The DV5R engine can lose power due to slippage of the water pump pulley. This slippage can cause the timing belt to become misaligned, potentially leading to engine stalling. The water pump pulley gear can detach from the shaft, which may result in parts falling onto the road and increase the risk of accidents and injuries.
EU Safety Gate · RappelConso · FranceApr 3, 2026sr/00969/26Model years 2025–2026Auto-translated · original: FrenchView details →
On affected vehicles due to a production nonconformity the water pump may malfunction which may cause a loss of engine power and result in the engine shutting down.
DVSA · United KingdomMar 13, 2026R/2026/110Model years 2025–2026View details →
Some vehicles equipped with the DW10F Euro 6.4 engine may exhibit a fault in the diesel exhaust fluid (urea) consumption monitoring system. Because of this issue, the diagnostic test designed to detect problems such as low urea consumption or a blocked injector may not run often enough. This increases the risk that the emissions system is not properly monitored, which could cause the vehicle to fail to meet the required emissions standards.
EU Safety Gate · RappelConso · FranceNov 28, 2025sr/04142/25Model years 2022–2024Auto-translated · original: FrenchView details →
Vehicles may be affected by incorrect performance of the On-Board-Diagnostics related to Selective Catalytic Reduction system and/or Diesel Particle Filter. The Malfunction Indicator Light (MIL) may not illuminate in the event of a malfunction and therefore does not comply with emission regulations.
DVSA · United KingdomAug 18, 2025R/2025/346Model years 2020–2022View details →
The engine can stall spontaneously while driving due to a fault in the communication between the electric control unit and the air conditioning compressor.
rdwJul 5, 2023MGP230278Model years 2020–2023Auto-translated · original: DutchView details →
Als de auto langdurig in een koude omgeving heeft gestaan, kan de AdBlue zijn bevroren en kan het voorkomen dat het systeem de AdBlue niet voldoende snel kan verwarmen.
rdwFeb 8, 2023MGP230043Model years 2021Shown in the original Dutch · translation pendingView details →
The vehicle’s air-conditioning compressor pulley could break and damage other components in the engine compartment. This may increase the risk of an accident.
EU Safety GateMar 29, 2019A12/0574/19Model years 2015–2018View details →
De motorsoftware bevat een fout. Hierdoor is de aansturing van de motorkoeling en die van de waarschuwing voor de maximale koelvloeistoftemperatuur op het dashboard onjuist.
rdwJul 27, 2018MGP180361Model years 2017–2019Shown in the original Dutch · translation pendingView details →
The cooling system strategy and the maximum temperature alert could cause the engine to overheat this may cause an oil leak from the sump drain cap. Due to the incorrect operation of the warning system there is no driver alert.
DVSA · United KingdomJul 24, 2018R/2018/193Model years 2016–2018View details →
On the affected vehicles the tightening of a sealing plug on the engine oil gallery may not be correct to specification.This could lead over time to an oil leak which in rare cases could result in oil leaking on to the road.
DVSA · United KingdomJul 19, 2018R/2018/187Model years 2018View details →
An engine component may not be to specification which could result in loss of engine performance. This may lead to the engine stalling and potentially causing an engine failure. In very unlikely circumstances the vehicle speed may increase without warning but will stop on its own after a few seconds.
DVSA · United KingdomJan 3, 2018R/2018/002Model years 2017View details →
The fuel filter's integrated heater may be defective and could cause the cover to distort. This could cause air ingress and fuel egress. Either could cause poor starting and a warning light should illuminate
DVSA · United KingdomDec 8, 2015R/2015/243Model years 2012–2014View details →
null In the case of negative exterior temperatures, and after repeated activation of the fuel heater, an electric connection on the cover of the fuel heater can overheat. This can cause the cover to melt, allowing air to enter the fuel system which could lead to stalling of the engine and loss of control of the car.
EU Safety GateNov 20, 2015A12/1484/15Model years 2012–2014View details →
An inadequate weld on the bottom engine mounting tie bar may fail and cause a serious engine vibration and separation of one of the driveshafts.
DVSA · United KingdomJul 26, 2003R/2003/115Model years 2003View details →
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).