Service bulletins (TSBs) are repair instructions manufacturers send to their dealers about known problems. They are not safety recalls, but they often confirm a defect.
This Preliminary Information communication provides information to the technician about vehicles that may have the engine Cover Foam not installed correctly. If the foam is deformed then replace the cover. If a burning odor was found replace the cabin filter.
NHTSA · manufacturer bulletin10160999Model years 2016View details →
This Preliminary Information communication provides information to the technician about vehicles that may have the engine Cover Foam not installed correctly. If the foam is deformed then replace the cover. If a burning odor was found replace the cabin filter.
NHTSA · manufacturer bulletin10114917Model years 2016View details →
This service bulletin provides repair information to correct a customer concern of No Crank, No Start, Quick Start/Stall, No FOB Detected, Key FOBs Inoperative, B3924 00, B3925 00, B3926 00, B3927 00, B3928 00 Set.
NHTSA · manufacturer bulletin11016946Model years 2019View details →
This engineering information (EI) is requesting information from technicians to perform the check list provided and contact the engineer listed in regards to Oil Leaking from Front of Engine.
NHTSA · manufacturer bulletin10211090Model years 2019View details →
Front Tire Front Air Deflector Fastener Length Differences When performing a PDI, or if removing the left front tire front air deflector or the front bumper fascia center air deflector, the incorrect length screw may have been provided for installation. If a longer screw is installed in the incorrect position of the left front tire front air deflector, the longer screw may come in contact with the battery coolant hose.
NHTSA · manufacturer bulletin10190511Model years 2016View details →
This Preliminary information communicates a concern where the wrong part number was being installed causing XM and Audio concerns. This PI explains the concern and advises to return the part to the ESC for the correct part if the incorrect part number is received
NHTSA · manufacturer bulletin10184106Model years 2019View details →
17229 - Service Update. Certain vehicles may develop a fractured right front side tubular half-shaft near the outboard cv joint. This condition presents itself at a low mileage, and the driver may hear a clunk, grinding or rattle noise at the right front side of the vehicle during braking or accelerating. Loss of propulsion may also occur without warning. In addition, the wheels may not be locked, and rollaway can occur if the vehicle is placed in park on a grade without the parking brake being set. Replace the right front wheel drive shaft.
NHTSA · manufacturer bulletin10158901Model years 2017View details →
16185-Customer Satisfaction. On certain vehicles, the high voltage interlock connector behind the high voltage battery disconnect relay fuse block cover may be susceptible to becoming recessed back into the high voltage battery disconnect relay assembly. This may cause an electrical disconnect which could result in a loss of vehicle propulsion and/or a no start condition. The malfunction indicator lamp may be illuminated and DTC P0A0C ? ?high voltage system inter-lock circuit low? may be set. A ?Shift To Park? message may also be displayed. Additionally, a subset of these vehicles may have a condition in which the 15A fuse in the high voltage battery disconnect relay may prematurely open. The open fuse may prevent the low voltage battery from being charged by the 14v DC power module. If this were to occur, the vehicle will provide warning to the driver and eventually lose electrical power. Once power is drained from the 12 volt battery, the vehicle may lose propulsion and will not start. Dealers will reprogram the hybrid powertrain control module 2; and if applicable, replace the 15 amp high voltage battery disconnect relay fuse.
NHTSA · manufacturer bulletin10156979Model years 2017View details →
This informational bulletin provides information regarding the Passenger Presence System (PPS) May Command Seat Belt Reminder Chime and Passenger Airbag Indicator On When Electronic Devices or Conductive Objects are Placed on Front Passenger Seat
NHTSA · manufacturer bulletin10138552Model years 2013View details →
12266 - Service Update. During vehicle startup, the Electric Park Brake telltale and the Service Electric Parking Brake telltale may illuminate in error. Dealers are to reprogram the Electronic Parking Bracke Control Module.
