assemblies (including fuel sending unit and pump) will be replaced.
Vehicle description: Passenger vehicles. These vehicles have a torn fuel tank sending unit/pump seal. This can cause fuel odor and/or leakage at the attachment location.
The fuel feed and return lines on these vehicles were built with the incorrect line end flare configuration. If these lines are left uncorrected the line ends could crack, causing a fuel leak and a risk of an engine compartment fire. Correction: New fuel lines with the correct end flare configuration will be installed on affected vehicles.
Fuel feed and return line connectors have incorrect line end flare configurations.
In the electric column lock, which is the steering lock device, the material of the internal lock pin drive mechanism is inappropriate. Therefore, if the vehicle continues to be used in a hot and humid environment, that drive mechanism may deform. As a result, the drive resistance increases, and in the worst case the steering lock cannot be released, so the engine may not be able to start.
The motor that operates the steering wheel lock was manufactured improperly, so the insulation of the coil inside some of the motors is damaged. If the vehicle continues to be used in this condition, the coil may short-circuit, causing the motor to stop operating. The steering wheel lock may then be unable to be released, and the engine may not be able to start.
When the vehicle reaches operating temperature, the UBEC fuse holder in the engine compartment switches off. As a result, the power wire for the dimmer relay is bent slightly. With repeated bending, the power wire can break and come loose.
The rubber hose used in the fuel evaporative emission control system has a material defect. If it continues to be used in this condition, the hose may crack and, in the worst case, fuel vapor may be released into the atmosphere.
These vehicles may not comply with c.M.V.S.S. 1105 - evaporative emissions. Two (2) suspect evaporative emission hoses may deteriorate, crack and leak. Correction: Suspect evaporative emission hoses will be replaced with improved hoses which will be secured with hose clamps.
The cruise control vacuum solenoid valves may malfunction at any- time the engine is running with the cruise control engaged, resulting in unexpected engine acceleration.
The cruise control vacuum solenoid valves may malfunction at any time the engine is running and the cruise control is engaged and cause unexpected engine acceleration. Consequence of defect: Loss of accelerator control could result in a vehicle crash without prior warning.
Certain Camaro, Firebird, Monte Carlo and Grand Prix equipped with a 5.0L engine, and 5.7L Corvettes. High ignition coil temperatures combined with the stress of higher voltage may break down the coating of the high output ignition coil secondary windings. Declining ignition voltage may lead to engine misfire, hesitation sags or no re-start. Depending on road condition, this could result in a significant safety hazard. Correction: High output ignition coil will be replace, spark plug gap will be revised and a spark plug gap revision label will be installed.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).