Motor vehicles – engine including fuel, lubrication and cooling systems
An electrical connection of the fuel heater in the fuel filter cover can overheat. As a result, the cover may become deformed.
🔔 Create a free account to get email alerts about Citroën C8 (all generations)
An electrical connection of the fuel heater in the fuel filter cover can overheat. As a result, the cover may become deformed.
The steering column to steering wheel shaft may not have been assembled correctly. If not corrected noise and play will become apparent and if these warnings are not acted on eventually steering control could be lost.
It is possible that the fuel return pipe may chaff on the diesel fuel filter support in the engine compartment. This can if not identified result in a fuel leak.
A potential fault within the engine management system could cause an internal engine fuel leak via one or more of the injectors following engine switch off. The engine would then not restart because of the excess fuel present in the inlet manifold or cylinders.
There is a possibility of a brake pipe contacting the clip of the turbo-charger air inlet union. In extreme cases this could lead to a loss of brake fluid causing the brake warning lamp to come on.
Due to draining of the condensation from the air conditioning system into the passenger compartment the air bag warning light may activate unintentionally. This in extreme cases may cause the air bag system to malfunction.
There is a possibility of defective components in the heater blower which could cause a short circuit and a loss of ventilation of the passenger compartment and in an extreme condition could set fire to the wiring harness.
Water ingress into the airbag electronic control unit (ECU) could result in illumination of the warning light and in the worst case unintentional deployment of the airbag.
The fuel filter's integrated heater may be defective and could cause the cover to distort. This could cause air ingress and fuel egress. Either could cause poor starting and a warning light should illuminate
null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air to enter the fuel system which could lead to stalling of the engine and loss of control of the car.
null The connection between the steering column and the steering wheel can become loose and lead to the failure of the steering.
Some tyres may have suffered superficial damage when the vehicle was being transported. The front Left hand tyre may have localised damage on the tread or the inner side. The tyre may rip and deflate.
It is possible that the wiring harness for the power assisted steering motor may come in contact with other components in the engine bay. Should this occur then it is possible that the power steering assistance on this large vehicle may become affected.
It has been identified that the position of the exterior lighting control ring may not be detected by the lighting management system and the lights may switch off without warning.
The threaded portion of the brake linkage rod in the brake control system may not be to conformity. This could result in a reduction of braking efficiency.
The lighting management system may incorrectly detect the position of the exterior lighting control switch. This may cause the exterior light to switch off without warning.
It has been identified that the diesel fuel return pipe which is fixed to the inlet manifold may be abraded to the extent that if left undetected will leak.
It has been identified that the check valve within the brake assistance vacuum pump may suffer from a non-conformity which in time may reduce the braking assistance.
It has been identified that a brake hose may become worn as a result of rubbing contact against the heat shield protecting the exhaust system. This may lead in extreme cases to a leak from a brake circuit which manifests itself in increased brake pedal travel.
The seat belt locking action may not be as fast as it is designed to be.
Braking assistance could be adversely affected by freezing of moisture that may accumulate in the vacuum circuit.
The fixings for the under engine protection tray could deteriorate which could lead in some cases to the tray falling whilst the vehicle is in motion.
When the vehicle is moving an electrical signal could neutralise the sliding door safety lock and allow the door to open unintentionally.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).