This file gathers the known defects of the Daihatsu Tanto IV, written and sourced by the community. Anyone can read; a free account lets you contribute. A defect earns the seal once enough reputable contributors have validated it.
Under Japan's Ministry of Land, Infrastructure, Transport and Tourism (MLIT) "Automobile Defect Information Hotline," owners have submitted 16 reports of problems with this vehicle's "engine" (first registered 2020–2025). Many of the reported mileages are around 17,000 km. Of the reports, 2 contain descriptions related to fire or smoke.
✓ Mecafile analysis of official data2020–2025Auto-translated · original: JapaneseView details →
Fourteen defect reports concerning this vehicle's "乗車装置" (occupant equipment) have been submitted by owners to the Ministry of Land, Infrastructure, Transport and Tourism's (MLIT) Japanese "Automobile Defect Information Hotline" (初度登録 2020–2023). Most of the reported mileage is around 7,000 km.
✓ Mecafile analysis of official data2020–2023Auto-translated · original: JapaneseView details →
Seven owner reports concerning the vehicle's "frame and body" have been submitted to Japan's Ministry of Land, Infrastructure, Transport and Tourism (MLIT) "Automobile Defect Information Hotline" (first registered 2020–2025). Mileage at the time of the reports is mostly around 22,000 km.
✓ Mecafile analysis of official data2020–2025Auto-translated · original: JapaneseView details →
In the front seats, the mounting bolts were not tightened properly, so some of these bolts may loosen due to vibration during driving. As a result, abnormal noise may occur from the mounting area, and if use continues as is, the bolts may fall out. In the worst case, the seat could move in a collision, and the occupant protection performance it is meant to provide may not be achieved.
The air deflector mounted under the floor ahead of the rear wheels did not undergo sufficient shape verification during development, so it does not conform to the exterior technical standards (UN Regulation No. 26).
In the front stabilizer, due to improper control of the manufacturing process, some units have a large amount of pre-painting chemical conversion solution remaining inside the pipe, and their strength has been reduced by hydrogen embrittlement. Therefore, if the vehicle continues to be used in this condition, the stabilizer may break due to torsional force while driving.
Sources: NHTSA (United States, public domain), Transport Canada (Open Government Licence – Canada), DVSA (United Kingdom, Open Government Licence v3.0), RappelConso and EU Safety Gate (France, Licence Ouverte 2.0), Japan's MLIT (Public Data License 1.0) and South Korea's MOLIT (car.go.kr).