NHTSA · manufacturer bulletin10138228Model years 2013View details →
This Preliminary information communicates to the technician, that if the latest calibration have been installed per 17058 and Service Information for the P2097 fails to isolate the cause, do not attempt repairs at this time. To return the vehicle to the customer and to advise that GM is aware of this concern and working on a resolution.
NHTSA · manufacturer bulletin10137184Model years 2016View details →
This Preliminary information communicates to the technician, that if the latest calibration have been installed per 17058 and Service Information for the P2097 fails to isolate the cause, do not attempt repairs at this time. To return the vehicle to the customer and to advise that GM is aware of this concern and working on a resolution.
NHTSA · manufacturer bulletin10137187Model years 2016View details →
17459 - Service Update. Certain vehicles may have a wireless charging pad that is inoperative. The customer will be unable to charge their cell phone with a wireless charger. Dealers are to check for a missing fuse. Install a new fuse and check the wireless charger pad operation
NHTSA · manufacturer bulletin10137154Model years 2018View details →
27660 - Service Update. The engine may stall, followed by a Driver Information Center (DIC) message ?Action Required-Engine Not Available?. This will also cause diagnostic trouble codes P0AB9 (Hybrid/EV System Performance) and P0AC4 (Hybrid/EV Powertrain Control Module Requested MIL Illumination) to set. The engine will not start until the key is cycled. Dealers will reprogram the drive motor power inverter module.
NHTSA · manufacturer bulletin10135428Model years 2016View details →
This Preliminary Information communication provides information to the technician about vehicles that may have misfires or rough running on cold start up. Technician may find a Diagnostic Trouble Code P0300. Technician will need to use a scan tool and observe Crankshaft Position Re-sync Counter parameter. The Re-sync Counter parameter should remain at 0 during all operating conditions, and while manipulating the related harnesses and connectors between the crankshaft position sensor and the Engine Control Module. Technician will need to inspect for water intrusion in related connectors, terminals, and components. Tech will need to bring the vehicle up to engine coolant temperature that was stored when Diagnostic Trouble Code P0300 was set. After the engine coolant temperature is up to temperature technician will need to perform compression and cylinder leakage and record the readings. Technician should also verify correct fuel system pressure, inspect the heated oxygen sensors for contamination from fuel, silicon, or the incorrect use of room temperature vulcanization silicone sealant, and inspect the spark plugs for incorrect heat range, coolant or oil fouling, carbon tracking, cracks or insulator fractures at the tip. Technician should also Test for coolant contamination into the cylinders.
NHTSA · manufacturer bulletin10129886Model years 2012View details →
This preliminary bulletin provides a procedure to reprogram the power steering module to correct the customers concern of the MIL on and a drop in power steering assist.
NHTSA · manufacturer bulletin10126211Model years 2012View details →
This preliminary informational bulletin provides a procedure to reprogram the electronic power steering control module for comments regarding a indicator lamp illuminated and DTC C0544 and U0415 set.
NHTSA · manufacturer bulletin10126172Model years 2012View details →
This Preliminary Information communication provides information to the technician about vehicles that have the high voltage battery the tabs on X3 could become damaged during service. Technician will need to ensure to use caution when removing and installing this connector. Connectors need to be square to each other before the cam lock is engaged.
NHTSA · manufacturer bulletin10115088Model years 2016View details →
This Preliminary Information communication provides information to the technician about vehicles that have a no start or multiple messages on the Driver Information Center during cold weather. Technician will need to check the Vehicle Communication Interface Module label for Assembled in China. If the date is between 7/18/2014 and 8/3/2014, record the Station Identifier from the label and call General Motors Technical Assistance Center referencing this Preliminary Information for further assistance.
NHTSA · manufacturer bulletin10115133Model years 2015View details →
This informational bulletin provides information regarding the Passenger Presence System (PPS) May Command Seat Belt Reminder Chime and Passenger Airbag Indicator On When Electronic Devices or Conductive Objects are Placed on Front Passenger Seat
NHTSA · manufacturer bulletin10113824Model years 2013View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).